Question about Cars & Trucks

Open Question

Dodge reset tran. wilnot shift

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2007 Dodge 2500 cummins with 108000 miles on it when it shifts from first too second it will redline before it shifts and then sometimes you have to let off the gas too get it too shift and it...


MOST DODGES (NOT THE MOTOR BUT THE TRANS HAS A SHIFT SOLINOID IN THE TRANS
THIS PART IS ABOVE THE VALVE BODY OF THE TRANS SO IT IS NOT EASY TO REMOVE
BUT YOU CAN DO IT WITH OUT DROP[ING THE TRANSMISSION YOU WILL IN MOST CASES HAVE TO REPLACE THE VALVE BODY GASKET
THE SOLINOID IS ABOVE THE VALVE BODY ...
YOU WILL BE ABLE TO SEE IT ONCE YOU REMOVE THE VALVE BODY REPLACE THE SOLINOID SHOULD HELP WITH YOU SHIFTING PROBLEM

Apr 19, 2010 | 1999 Dodge Ram 2500 4WD

1 Answer

Dodge ram 1500 2001 codes coming up 0753 1757 1762 1765 trans not shifting proper trans in drive wont shift to lower gears automaticly


0753 is shift solenoid A, electrical problem.as for the other codes they should start with a zero not a one. if they started with a 0757 that means shift solenoid B,stuck in on position. 0762 means shift solenoid C,stuck in on position. 0765 means shift solenoid D,malfunction

Jan 20, 2010 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

99 dodge caravan doesn't shift out of second gear


trans has gone into limp mode. Factory setting to get you home or to the dealer. First check fluid level. Try resetting the trans by removing the neg batt cable for a hour. If problem still there see repair shop

Sep 19, 2009 | 1999 Dodge Caravan

2 Answers

Shifting trouble


vauum actuator is sticking

Jun 27, 2009 | 1997 Dodge Avenger

1 Answer

Where is the shift solenoid located on a 2003 dodge neon sxt


the trans shift solenoid pack is bolted to the side of the trans closer to the radiator. it is rather large and there are three 10mm bolts holding it to the trans. it is under the input speed sensor and just under the spot where the cooler lines go into the trans.

Apr 11, 2009 | 2003 Dodge Neon

1 Answer

95 dodge intrepid wont shift out of first gear


It sounds like the trans has gone into "Limp In" mode. You may need to access the trans controller and look at fault codes. A Generic OBDII scanner may give you the codes. You could also try disconnecting the battery which will reset the trans controller. (however that is not a cure but it will verify the trans was in fault mode) The most common issues I've seen have been with the "Input" and "Output" Turbine Speed Sensors. They are both mounted on the trans case (External). The input is towards the front and the output is near the rear.

Mar 30, 2009 | 1999 Dodge Intrepid

1 Answer

1999 DODG 3500 AUTO TRANS SHIFTS TO 2ND WITH A LITTLE HELP


I have a 1999 Ram B 1500 Van, auto transmission, 5.9 L engine.
Same problem, trans hesitates in 2-3 upshift, sometimes 1-2
to 2-3 upshift. Posts trouble code P1756 - Transmission Govenor pressure too low at below 15 to 20 Psi. Transmission pump shot or valve body leak stops trans from reaching proper pressure to shift, which is minimum 15 Psi.
Either trans is leaking in valve body, valve is stuck, shift solenoid on valve body is sticking, or pump is shot.

Feb 14, 2009 | 1999 Dodge Ram

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

257 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...