Question about 2006 Kia Sorento 3.5
Posted by Anonymous on
Tips for a great answer:
- Excess vacuum
- Purge flow during non-commanded conditions
- Fuel Level and Fuel Pressure sensor faults
- EVAP Purge and Vent Valve faults
The ECM monitors the Fuel Tank Pressure sensor in order to determine the level of vacuum/pressure in the EVAP system. The ECM commands both the EVAP Purge Solenoid and the EVAP Vent Valve ON when the conditions are met in order to apply an engine vacuum to the EVAP system. The ECM commands the EVAP Purge Solenoid OFF once the system has reached a predetermined level of vacuum. This test verifies if a vacuum can be achieved in the EVAP system. Failure to develop a vacuum may be caused by a large leak or a restriction.
P0441 1998 Toyota Camry Evaporative Emission Control System Incorrect...
Possible causes - Missing Fuel cap
- Incorrect fuel filler cap used
- Fuel filler cap remains open or fails to close
- Foreign matter caught in fuel filler cap
- Incorrect fuel tank vacuum relief valve
P0441 Toyota Evaporative Emission Control System Incorrect Purge Flow
Jun 01, 2015 | 1998 Toyota Camry
May 08, 2015 | Dodge Cars & Trucks
Jul 09, 2014 | 2008 Kia Optima
Dec 12, 2013 | Cars & Trucks
Evaporative Emission Control System Incorrect Purge Flow
What does that mean?
This indicates that a part of the EVAP control system is no longer functioning correctly. The EVAP system consists of many parts, including (but not limited to) the gas cap, fuel lines, carbon canister, purge valve, and other hoses. The (EVAP) emission control system prevents the escape of fuel vapors from a vehicle's fuel system. Fuel vapors are routed by hoses to a charcoal canister for storage. Later, when the engine is running a purge control valve opens allowing intake vacuum to siphon the fuel vapors into the engine.
EVAP emission canister purge is controlled by a valve which allows engine vacuum to pull stored fuel vapors from fuel tank into the engine to be burned, rather than be vented to atmosphere. A vacuum switch is used to detect when flow exists. If the PCM commands purge and sees that the switch is closed (indicating no detected purge flow) P0441 is set.
Likely, no symptoms will be discernible to the driver, other than the illuminated Check Engine Light.
A code P0441 could mean one or more of the following has happened:
With a P0441 OBD-II trouble code, diagnosis can be tricky at times. Here are some things to try:
Jul 11, 2012 | Cars & Trucks
Mar 02, 2012 | Mitsubishi Cars & Trucks
Jul 28, 2011 | 1996 Pontiac Firebird
Jun 18, 2010 | Hyundai Motor 2002 Elantra
Jun 15, 2009 | 1996 Chevrolet Monte Carlo
May 03, 2009 | Hyundai Elantra Cars & Trucks
88 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: