Question about 1997 Honda Civic

1 Answer

No spark turns over, no power from distributor

Posted by Anonymous on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

No spark on mi 2003 audi 1.8t

Posted on Apr 27, 2014


1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1965 elcamino, not getting spark at plugs swapped plugs wires coil, distributor, won't start! Ideas?


Check power and ground at the coil. If there isn't any power there you will need to trace them both back to find the problem. If you have power at the coil, does the coil provide power to the distributor? If yes the either cap, points or distributor is bad. Check gap on points. Make sure point contacts are clean. Does the internals of the distributor turn when engine is turned over? All this has to work correctly for you to get spark.

Nov 12, 2016 | Cars & Trucks

1 Answer

I have a 97 dodge average 2.5 v-6 the car attempts to turn over but won't fire, start. I was told by midas it was a spark issue and needed a new distributor. I replaced that still no change


check for spark to make sure the distributor is working. If there is not spark than make sure the distributor is turning. Remove the cap and see if the rotor turns will a helper cranks the engine over. If it is turning than use a test light connected to ground and see if spark comes out of the ignition coil while the engine is being cranked. if there is no spark make sure there is power to the coil. if there is power you may have a defective distributor. if there is no power check fuses.

if the rotor is not turning check to make sure the timing belt is not broken.

Sep 05, 2015 | Dodge Cars & Trucks

2 Answers

Engine cranks but no start, no spark. What else can I check?


is it actually rotating when the engine turns over I know sounds stupid but I\'ve seen the teeth that goes inside against the cam break off on first turn over happened to me once on a Honda, also that same car my original problem was I was getting power and everything like you but the icm on the distributor was putting the power out on the ground side and the power turned to ground not allowing the distributor to do its job and produce spark





hope this helps

Aug 29, 2014 | 1994 Toyota Corolla

1 Answer

I have a 1988 Acura Legend with a 2.7L. My starter turns over but my car does not turn on. There is power going into the coil. I know that for sure. I don't know if there is coming out of it. I know there...


Remove the cable which connects your coil and the distributor from the distributor side. Have someone to crank your engine while holding the cable (use insulated pliers to hold the cable by insulated part). Maintain 1/2 inch distance from the engine surface where is some bare metal without paint. If there is the spark, then replace your distributor's cap and rotor. If there is no spark, replace coil and check your cap and rotor anyway, if they look worn and black inside, then replace them anyway. Note: before removing spark plug wires from distributor cap, mark wires and distributor!

Oct 04, 2013 | 1988 Acura Legend

1 Answer

2000 Chevy Astro; power to distributor from the coil, but no power out the distributor. New rotar cap, magnetic switch and distributor and ignition control module, but still won't turn over. Help!


check if fire at the end of spark plug wire with HEI spark plug tester.It need 25000 volts to jump the tester. If ok check for fuel injectors by pouring a little fuel inside intake .

Sep 19, 2013 | 2000 Chevrolet Astro

1 Answer

G200 has died, replaced spark plugs leads and distributor but still will not fire although cranks over easily enough


check module unit in distributor for power. check that rotor button is turning and the cam shaft is rotating( Broken timing belt/ chain)

Jan 19, 2013 | Cars & Trucks

2 Answers

My 1994 chevy astro van is turning over but won't start,i installed a new coil and anew distributor but there is no spark at the coil to the distributor


their are two spark control features one is the pick up coil it's mounted under the distributor the other is in the distributor it the control module check the pink wire that plugs into the distributor for power

Aug 27, 2012 | 1994 Chevrolet Astro

2 Answers

1999 chev blazer stopped running turns over no


hi...
1.try checking the clearance in the spark plug if you have insufficient or more clearance you wont get spark check this.
2.check the wire coming to the spark plug.if power is not coming to spark plug there wil be discontinuity in the wire try replace it.

if you get the information which you needed please vote me by clicking the thumbs present in the underside of the page.

Jul 10, 2010 | 1999 Chevrolet Blazer

1 Answer

No spark


Could be your crank sensor or the distributor. Do you have a check engine light if not chang the distributor.

Nov 14, 2009 | 1990 Honda Prelude

Not finding what you are looking for?
1997 Honda Civic Logo

Related Topics:

419 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...