Question about 2006 Kia Spectra

Open Question

2006 Kia Spectra: Cannot disable seatbelt chime.

I drive a 2006 Kia Spectra and I cannot figure out how to disable the seat belt chime. This is the noise that dings about 3 times every 15 seconds or so if the car is on and the driver seat belt is not fastened.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
turboKia
  • 55 Answers

SOURCE: How do you replace a Drivers side headlight bulb 2006 kia spectra

Helps to remove the battery, but small ahbds can do it.

Directly behind the lens is a big round cap ... twist it off. The bulb is held in place with a spring that locks in to a notch in the holder. When handling the new bulb, don't touch the glass. The oil from your skin will cause it to shatter when turned on.

Posted on Oct 23, 2009

Ad
  • 15 Answers

SOURCE: 2006 kia spectra intermitent popping noise

a bering in the disck is gone

Posted on Jan 27, 2009

  • 11 Answers

SOURCE: Disabling seat belt chime in a 2007 Silverado

Unfortunately if you take this to a shop they can get into alot of trouble doing this for you. Some are controlled by the body control module and others are just simple circuits. Look at you seat belt female end and look for a harness that goes to it. If it's just 2 wires connect those two wires together to trick the system! You should always wear your seatbelt by the way.

Posted on Sep 03, 2009

  • 5 Answers

SOURCE: disable tpms

I don't know if there is a problem with your TPMS receiver (on dash board), or your TPMS sensor is disable (in four tire). If it's the receiver problem, You have to go to the dealer ship to solve the problem. If it's the sensor problem. You can go to the dealer ship to let them find which sensor or sensors are fault, And replace them by the new one then doing the reset process.

Posted on Nov 24, 2009

roniecon
  • 6927 Answers

SOURCE: 2006 Kia Spectra 5 rear brake disc replacement

One side,turns right,and push in slightly,and the other side turns left,to retract.

Posted on Apr 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reset seatbelt chime?


I can only think of a couple of things that might cause that 1st look down inside the latch of the seatbelt just to see if something way have gotton down in there and is creating or stopping a connection . and the second thing is there should be a ground wire down by the floor wher you connect the seatbelt at . one last thing on the off chance the comp is getting a screwy signal just disconnect the neg battery cable for 5-10 minutes this will allow the comp to reset

Jan 06, 2015 | 2006 Kia Spectra

1 Answer

My 2006 chrysler 300 seatbelt chime wont shut off even tho all seatbelts are fastened


Look under the seat and see if the plug is unplugged to the switch. You may have a break in the wire as when you click your seat belt together it completes the ground and turns the chime off.

Jan 02, 2015 | Cars & Trucks

1 Answer

I have a 2004 ford explorer when im driving i hear a dinging noise on the passenger side behind dash bords


Could be the seat belt or the door chime.on a timer, probably the seat belt.

Oct 17, 2014 | 2004 Ford Explorer

2 Answers

In my 2006 ford fusion 2.3L whenever I put my key in the ignition and turn it a weird solid ringing sound start and stops 5 seconds later hat could it be?


Not surprisingly, many others have experienced problems with the ignition switch on this car. Historically, it is not a sound, but that the key is stuck in the ignition. http://repairpal.com/key-will-not-come-out-of-ignition-570 Your problem sounds different, but it may be related. Although I do not recommend the fix in the link above, it is possible the previous owner of your car did perform this fix and it has resulted in the problem you now have. My better guess is that the chime/buzzer has failed due to moisture or dirt and is no longer producing the sound that it should, but instead is altered to the ringing you describe.To disable follow these instructions:

1. Turn the ignition switch to the RUN (or ON) position. (DO NOT
START THE ENGINE)
2. Wait until the safety belt warning light turns off. (Approximately 1
minute)
Step 3 must be completed within 50 seconds after the safety belt
warning light turns off.
3. For the seating position being disabled, at a moderate speed, buckle
then unbuckle the safety belt 9 times, ending in the unbuckled state.
(Step 3 must be completed within 50 seconds after the safety belt
warning light turns off.)
After Step 3, the safety belt warning light will be turned on for three
seconds.
4. Within 10 seconds of the light turning on, at a moderate speed, buckle
then unbuckle the safety belt.
This will disable the BeltMinder feature for that seating position if it
is currently enabled. As confirmation, the safety belt warning light will
flash 4 times per second for 3 seconds.
This will enable the BeltMinder feature for that seating position if it
is currently disabled. As confirmation, the safety belt warning light will
flash 4 times per second for 3 seconds, followed by 3 seconds with the
light off, then followed by the safety belt warning light flashing 4 times
per second for 3 seconds again.
I hope this helps. Good luck.

Jun 12, 2014 | 2006 Ford Fusion

3 Answers

Faulty seat belt alarm


YOU CAN' DISABLE THE ALARM.IS PART OF SRS SYSTEM.BUY FROM YOU LOCAL DEALER BELT BUKAL ONLY AND REPLACE.IS EASY AND LOW COST.

Mar 28, 2014 | Hyundai Motor 2004 Sonata

2 Answers

Disable passenger seatbelt chime


Hi Candy, I'm glad to help!

Candy, I'm not sure why you want to disable the pass seat belt chime, maybe its going off even with no one in the seat. BUT, the only way to stop it would be to plug the seat belt into the buckle. Hope this helps and have an awesome day Candy

May 13, 2013 | 2006 GMC Envoy

1 Answer

Security bell keeps dinging even with seat belts on. 99 lincoln towncar


check the electrical connection under seat at seatbelt latch

Feb 19, 2013 | 1999 Lincoln Town Car

1 Answer

I had my alternator replaced in my 2001 Kia Spectra. The belts really made noise after and for the second time the alternator belt has broken off. What is wrong?


whan a new belt is put on it will always stretch a littl;e after a few days and will need to be tightened,if its making noise....it most likely loose,so after the belt is replaced..drive it for a day or two then have it retightened,hope this helps

Nov 11, 2010 | 2001 Kia Spectra

Not finding what you are looking for?
2006 Kia Spectra Logo

Related Topics:

429 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

yadayada
yadayada

Level 3 Expert

77499 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...