Question about 1986 Ford F150 SuperCab

Open Question

Need to buy a 1986 ford f150 fuel filter housing

Need a fuel filter housing

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 142 Answers

SOURCE: remove fuel lines from the fuel filter on a 93 f150 ford truck

There is a special tool used to disconnect the lines from the fuel filter. You should be able to get them at any local automotive shop, i.e., Pepboys, Autozone, Chief Auto. It should be relatively cheap to buy this tool.

Posted on Sep 27, 2008

  • 1 Answer

SOURCE: fuse box

i need one too

Posted on Dec 06, 2008

LEFTY64
  • 69 Answers

SOURCE: NEED INSTRUCTIONS ON REPLACING ALTERNATOR ON F150

REMOVAL & INSTALLATION

See Figures 1 and 2


0900c1528004b8db.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 1: Rear terminal alternator


0900c1528004b8dc.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 2: Side terminal alternator

  1. Open the hood and disconnect the battery ground cable.
  2. Remove the adjusting arm bolt.
  3. Remove the alternator through-bolt. Remove the drive belt from the alternator pulley and lower the alternator.

Some engines are equipped with a ribbed, K-section belt and automatic tensioner. A special tool must be made to remove the tension from the tensioner arm. Loosen the idler pulley pivot and adjuster bolts before using the tool. See the accompanying illustration for tool details.
  1. Label all of the leads to the alternator so that you can install them correctly and disconnect the leads from the alternator.
  2. Remove the alternator from the vehicle.
  3. To install, reverse the above procedure. Torque the pivot bolt to 58 ft. lbs.; the adjusting bolt to 25 ft. lbs.; the wire terminal nuts to 60-90 inch lbs.

BELT TENSION ADJUSTMENT

The fan belt drives the alternator and water pump. If the belt is too loose, it will slip and the alternator will not be able to produce it rated current. Also, the water pump will not operate efficiently and the engine could overheat.
Check the tension of the belt by pushing your thumb down on the longest span of the belt, midway between the pulleys. Belt deflection should be approximately 1 / 2 inch; (13mm).To adjust the belt tension, proceed as follows:
  1. Loosen the alternator mounting bolt and the adjusting arm bolts.
  2. Apply pressure on the alternator front housing only, moving the alternator away from the engine to tighten the belt. Do not apply pressure to the rear of the cast aluminum housing of an alternator; damage to the housing could result.
  3. Tighten the alternator mounting bolt and the adjusting arm bolts when the correct tension is reached.

Posted on Apr 07, 2009

  • 921 Answers

SOURCE: where to find fuel filter 1986 ford thunderbird

Get under your gas tank and follow the lines. one of them should lead not far away from the tank where most filters are located. When you change it remember to release pressure by take loose the gas cap...and have some rags ready to catch some overflow.

Posted on Sep 27, 2009

  • 105 Answers

SOURCE: 2006 ford f350, leaking fuel at the fuel filter

must identified what part of it is leaking has it been changed and wrong or wrongly installed gasket promble

Posted on Mar 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is My 1986 ford f150 starts great in the morning but after hot it's like it's not getting fuel


What have you checked so far ?
Fuel pressure ? Fuel pump relay ? Good spark to plugs ?

Sep 05, 2014 | 1986 Ford F150 SuperCab

1 Answer

My 1986 ford f150 has a startinf problem new starter new carborator


i need to know more of the problem but check the fuel filter,plugs, cap and rotor

Dec 16, 2010 | 1986 Ford F150 SuperCab

1 Answer

1986 ford xlt lariatf150 302 in it will run good for a little while but its staring to sputter an spit like its not getting gas. But ihavent changed the fuel filter yet. But you can let it sit for a sec....


There is only one fuel filter and the possibility of bad gas is good.If the truck set as long as you said then you need to drain the fuel tank and put in fresh gas,unleaded gas does not do well over three months old and if it is an ethanol blend it will actually start to grow a fungus.Change the fuel and the fuel filter and if this does not work let me know,we will start over from there.

Jun 23, 2010 | 1986 Ford F150 SuperCab

2 Answers

Truck is fuel injected but you have to spin it


mcdevito75 here, It"s possible but not to the extent the old carbureted engines would flood, Best bet is ti look for a sale some shops run on checking the fuel system, Sears, Pepboys etc.

Jun 17, 2010 | 1986 Ford F150 SuperCab

1 Answer

89 ford f150 in-line 6 cylinder. i have replaced a few injectors both fuel pumps and filter. idles like a dream. when i hit the gas it studders but doesn't die. need more info ask. any ideas?


This is for a 1989 Ford F150 In-Line 6-Cylinder (4.9L) wrongly posted by the Asker under a 1986 Ford Mustang....

Fuel Injector Pressure Regulator. Look it up on line at any of the reputable auto parts websites to get an idea what it looks like.
There should be a Rubber Vacuum Line coming from this (the Regulator is located on the Fuel Line prior to the Fuel Injectors) to the Intake. Take this Line OFF. If there is gas in that line = The Fuel Injector Pressure Regulator diaphram is broken and the Fuel is being dumped into the Intake and NOT being advanced onto the Fuel Injectors; and the Regulator must be replaced.
Let me know if this helped.

Apr 01, 2010 | 1986 Ford Mustang

1 Answer

Dule gas tank ford truck 1986 4X4 location of fule filters I found one


The main filter is ahead of the high pressure fuel pump on the frame rail, and has 2 small plastic clip holding the fuel lines on. The other is behind the high pressure pump, in the resviour, and looks like a cup. If yours has two filters,(some don't) that where it is. The cup screws off. If you find o-rings in the bottom of the cup, you have to replace the whole unit (if you choose to remove it) Good Luck to you!

Sep 23, 2009 | 1986 Ford F150 SuperCab

2 Answers

Hi got a ford f150 1986 f/i will not start


check fuel pressure @ service port on fuel rail. also listen for fuel pump to come on when you first turn on key. pump is in fuel tank. also note i have seen a lot of f150 302 injectors clogg up.but that usually effect idle and performance. if there is good fuel pressure then check fuel injector signal with a tester called a noid light. it is inexpensive and can be found @ most auto part stores. you really should'nt check injector signals with a standard 12 volt testlight. it has been known to burnout the drivers on the ecu. test all that first.

Aug 04, 2009 | 1986 Ford F150 SuperCab

1 Answer

Ford f150 1984 fuel transfer problem


check to see if you have more then one fuel filter for your truck it maybe a bad fuel filter try these websites www.autozone.com and www.alldatadiy.com to see if you can get more information and diagrams and pictures at the same time.

Jul 30, 2009 | 1986 Ford F 250

1 Answer

Fuel sencer


The fuel sender is located in the gas tank.

Jun 04, 2009 | 1986 Ford F150 SuperCab

1 Answer

Remove fuel lines from the fuel filter on a 93 f150 ford truck


There is a special tool used to disconnect the lines from the fuel filter. You should be able to get them at any local automotive shop, i.e., Pepboys, Autozone, Chief Auto. It should be relatively cheap to buy this tool.

Sep 27, 2008 | 1993 Ford Club Extended

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...