Question about Cars & Trucks

Open Question

Replacing tcc solenoid - Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75807 Answers

SOURCE: tcc solenoid code

This is a transmission issue, TCC is Torque Converter Control, the solenoid is inside the trans, unless you are a well versed technician I would leave this to the transmission experts, you might try premium assistance for someone that can provide more detailed step by step repair procedures if you are determined to do the repair yourself.

Posted on Oct 06, 2008

  • 289 Answers

SOURCE: 2002 Sunfire TCC Solenoid replacement

hi..the transaxle converter clutch . tcc. uses a solenoid -operated valve located in the automatic transaxle to mechanically couple the engine flywheel to the output shaft of the transmission through the torque converter.that reduces the slippage loss in the converter.reducing emissions.but check the vss first.which is called the vehicle speed sensor.they both work together .if the vss is not working right it wont call on the tcc.
check this out..
thank u..
rate me..

Posted on Mar 06, 2009

Molson02536
  • 3854 Answers

SOURCE: p1744 enginge code tcc solenoid circuit

DTC P1744 is "TCC - Excessive Slip Detected During Full TCC Engagement". Which means that the Torque Converter Clutch (TCC) is disengaged or the EPC pressure is at the minimum.

The most likely cause is a sticking or bad TCC solenoid inside the transmission. You can check the connector at the transmission to make sure it is clean and tight and that it is not damaged in any way.

If the TCC and wiring is okay, then pressure testing of the transmission will need to be done.

A new torque converter from Ford is about $265.00 and about 4 hours labor. Throw in a $40.00 TCC solenoid and I don't think it'll be more than $700.00 at worst.

If the pressure test is good then it's just going to be the $40.00 tcc solenoid and the cost of the transmission oil and filter changed which should be around $150.00

Good luck and hope it's just a loose wire harness to the solenoid which would cost $0.00 and just your time to locate the break in the wire. The other thing to, is to add a transmission fluid additive that would restore the clutch pack in the transmission and Torque Converter.

Posted on Nov 17, 2009

Testimonial: "thanks a lot very helpful and detailed explanation"

SOURCE: Got this code p0740, tcc

P0740 - Torque Converter Clutch Circuit Open

Possible Causes:
- Low transmission fluid level
- Dirty transmission fluid
- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness or connectors
- Torque converter clutch solenoid valve circuit is open or shorted

Check your fluids 1st if they are low add fluid, and if they are dirty do a flush and a new filter. This usually will take care of it and save you money. TCCSV is a bit pricey try the cheaper route first. But it is located inside the transmission or on the side of the transmission. I dont recall exactly. Its something I would let a shop do though unless you have high mechanical skills.

Posted on Jan 13, 2011

cansmo
  • 2431 Answers

SOURCE: TCC Solenoid

In the valve body of the transmission, This can be check by its PWM (pulse width modulation) The wire connection is a seven pin connector at upper front of trans case. What you are describing does not seem to be a TCC problem. The TCC comes on at above 50 MPH. Drive at above 50 MPH step on the brake pedal not to stop the vehicle, just slightly,.enough to turn off the TCC. See if it make a difference then do it going toward 30MPH.

Posted on Mar 05, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I clear the code1860 on my Chevy venture 3.4 so it will pass smog


Replace the TCC solenoid in the transmission !
Ignition voltage is provided to the torque converter clutch pulse width modulation (TCC PWM) solenoid valve. The PCM controls the solenoid with a negative duty cycle in order to control application and release of the TCC. When the solenoid is commanded OFF, the PCM senses high voltage.When the solenoid is commanded ON, the PCM senses low voltage.
DTC P1860 sets if the PCM detects a voltage that is outside of the calibration limits. DTC P1860 is a type B DTC .
Do you know what the TCC is ?

