Question about 2002 Isuzu Trooper

Open Question

Isuzu trooper seat armrest wont move up or down

Front driver side seat armrest wont lower

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1995 Isuzu Trooper--Power Windows wont roll down

Check the circuit breaker in the fuse panel on the driver side kick panel. It is a small brown push button directly above the replaceable fuses. My girlfriend has the same year trooper and this has happened to her in the past. I found the breaker and it took care of the issue.

Posted on Nov 07, 2008

Ad
  • 3 Answers

SOURCE: power windows isuzu rodeo 1999

Cable must of disconnected need to take door cover off and reconnect...

Posted on Jan 10, 2009

fknstart
  • 404 Answers

SOURCE: 2000 rodeo drivers side electric window goes up but not down?

pull the control switch out n clean contacts or try and spay contact cleaner on them

Posted on Jun 13, 2009

stevenhurc
  • 450 Answers

SOURCE: 91 isuzu trooper no acceleration

check fuel pressure possibly too low fuel pump not pumping enough

Posted on Jun 15, 2009

germcelchar
  • 389 Answers

SOURCE: how do i remove cv axle for a 98 isuzu trooper

Go to my profile I have just explained how to change a cv boot on a Trooper. The axle needs to be taken out to change the boot so the same solution. What you call an axle I have refered to as a drive (short for driveshaft) It takes a lot of explaining so save me a lot of writing if you read the solution I gave for changing the CV boot. Cheer's

Posted on Sep 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the power armrest control located?


It should be in the vicinity of the armrest....Is this a door armrest or center console armrest? In either case, the adjustment will be near to the armrest, like the seats have an adjustment at the hinge area.

Mar 31, 2016 | 2000 Isuzu Trooper

1 Answer

Just got a 2002 trooper swb 2 door but i cant find the control switch for mirrors


Power mirror switches are usually located on the driver's door armrest forward of the power window and door lock switches, but some Troopers have this control mounted on the center console behind the shifter lever.

Oct 08, 2013 | 2002 Isuzu Trooper

1 Answer

How do I remove folding back seats on 1997 bmw 328i


Remove the headrests (if equipped). Grip the lower seat at the front part of the seat and pull upwards to clear the clips(1), and the remove the lower seat.
Fold down the armrest and remove the bolts behind the armrest. The upper seat(backrest) is then pushed up, pulled forward and then moved either left or right out of the vehicle from behind the seat belts

Jun 29, 2012 | Cars & Trucks

1 Answer

Hood release not working on 1999 Isuzu Trooper, how do I open the hood now?


If you have a long flat screw driver you can go through the front grill and press the hood down and move the latch to the right and the hood will open.

Sep 19, 2011 | 1999 Isuzu Trooper

3 Answers

How do i take the back off on a 1999 nissan maxima bucket seat


Hi, follow the instruction below......
Rear
See Figures 3, 4, 5 and 6
  1. Remove the lower seat cushion by pulling straight up on the front portion and disengaging the clips. Then hinge the seat upward to release the rear clips.
03b6e0a.jpg

Fig. 3: Pull up on the front of the lower seat cushion and disengage the clips
  1. Remove upper rear seat back-to-chassis bolts.
77eb191.jpg

Fig. 4: Remove the bolts behind the center armrest ...

a796228.jpg

Fig. 5: ... and the bolts on the lower corners ...

fbf100a.jpg

Fig. 6: ... Then pull up on the seat to disengage the three clips on the top of the seat
  1. Remove rear seat back by tilting forward and pulling straight up.

To install:
  1. Install the lower seat cushion and torque the lower rear seat-to-chassis bolts to 15-20 ft. lbs. (21-26 Nm).
  2. Install the upper rear seat back cushion and torque the upper rear seat back-to-chassis bolts to 15-20 ft. lbs. (21-26 Nm)

Jan 19, 2011 | 1999 Nissan Maxima

1 Answer

How do I remove the back seat / backrest from a bmw 328IC 1997


Remove the headrests (if equipped). Grip the lower seat at the front part of the seat and pull upwards to clear the clips(1), and the remove the lower seat.
Fold down the armrest and remove the bolts behind the armrest. The upper seat(backrest) is then pushed up, pulled forward and then moved either left or right out of the vehicle from behind the seatbelts.


suzman_15.jpg

Nov 15, 2010 | 1997 BMW 328

1 Answer

Trying to remove driver side rocker arm cover but it wont budge in the rear closest to the fire wall, can lift from the front but unable to get it to release in the back


removetransmission support and upport by jack to move down, little by little until the space you want reach to access and you can remove cylinder head cover

Jun 27, 2010 | 1994 Isuzu Trooper

1 Answer

Turn signal & emerg. flashers stop working


2000 Isuzu Truck Trooper 4WD 3.5L SFI DOHC 6cyl The Flasher is located: Front seating area, behind the left hand side of the instrument panel, behind the fuse panel.

Hope helps (remember rated this).

Jun 12, 2010 | 2000 Isuzu Trooper

1 Answer

I pulled the 3 wires out of the plug on my 98 isuzu trooper and dont know how thay go back in order can you help me plz


For the 3.2l dohc v6 it is 1,2,3,4,5,6. with the cylinders being numbered from front to back and left to right 1,3,5,right and 2,4,6 left. The left and right side of the vehicle is determined from you setting in the drivers seat For the 2.6l 4cyl it is 1,3,4,2 starting with the right front wire and going in counter clockwise direction, and the cylinders are numbered from front to back 4,3,2,1. hope this helps out

Jul 05, 2009 | 1998 Isuzu Trooper

1 Answer

Where is the oil filter on a 1992 isuzu trooper


I have a 1991 isuzu trooper and if they're anything similar it's on the right side (driver side) of the engine down lower under the exaust manifold. sort of near the dipstick.

Apr 14, 2009 | 1991 Isuzu Trooper

Not finding what you are looking for?
2002 Isuzu Trooper Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...