Question about 2000 Buick LeSabre

2 Answers

Vaccum line problem

I have a 2000 buick lasabre it is starting very hard. i have replaced plugs, wires pcv valve, fuel filter and now i think it is a vaccum problem cause when i remove the oil fill cap there is a large amount of suction pulling on the cap and with the cap off it runs muck better

Posted by on

  • 6 more comments 
  • nelsonhomere May 21, 2009

    the question is , why is there so much suction when i remove the oil fill cap and when i do it runs better but when i put the cap back on it stars to run rough then usully dies

  • nelsonhomere May 21, 2009

    could you tell me how to check that

  • nelsonhomere May 21, 2009

    ok just checked it and it moves just fine

  • Richard Scordino May 11, 2010

    OK Is there a fat hose(looks like a heater hose) coming off one of the valve covers that goes to a black plastic box? If so, make sure that box is not all gummed up inside.

  • Richard Scordino May 11, 2010

    Remove it and shake it...the valve should move freely and rattle...you can spray some carb cleaner through it to clean it up or get a new one (only about five bucks)

  • Richard Scordino May 11, 2010

    If your pcv is stuck wide open you will have a ton of vacuum in the engine cover. Likely it only stays running because the seals in the engine are in really good shape.

  • Richard Scordino May 11, 2010

    Check to make sure that the pcv valve is not stuck wide open.

  • yadayada
    yadayada May 11, 2010

    do u have an data trouble codes?

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Ya it probably is the maf sensor because I had same problen with my buick and then I replaced the maf sensor then it work great

Posted on Dec 30, 2012

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Mentor:

    An expert who has written 3 tips or uploaded 2 video tips.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 118 Answers

Have you had a diagnostic scan ran? It sounds like you may be having a problem with the MAF sensor. The MAF regulates the amount of air taken into the car. The sensor responds to the engine temperature.

Posted on Oct 05, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause my 2000 buick lasabre to shut-off when attempting to make a quick turn. It starts right back up. Acts like it's out of gas or very low but not


possible this pump is also failing --bad/clogging fuel filter --check the connections and relay --egr valve carbon build up

Aug 29, 2015 | 2000 Buick LeSabre

2 Answers

I need a tune up for my 2000 buick lesabre. What should I be expecting them to fix / change and how much would I typically face cost wise


they should replace the plugs, fuel filter, check and replace the air filter if its dirty, as far as cost every shop has a different hourly rate and their mark up on parts is different as well. you could be looking at around 200. this is just a guess.

Jun 26, 2015 | 2000 Buick LeSabre

1 Answer

Car starts then dies seconds later. only in cold weather. have replaced pcv valve vaccume lines fuel lines fuel filter. tested fuel pump. tested map sensor changed spark plugs and wires rotor bug and


Did you cycle key 3 times? on (not start, just on) off, on, off, on, and leave on and watch for check engine to flash. It will flash 2 digit #'s. example: flash,flash,pause,flash. = 21, then pause and if more codes will flash again. When you get 5 flashes, pause, then 5 more, that's end of message (codes)

Mar 26, 2014 | Plymouth Reliant Cars & Trucks

1 Answer

2.2 litre 1995 gmc sonoma idles rough no trouble code. found hole i brake booster vaccum line fixed that. replaced and changed fuel filter, idle air control valve, got spark at coil packs, put new spark...


Three things you should check using a good code checker which can read sensor outputs - the throttle position sensor (TPS), the mass air flow sensor (MAF) and the EGR valve. While you are at it, replace the PCV valve.

Jul 30, 2017 | 1993 GMC Sonoma Club

1 Answer

2000 CHEVROLET BLAZER 4.3 START BUT DIES.REPLACED COIL WIRE,PLUGS,ROOT BUTTON,CAP FUEL REGUTATOR,FUEL FILTER,FUEL INJECTOR,PCV VALVE FUEL PUMP IS 60PSI


Anti theft system failing maybe? Read this link and compare symptoms http://vatspasslockpasskeysecurityhelp.yolasite.com/

Jul 21, 2011 | 2000 Chevrolet Blazer

1 Answer

Hello i have a 1995 buick park avenue that has a rough idle and stalls in the mornings after sitting over night the first two or three times it will stall but after that it idles rough til it gets warm,ok...


Try plug wires, that's about all you haven't replaced. Actually if you have an ohm meter you can test them - anything over 6k ohms per foot - REPLACE them. Also run a good fuel system cleaner through it and stay away from cheap gas.

Mar 25, 2011 | Buick Park Avenue Cars & Trucks

1 Answer

WHAT PARTS DO YOU NEED TO PERFORM A CAR TUNE UP ON


All you need are the spark plugs and an air filter is needed

Mar 22, 2011 | 2000 Buick LeSabre

1 Answer

Replacing my fuel filter on a 2000 Buick LaSabre Custom..any special tools needed and where is it located


There is no special tools needed, you will probably find the fuel fuel filter beneath the undercarriage of the vehicle, check both sides just below the seating area and if not found there you will have to trace the fuel line from the fuel tank forward intil you locate the fuel filter.

Aug 28, 2010 | Buick LeSabre Cars & Trucks

1 Answer

Cant find pcv valve on 2000 buick lasabre


The PCV valve is hidden on top of the intake manifold down in a little enclosure. There are two small bolts holding the PCV cover. Often there is a fairly large vacuum line coming into the enclosure. Remove the cover and pull the PCV valve that sits down into a gasket.




201f7e7.jpg

Feb 18, 2010 | 2002 Ford F150 Regular Cab

Not finding what you are looking for?
2000 Buick LeSabre Logo

252 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...