Sep 03, 2015 | Cars & Trucks

1 Answer

What does the TCC code mean for chevy s10


The Torque Converter Clutch (TCC) solenoid valve is an electrical device that is used with the torque converter clutch pulse width modulation (TCC PWM) solenoid valve in order to control TCC apply and release. The TCC solenoid valve attaches to the transmission case assembly extending into the pump cover. The Powertrain Control Module (PCM) controls the solenoid by providing the ground path. The PCM monitors the throttle position (TP) voltage, the vehicle speed and other inputs in order to determine when to energize the TCC solenoid valve.

replace the relay.....its common for it to go out.

Jun 29, 2014 | 1997 Chevrolet S-10 Pickup

1 Answer

Torque converter p0741 performance


code p0741 refers to torque converter clutch (TCC) solenoid--performance or stuck off===causes-- Wiring---TCC solenoid. I would consider replacing the TCC solenoid

Sep 25, 2013 | 2003 Hummer H2

1 Answer

When I had my car tested the code po741 came up


code p0741 refers to torque converter clutch (TCC) solenoid---performance or stuck off===causes --wiring ---TCC solenoid. Replace the TCC solenoid.

Sep 08, 2013 | 2005 Chevrolet Malibu

2 Answers

PO741 could it be the brake switch and how to know if its the problem 2004 freesatr


EOBD Code: P0741
Faiult location: Torque converter clutch (TCC) solenoid - performance or stuck off
Probable cause: Wiring, TCC solenoid

First time check the wires and connection plug & socket of TCC solenoid. If everything will be OK then replace TCC solenoid.

Sep 22, 2010 | Ford Freestar Cars & Trucks

1 Answer

Code scanner says torque converter circiut stuck on. 1998 Grand Prix


The code scanner is indicating that the TCC or Torque Converter Circuit (Clutch) Solenoid is on all of the time. The TCC solenoid must be replaced to fix this problem which requires taking a pan off and replacing a spaghetti-like wired contraption known to go bad that is a solenoid that controls the TCC.

Aug 17, 2010 | 1998 Pontiac Grand Prix

2 Answers

What would it cost to fix a torque converter stuck in the ON position. That is what the code reader told us it was. Chevrolet Lumina 2001. Thank you.


It may be as simple as a short in the wire or a bad TCC solenoid that needs to be replaced. The most would be just under $200.00 with parts and labor with transmission fluid and filter replaced.
If your lucky, you may find where the issue is if it's a wire that is shorting out. Inspect your TCC switch on your brake peddle and it may just need to be readjusted. The other place would be a short to the transmission harness where is connects to the transmission. Once all electrical connections have been inspected, then your going to have to move on to having a transmission shop replace the TCC solenoid replaced.
TCC always locked: TCC apply solenoid circuit shorted to ground, TCC solenoid blockage (easy fix in pan), or TC broken (must remove trans and replace TC).
Thank you for using fixya and most common would be a ground problem, good luck and hope it's will cost you nothing if you find it.

Jun 20, 2010 | 2001 Chevrolet Lumina

2 Answers

Wondering what the TCC fault code is


Here are the DTC's for the TCC Solenoid:

DTC P0740 TCC Enable Solenoid Circuit Electrical
DTC P0741 TCC System Stuck Off
DTC P0742 TCC System Stuck On
DTC P0743 TCC Enable Solenoid Circuit Electrical
DTC P0744 Torque Converter Clutch Circuit Intermittent

-KC GTO Dad

Sep 17, 2009 | 2002 Pontiac Grand Prix

2 Answers

2002 Sunfire TCC Solenoid replacement


hi..the transaxle converter clutch . tcc. uses a solenoid -operated valve located in the automatic transaxle to mechanically couple the engine flywheel to the output shaft of the transmission through the torque converter.that reduces the slippage loss in the converter.reducing emissions.but check the vss first.which is called the vehicle speed sensor.they both work together .if the vss is not working right it wont call on the tcc.
check this out..
thank u..
rate me..

Mar 06, 2009 | 2002 Pontiac Sunfire

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

223 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...