Question about 2010 Chevrolet Silverado 1500

Open Question

2010 siverado says sevice traction control and check engine light came on

Truck reduced engine power and slowed me down. I stopped then turned off the truck and traction light went off but check engine light stayed on

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 4 Answers

SOURCE: hold light blinking, check engine light on, engine slows down

check tps sensor (throttle position sensor in backside of the throttle cable) and map sensor (manifold absolute pressure on front little 1 inch sensor with vacuum line) make sure there plugged in. the ecm (engine control module driver side inner fender) and tcm (transmission control module under dash) both need the data to know when to upshift and increase fuel/air. Otherwise the computer runs default values and guesses off of other sensors giving poor performance. also disconnect battery for 15 min. usually resets aveo service lights if you dont have a scanner.

Posted on Aug 02, 2009

Ad
  • 714 Answers

SOURCE: The "engine power is reduced" light comes on

po455 is Probable Cause[s]

1. Defective, loose or missing fuel cap
2. EVAP canister broke, hose cracked or not connected
3. Purge or vent solenoid defective
4 . Vacuum leak at engine po121 code po121 means Throttle Position Sensor/Switch A Circuit Range/Performance Problem . it is usually indicative of a faulty throttle position sensor or faulty wiring harness in the engine bay.

Posted on Feb 27, 2010

  • 2 Answers

SOURCE: my service traction control light keeps on going

I have a 2006 checy impala and the TCS ( TRACTION CONTROL SERVICE) liught came on..What does this mean?

Posted on Mar 08, 2010

SOURCE: reduced engine power on

The traction control uses the speed sensor in the transmission and the wheel speed sensors to determine wheel spin. If a wheel spins braking is applied to it so that the power can be transferred to the other wheels. At some point the ECU detected a gross disagreement between the sensors and so as a precaution has entered into a limp home mode. On some systems if the fault is in error it can be cleared by putting the car into drive and moving forward a meter, putting in reverse and going a back a meter and doing this three times. If one or other of the sensors are faulty this process will not allow the error to be cleared. You need to check or have checked the error codes and the speed sensors.

Posted on May 28, 2010

  • 2 Answers

SOURCE: 2009 chevy silverado traction control


DTC P1516 Throttle Actuator Control (TAC) Module Throttle Actuator Position Performance

Your vehicle has an electronic throttle body unit so it uses voltage signals to control throttle blade in the throttle body. There are a few different issues that can cause this problem.

First off there is a update for the PCM to address those codes, but you will have to take it to the dealer for that.

Second there is issues with the actuator on the throttle body binding up and causing the codes.

Third there is a yellow wire coming off the throttle body connector that breaks inside internally and cannot be seen to the naked eye. The best way to test that is to grab the wire about 5 inches from the connector and tug if it feels spongy or breaks, that

Posted on Jan 01, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Traction control and reduced engine power


What make , model year and engine size ? Reduced engine power usually means thier is a fault with the electronic throttle control an when thier is a problem it will disable traction control . This will turn on warning lights on the instrument cluster .

Apr 29, 2017 | Cars & Trucks

2 Answers

On my 2010 Silverado the message center says engine power reduced, service stabilitrack and service traction control system. What would cause these messages. It started after sitting for a few days


The fault codes have nothing to do with it sitting for a few days. There are sensors that work with your ABS brakes and TCS to help your car maintain control when corning briskly under load. You probably have a bad sensor on one of the wheels. Recommend you get the Haynes manual to see exactly how to test and replace them. A multimeter will help too.

Apr 04, 2015 | 2010 Chevrolet Silverado

1 Answer

2010 chevy 1/2 pick-up 4x4 Check engine light comes on, engine power reduced, and service stabilitrak, traction control off.


Since all three systems work together, when the engine light is on the other two can be also.
I would start with checking the engine computer for trouble codes.

Feb 06, 2014 | 2008 Chevrolet Suburban

1 Answer

What does "Reduced Power, Traction Fault" mean?


GM's power strategy will reduce power if it doesn't see proper charging. It does this to conserve battery power by shutting off non-essential electrical accessories. It can also mean that the traction control system is reducing engine power to avoid a skid. The traction control system gets input data from the wheel speed sensors to figure out if you're entering a skid or the wheels are locking up. One way to get you out of the skid is to reduce engine power or pump your ABS brakes. In your case you should get the trouble codes read. An ABS or traction code code could be a C, U or B code which can't be seen by a cheap scan tool or the tools they use at auto parts stores. GM had major problems with the ABS wheel speed sensors built into the wheel bearing hubs in these vehicles. The fix involved replacing the hub. So get the codes read by a pro scanner to find out which wheel sensor is setting the code. Then do the fix. Also, the P0128 is usually caused by a bad thermostat. Fix that first, because if the engine doesn't get up to operating temperature, the computer can limit some features.
Read these posts for more trouble code information
http://ricksfreeautorepairadvice.com/p0128/
http://ricksfreeautorepairadvice.com/abstcs-light/

Jun 26, 2017 | 2005 GMC Canyon Crew

1 Answer

Engine power reduced


check the engine OBD2 codes. you may have bad crank shaft or cam shaft sensors. replace them all ....

Oct 12, 2017 | 2010 Chevrolet Cobalt

1 Answer

Traction conrol


The traction control light is on to let you know that system is disabled. I would say the actual problem is a performance issue with the engine.
You should have someone scan the computer for trouble codes to proceed with testing. A 2010 model may still be under factory warranty.

Dec 13, 2012 | 2010 Chevrolet Cobalt

1 Answer

2006 chevy impala traction control


Reduced power is a problem with electronic throttle contol . drive by wire . Do you know what this is ? Taking the vehicle an having it hooked up to diagnostic tool an checking for DTC'S - diagnostic trouble codes is always a first step when trying to find the root cause of any trouble light ! And not auto zone , pep boys , or advance auto parts . Thier diagnostic tool will not check codes in all system control modules .

Apr 15, 2017 | 2006 Chevrolet Impala

1 Answer

I have a 2010 Chevy impala. Service Traction control, Engine Power reduced and Service Stabiltrak message comes on. Also check engine light comes on and a triangle with a car in the middle and slippery...


had the same trouble with my '10 impala it turned out to be defective electronic accelerator pedal it is actually a recall for this vehicle and should be a free repair at your dealer.

Sep 27, 2012 | 2010 Chevrolet Impala

1 Answer

ETS LIGHT CAME ON AND CHECK ENGINE LIGHT 1997 chevy cavalier 2.4


ETS is Enhanced Traction System is used to stop wheel slip thru reducing engine output. And if the light is on it doesn't mean you will spend x amount of dollars to fix it! It just means that ETS has been disabled because you have a engine problem and the computer cannot reduce power to the wheels because the engine might stall so the computer disables the system! Now some cars come with a switch by the shifter that turns on and off the system because if you get stuck in the snow traction control will keep you from getting stuck

Feb 14, 2010 | 1997 Chevrolet Cavalier

2 Answers

Service Throttle Control


It sounds like these things are all related. When the a computer sees a problem in the Electronic throttle system, it will dissable traction control, and give the reduced engine power alert because the powertrain computer does not know the value of throttle postion.
Codes will need to be scanned in the computersto begin diagnosis.
TechJK

Jan 30, 2009 | 2007 Chevrolet Impala LS Sedan New Cars

Not finding what you are looking for?
2010 Chevrolet Silverado 1500 Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...