Question about 1997 Mazda B-Series

Open Question

1996 nissan navara td27t not revving,blue smoke

Was low on diesel,replaced fuel filter but won't rev,blows blue smoke if i pump primer and try to rev

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: b2500 turbo diesel fuel pump diagram

courier%20injector%20pump%20inlet%20filter.jpg Undo the fuel inlet Banjo bolt and carefully fish with a piece of wire bent at the end (as pictured) and fish out the filter (under the spring) wash and replace. Can be very fiddly, so patience is a must.a2cb1b7.jpgecc55b3.jpg

Posted on Dec 01, 2009

Ad
  • 98 Answers

SOURCE: 2002 turbo diesel mazda bravo starts and runs fine

diesels are not known to be high revving engines to begin with, anyways, it sounds like your turbo is malfunctioning, get it inspected or repaired

Posted on Feb 25, 2010

Testimonial: "thanks for the advise much appreciated."

duane_wong
  • 6826 Answers

SOURCE: I am getting no diesel

Fuel Pump REMOVAL & INSTALLATION Navajo and B Series Pick-up Models NOTE: To gain access to the fuel pump, it is necessary to remove the fuel tank.

  1. Depressurize the fuel system and remove the fuel tank from the vehicle.
  2. Remove any dirt that has accumulated around the fuel pump attaching flange, to prevent it from entering the tank during service.
  3. Turn the fuel pump locking ring counterclockwise using a locking ring removal tool and remove the locking ring.
  4. Remove the fuel pump and bracket assembly.
  5. Remove the seal gasket and discard it. To install:
  6. Put a light coating of heavy grease on a new seal ring to hold it in place during assembly. Install it in fuel tank ring groove. Fig. 1: Fuel pump and sending unit used on the B Series Pick-up regular cab 89685g02.gif
    Fig. 2: Fuel pump and sending unit used on the B Series Cab Plus Pick-up 89685g03.gif
    Fig. 3: Fuel pump and sending unit used on the Navajo 89685g04.gif

  7. Insert the fuel pump assembly into the fuel tank, then secure it in place with the locking ring. Tighten the ring until secure.
  8. Install the tank in the vehicle.
  9. Install a minimum of 10 gallons of fuel and check for leaks.
  10. Install a pressure gauge on the throttle body valve and turn the ignition ON for 3 seconds. Turn the key OFF, then repeat the key cycle five to ten times until the pressure gauge shows at least 30 psi. Reinspect for leaks at the fittings.
  11. Remove the pressure gauge. Start the engine and check for fuel leaks.
MPV Models
  1. Relieve the fuel system pressure and disconnect the negative battery cable.
  2. Remove the rear seat and lift up the rear floormat. Remove the fuel pump cover.
  3. Disconnect the sending unit/fuel pump assembly electrical connector and the fuel lines.
  4. Remove any dirt that has accumulated around the sending unit/fuel pump assembly so it will not enter the fuel tank during removal and installation.
  5. Remove the attaching screws and remove the sending unit/fuel pump assembly.
  6. If necessary, disconnect the electrical connectors and the fuel hose and remove the pump from the sending unit assembly.
  7. Installation is the reverse of the removal procedure. Be sure to install a new seal rubber gasket. Fig. 4: Remove the rear seat and floormat to service the fuel pump 90975g06.gif
    Fig. 5: Removing the fuel pump assembly 90975g07.gif
prev.gif next.gif

Posted on Aug 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Navara 2.5 diesel only reaching 2,000 rpm


Blue smoke is oil. Compression check. and check plugs for fouling.

Apr 26, 2014 | 2005 Nissan King Cab

1 Answer

My 2004 kia k2700 tu diesel is just idling and as soon as you acelerate it stops. Just clean out fuel lines with injector cleaner and cleaned fuel tank and still does it as well as blowing blue grey s


Check the seal aroud the accelerator shaft on the pump. If the seal leaks reduced pressure in the pump will not allow the governor system to work properly The smoke color is the give away to a faulty pump

Jan 07, 2013 | Cars & Trucks

1 Answer

2002 gmc Sierra 6.6 turbo diesel won't start, has a black and blue wire just under the fuel filter thats been ripped off and can't find where it' should connect to.


wires broke under fuel filter is the water in fuel sensor.need to replace water in fuel sensor install new fuel filter pump the primer located on top fuel filter 30 times until stiff then try to start truck.the water fuel sensor got damaged became loose leak out fuel in fuel filter causing hard start problems, diesel engine wont start if air in fuel system or air filter stopped up.

Sep 18, 2012 | 2002 GMC Sierra 2500HD

1 Answer

95 Courier with Mazda diesel is hard to start, runs rough, blows lots of blue smoke and won't go over 60kph in top gear


I'd get your injectors rebuilt, and tune up your injector pump. Run a little seafoam in the diesel tank, and in the oil. Should make it clear right up.

Mar 29, 2012 | Cars & Trucks

1 Answer

1996 nissan navara diesel startred running rough and smokeing and can only rev to about 2 000 rpm


IF ENGINE SMOKING WHITE INCORRECT INJECTION TIMING TIMING RETARDED FUEL FULL OF AIR BUBBLES. IF YOU SEE BLACK SMOKE TIMING IS ADVANCED. IF YOU SEE LOT OF HEAVY BLUE SMOKE LOW COMPRESSION ENGINE BURNING OIL.

Jul 26, 2011 | Nissan Pickup Cars & Trucks

2 Answers

My 1996 nissan wingroad runs and pulls beatifully when cold but when warm hesitates as if flooding or starving when pulling from below 2200 revs especially when accelerating out of a corner.any...


common fault in this vehicle is air flow meter and temp sensor, if temp sensor fault normally will blow black smoke at the tail pie, air flow meter will have symptoms as you described.

Apr 19, 2011 | 1996 Nissan Sentra

1 Answer

Nissan navara stopped running


Check for an airlock in the fuel filter.

Nov 28, 2009 | Nissan Pathfinder Cars & Trucks

10 Answers

Why does my Nissan Terrano 2.7 turbo diesel have no power?


i have got 2.7 turbo thats lost power ive changed fuel filter but when you put your foot down it blowing heaps of smoke ??

Jul 09, 2009 | 1999 Nissan Pathfinder

1 Answer

Maintenance schedule corolla 110 1996


change fuel filter and stick an airline down the feed pipe to the filter to blow out the gauze filter in the tank ,remove the filler cap first though ,if none of this works remove the injector pump and take it to diesel specialist

Nov 08, 2008 | 1996 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...