Question about Cars & Trucks

Open Question

Overheating chevy venture

Over heats and no heat in van

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Thermostat in a 2003 chevy venture van

the bottom boult is hard but can be done need to use a 10 or 12 stubby wrench and take a pry bar and lighty pry heat shild away to get bottom bolt dont need to take it out all the way just loosen and slide down

Posted on Aug 17, 2008

  • 37 Answers

SOURCE: rear brakes scrubbing on 1998 chevy venture van

Removal Procedure Tools RequiredJ 38400
Caution: Keep fingers away from rear brake shoe springs to prevent fingers from being pinched between spring and shoe web or spring and backing plate.

  1. Remove the brake drum. Refer to Brake Drum Replacement

  2. 142285.gif
    tif.gif
    Notice: Do not over stretch the adjuster spring. Damage can occur if the spring is over stretched.
  3. Use the J 38400 in order remove the adjuster spring (1). Disengage the adjuster spring loop from the tab on the adjuster actuator.
  4. 2.1. Remove the loop end of the adjuster spring from the adjuster actuator. 2.2. Remove the straight end of the adjuster spring from the secondary brake shoe.
    142293.gif
    tif.gif
  5. Use the J 38400 in order to spread the brake shoes apart.
  6. Remove the adjuster.
Installation Procedure

    142293.gif
    tif.gif
  1. Use the J 38400 in order to spread the brake shoes apart.

  2. 178990.gif
    tif.gif
    Important: Ensure that the adjuster (2) engages the brake shoes (4 and 5), the park brake actuator (3), and the adjuster actuator (1) properly.
  3. Install the adjuster.

  4. 142285.gif
    tif.gif
    Notice: Do not over stretch the adjuster spring. Damage can occur if the spring is over stretched.
  5. Install the adjuster spring (1).
  6. 3.1. Install the straight end of the adjuster spring into the secondary brake shoe. 3.2. Install the loop end of the adjuster spring to the adjuster actuator.
  7. Install the brake drum.

Posted on Dec 08, 2008

  • 1 Answer

SOURCE: Thermostat in a 2003 chevy venture van

no you dont need a special tool you have to take the throttle body off it makes it sooooooo much more simple.

Posted on Jan 27, 2009

  • 356 Answers

SOURCE: 2001 pontiac montana overheating no warm air when heat is on

Might be a weak or failing water pump... Does it leak antifreeze or do you have to add antifreeze very often? When the engine gets to operating temperature squeeze the top radiator hose and see if you can feel pressure from the water pump forcing water through it.

Posted on Feb 21, 2009

billie17
  • 84 Answers

SOURCE: need to add 13-4a freon to my 2000 venture chevy van. Where is the pressure hose located?

passengers side under the hood.....by the firewall.....

Posted on May 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 Chevy venture gauge says its overheating and heat gets cold but then the gauge drops back down real quickly and heat works again. doesn't steam


You are low on coolant. There is air in the coolant system. This is the reason it jumps high with no heat.

Oct 31, 2014 | Cars & Trucks

1 Answer

I cant get much heat in my 2000 chevy venture


check if your thermostate is working... is it having troubles getting to operating tempurature?
check your heater lines that run to the heater core and see if there is heat getting to and from the heater core if the thermostat is running properly...
if you have heat running to and from the heater core then check and make sure your heater controls in the van are switching between defrost and heat and floor properly
could be a heater box problem ....
when i had the same problem with my venture it turned out to be a plugged heater core and i replaced it

Dec 07, 2010 | 2001 Chevrolet Venture

1 Answer

The heater doesn't work very well on my 2000 Chevy Venture van. I'm wondering if I should try replacing the thermostat. Or, it is all computer controlled now.


If heat gauge reads normal, stays in the middle, then you do not need to mes up with the thermostat. I own a 2000 Chevy Venture and changing the thermostat was not fan.
It may be the Temperature Control Module, which you can buy for $45 and replace without problem, or may be an partially obstructed heating core. The GM Dex-Cool antifreeze, the read one, has additives, but if you do not flush the radiator every 2 or 3 years, can result in partially clogged heater core. I have done on my car twice till now, and replaced with green Prestone, on my own risk. Hope this will help. If need more information let me know. A have the Haynes manual for Chevy Venture 2000, and I am a car dealer.

Oct 28, 2010 | 2000 Chevrolet Venture

2 Answers

My 2000 chevy venture is overheating and the heater is not working


could be that you are low on coolant, this would cause you to not get any heat and also would over heat.

Jan 27, 2010 | 2000 Chevrolet Venture

1 Answer

I have a Chevy Venture 2001 that has serious problems with the engine overheating. I already replaced the thermostat & antifreeze. When I drive it just a block, the needle on the heat dial jumps from...


You should probably replace the temperature sensor first, make sure the car is indeed overheating.

If after replacing the temp sensor, and the problem does exist, then buy a flush kit, and back flush the system, it may be clogged.

Nov 16, 2009 | 2001 Chevrolet Venture

1 Answer

Overheating


If you are adding anti-freeze every time this happens, you are still loosing coolant some were. I assume there are no puddles on the garage floor or where you park the van? Check the oil dipstick and make sure the oil is not a "milky"color. Check the passenger side carpet for wetness, you may have to pull it back.
If all of that is OK, you are still burning the coolant by way of the intake gasket or head gasket.
Good luck, let me know.
Regards,

Mar 23, 2009 | 2001 Chevrolet Venture

1 Answer

No Heat


check your coolant level...if its too low then it will not flow through the heater core correctly to generate the heat.

Jan 15, 2009 | 2001 Chevrolet Venture

2 Answers

Thermostat in a 2003 chevy venture van


the bottom boult is hard but can be done need to use a 10 or 12 stubby wrench and take a pry bar and lighty pry heat shild away to get bottom bolt dont need to take it out all the way just loosen and slide down

Aug 08, 2008 | 2003 Chevrolet Venture Passanger

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...