Question about 2003 Chevrolet Suburban 2500

1 Answer

Window control panel loose - 2003 Chevrolet Suburban 2500

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Chevrolet Master
  • 443 Answers

These are not a good design alot of people have this problem. the door panel has a small ear on it that breaks and it is hooked directly to the window control switch. you can either glue it back or order a new door panel.. Sorry but they should have made this holder a little different but they sure did a sloppy job on this little part. Jerry

Posted on May 22, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 2010 jeep liberty my dr side window stop working and window broke now none of the other windows will work is this a fuse problem

It may have pulled the wire loose from the master panel on the door (with controls for all windows). You should probably take the door panel off and inspect.

Apr 07, 2017 | Jeep Cars & Trucks

1 Answer

1994 s 10 blazer pwr windows not working ......all 4

Checking for blown fuse is a common problem fix, but your master control on drivers door may have a loose conection, or may be faulty. Remove all surrounding screws for door control pad and with gentle prying should loosen pad without removing door panel.Press together all connectors. Windows should operate. if pad dose not come free door panel must be removed.

Apr 13, 2013 | 1999 Chevrolet Blazer

1 Answer

Why all power windows stop working at same time honda accord 2002

The most likely reason is a blown or loose fuse. Hondas also use a special controller on the driver's window control panel, and these controllers are notorious for burning out. As always, after confirming that the fuse is good, the best way to start is to get out your volt meter or test light and make sure you have voltage at the window control panel. From there, you trace back to find a broken wire between the door and the fuse panel or trace forward through the switch.

Apr 05, 2012 | 2002 Honda Accord

1 Answer

Driver's side power window was inop. Window failed to go back up. Chevy dealer replaced the regulator motor and now working. Now the power dood lock switch on drivers side won't unlock doors.. Is the...

Hi, that wire is disconnected when the door panel is removed to work on the window motor. Take the car back and ask them to reconnect your door locks. If you want to fix it yourself, you may be able to access the connector by removing only the control panel where the door lock switch is installed. Remove any visible screws and then pry gently to pull up the panel. Odds are, however, that the whole door panel will need to be pulled loose to find the cable. You can possibly just pull the bottom of the panel loose, but do it carefully. Feed the wire back up to the control panel and reconnect to the switch. Thanks for using Fixya.

Jan 24, 2011 | 2003 Chevrolet Venture Passanger

1 Answer

All the locks and windows are not working from the drivers door control panel at my 1999 grand cherokee laredo...

check for a fuse or a loose wire under the control panel on the driver side wish you the best of luck Michigan Man.

Oct 24, 2010 | Jeep Cherokee Cars & Trucks

1 Answer

How to remove drivers door panel on 1999 ford escort. I need to repair the windows switch for the drivers side. My window is in the down position and won't come up when I push the button. All other windows...

Remove the front door pull cup screw 1152a96.gif

Remove the screw cap and the screw from the inside door handle and slide the handle rearward to disengage the hook from the inner sheet metal.
  • Disconnect the inside door handle from the front door latch remote control link

Remove the two-piece pushpins from the front door trim panel (23942).

NOTE: Use a commonly available spring loaded trim pad removing tool with a long thin nose to prevent damage to the door trim panel.
Release the seven front door trim panel bullet nose fasteners and push inboard, then upward to release the front door trim panel.
  • If equipped, disconnect the master window regulator control switch electrical connector

Remove the retainer from the master window regulator control switch panel.
  1. Pull outward on the cup retainer tabs and remove.
  1. Remove the master window regulator control switch electrical connector from the retainer

Jun 05, 2010 | 1999 Ford Escort

1 Answer

Rear windows are not workinghow do you take off panel to access window

Remove all the screws and also window and lock controls, Then take a big flat-head screwdriver and gently pry off the panel. Once it is all loose, lift up and off. Then to put back on when you are done, just lightly tap back in place.

Nov 18, 2009 | 2003 Volkswagen New Beetle Convertible

3 Answers

Passenger & rear power windows not working

First to keep with the basics, make sure you haven't inadvertantly hit the safety lockout button on your drivers side control panel. Then pop out or unscrew the switch from it's holder and check with a test light if the power is being ditributed to the other windows, if not you'll need a new door control modual and you'll have to take it to the dealer so they can code it and activate it according to your keyless entry system.This is probably covered under waranty and or recall. Thank you, Dana

Sep 10, 2009 | 2006 Lexus Rx 330

1 Answer

2004 Mitsubishi Galant window probem

your going to have to remove the door panel. remove the screws and you will iencounter plastic pieces call christmas trees these are a pain but the sell a tool for these at an auto parts store for about 10 bucks. disconnect the plug if you have power windows, if you have manual windows there is a clip that holds the handle on the shaft. use a small screwdriver to remove this. now you can remove the panel awy from the door. this will allow access to the window regulater. you said it sounded like something is loose. check to see if the control arm is disconnected from the lower part of the window. hope this helps

Sep 01, 2008 | 2003 Mitsubishi Galant

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

79077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides