Question about Cars & Trucks

Open Question

Disable jeep alarm

Jeep will not start, the doors are locking and unlocking when I turn on ignition. How do I deactivate the alarm.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 1996 Jeep Grand Cherokee alarm keeps randomly going off.

this happened to me recently with my 96 grand cherokee. the battery got drained by the alarm going off randomly at night. i pulled the fuse for the horn so at least my neighbors would only be bothered by flashing lights. then i couldn't jump the car because the alarm was still going off. i hooked my car to jump it to another car, and then i had to deactivate the alarm first by putting my key in the driver side door and unlocking the car. then i left it hooked to another car and still getting power but didn't jump it for at least 5 minutes in case the computer needed to reset. then it jumped fine. from what i've read online, this is a common problem that can be avoided if you stop using the power locks and always manually lock and unlock the doors with your key. its a little annoying, but apparently the power locks are connected to the alarm issue. hope the same works for you.

Posted on May 28, 2009

  • 1810 Answers

SOURCE: 1999 Jeep Grand Cherokee alarm goes off everytime

alarm remotes not disarming system look in manule for instructions on how to place alarm in valet mode
to disable alarm

Posted on Jan 28, 2010

airjer995
  • 5332 Answers

SOURCE: Ignition on my 2004 jeep grand Cherokee is locked,

tap the ignition lock cylinder with the plastic end of a scrwedriver (with the key removed). then insert the key and try to start. Try this several times. If you get it to turn immediately replace the igntion lock cylinder. The cylinder needs to be in the on position in order for the lock button to be depressed so that the cylinder can be removed from the housing.

If you still can't get it to turn than you will have to drill out the lock button in order to get the old lock cylinder out. I wouldn't recommend doing this unless you have some experience and understand what you are doing.

The lock button can be accessed by removing the lower steering column cover.

Posted on Nov 23, 2010

  • 151 Answers

SOURCE: my jeep key would not

TRY TO LOCK THE CAR WITH THE REMOTE.

LEAVE THE DRIVERS WINDOW DOWN

LOCK AND UNLOCK IT SEVERAL TIMES.

THIS SHOULD RESET THE SYSTEM

THEN TRY TO START THE CAR

Posted on Dec 26, 2010

saailer
  • 1868 Answers

SOURCE: I have a factory installed alarm on my 2003 jeep cherokee ,how do i disable alarm

Hello! The drivers side door lock/unlock switch is more than likely defective...Having said that, the alarm system on Jeeps are a constant problem...To disable the system requires removing the drivers door panel and cutting the Light Green/Orange wire at the switch...And installing a 465 Ohm resistor...Not something done without the necessary skills...
I would have the vehicle towed to a Jeep dealer and have them test the drivers door switch and disable the alarm....Guru...saailer

Posted on Feb 02, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a factory installed alarm on my 2003 jeep cherokee ,how do i disable alarm


Hello! The drivers side door lock/unlock switch is more than likely defective...Having said that, the alarm system on Jeeps are a constant problem...To disable the system requires removing the drivers door panel and cutting the Light Green/Orange wire at the switch...And installing a 465 Ohm resistor...Not something done without the necessary skills...
I would have the vehicle towed to a Jeep dealer and have them test the drivers door switch and disable the alarm....Guru...saailer

Feb 02, 2012 | Jeep Grand Cherokee Cars & Trucks

1 Answer

I have a 2005 JGC 5.7 hemi and sometimes remotes wont work only when you want to unlock it.If you use the key to open door alarm sounds. what could be the problem?


Have you tried a new battery in the remote, or do you have a second remote you can test. Either your remote is worn out or the battery is dead.
Once you lock the car with your remote it will active the alarm and if you use your key it won't deactive the alarm only your remote will, on some cars putting the key in the ignition will deactive it.
If you can deactive your alarm with your remote and can just manualy lock and unlock your doors and that should prevent your alarm from going off until you get a new remote or battery.

Aug 05, 2011 | 2005 Jeep Grand Cherokee

1 Answer

My jeep key would not unlock my jeep with the keyless entry, I used my key to unlock the door and set my alarm off. I disabled the alarm by putting the key in the ignition and now my key will not start...


TRY TO LOCK THE CAR WITH THE REMOTE.

LEAVE THE DRIVERS WINDOW DOWN

LOCK AND UNLOCK IT SEVERAL TIMES.

THIS SHOULD RESET THE SYSTEM

THEN TRY TO START THE CAR

Dec 26, 2010 | 2005 Jeep Grand Cherokee

1 Answer

2001 Jeep Grand Cherokee Laredo. Alarm sets off when unlocking doors with remote and will not shut off with remote, or by pressing the reset button behind blinking alarm light under dash,or by using key in...


I found a solution on another site showing if i turn the ignition on and hold the reset button on behind the alarm light untill it turns to solid blue light then turn off the ignition , it will disable the alarm.

Dec 12, 2009 | 2001 Jeep Grand Cherokee

1 Answer

1996 Jeep grand cherokee limited


I WAS HAVING THE SAME PROBLEM, YOU HAVE TO TURN THE IGNITION OFF, GET OUT OF THE CAR, LOCK YOUR DOOR WITH THE KEY AND THEN UNLOCK IT. THAT IS ONE WAY , IF THAT DOESNT WORK PUT THE KEY IN THE IGNITION AT THE SAME TIME TURN THE IGNITION SWITCH AND PRESS AND HOLD KILL SWITCH UNDER STEERING COLUMN, BEHIND FUSE BOX

Feb 28, 2009 | 1996 Jeep Grand Cherokee

6 Answers

Jeep alarm will not turn off


The ignition security on/off is located at the trunk lock. unlock and lock rear gate and the alarm will turn off. My jeep sat in my drive for a month before a jeep tech told me this. It still triggers the security sometimes when I unlock the passenger door with the key and I go straight to the rear gate lock and it shuts off instantly.

Jun 27, 2008 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...