Question about 1993 Mitsubishi 3000GT

1 Answer

Cannot find where to hook the negative battery cable

I have a 1993 Mitsubishi 3000 GT. The battery cable (negative post) has two wires. One is screwed to the firewall. I cannot find where the other goes. Can you tell me what it connects to

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 66 Answers

It should go to the engine block or head.

Posted on May 21, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where does the ground wire for a 93 daodge dakota attach?


Battery Cable?

To the engine block

If a V8 there should be a threaded hole
near top of motor on battery side for the
negative cable

Feb 12, 2013 | 1993 Dodge Dakota

2 Answers

Mitsubishi 2001 Galant battery drain


Do not disconnect the positive Or negative cable while vehicle is running it is no longer an acceptable test and damage to computers could occur as there is no ability to suppress or absorb a voltage spike. If you remove the negative cable to check for an amperage draw that's an other thing. You should use a meter and connect it in series between the neg post and the neg cable once all modules are in sleep mode there should be no more than .3v as a rule of thumb. If more you have a parasitic draw which you could isolate the system/circuit by removing fuses one at a time. When the draw is gone that's the circuit in question.

Jun 18, 2012 | 2001 Mitsubishi Galant

1 Answer

How can i know if my starter relay is bad on a dodge stratus 2001


IF STARTER RELAY BAD THE STARTER WONT MAKE NO NOISE AT ALL HEADLIGHTS WONT DIM.IF YOU CLICKING NOISE BATTERY VOLTAGE TOO LOW. MAKE SURE BATTERY VOLTS ARE 12.6 VOLTS AND USE TEST LIGHT TO SEE IF STARTER GETTING POWER.COULD HAVE BLOWED IGNITION FUSE OR FAULTY IGNITION SWITCH. TO CHECK STARTER SOLENOID FIRST TURN OFF RADIO THEN REMOVE NEGATIVE BATTERY CABLE AND POSITIVE BATTERY CABLE.THEN REMOVE STARTER BUY A REMOTE SWITCH.YOU NEED BATTERY JUMPER CABLES HOOK BATTERY JUMPER CABLES TO BATTERY PUT POSITIVE CABLE ON POSITIVE BATTERY POST THEN PUT NEGATIVE BATTERY CABLE ON NEGATIVE POST. HOOK BATTERY CABLES TO STARTER USE NEGATIVE CABLE GROUND STARTER BODY AND PUT POSITIVE BATTERY CABLE ON THE LARGE POSITIVE POST ON STARTER SOLENOID. NOW TAKE REMOTE SWITCH HOOK RED WIRE TO STARTER SOLENOID POSITIVE POST THEN HOOK BLACK WIRE TO REMOTE SWITCH TO STARTER SOLENOID SWITCH TERMINAL WITH LETTER S THEN PRESS REMOTE IF STARTER SPINS STRONG WITH A GOOD KICK STARTER GOOD.YOUR PROBLEM COULD BE CORRODED WORN BATTERY CABLES. WEAK BATTERY FAULTY IGNITION SWITCH. IF STARTER DONT WORK WHEN YOU PRESS THE REMOTE SWITCH STARTER SOLNOID BAD OR STARTER ITSELF BAD.IF ALL IS GOOD. CODE SCAN CAR FOR THEFT SECURITY FAULT CODE.

Aug 28, 2011 | 1999 Dodge Caravan

2 Answers

Truck will not start how can i tell if its a starter or selonoid


does it spin real fast without clanging and grinding against the flywheel? if so then its probably the solenoid bad. do you have to hit the starter with a hammer then it works? it is probably bad brushes or a worn motor. eather way i think you can only get a new starter and solenoid together not sold seperate. check for bad battery cables (loose).

May 30, 2011 | 1996 Chevrolet K1500

1 Answer

The alternator fuse link keeps on blowing out on my 97 mitsubishi 3000 gt.and killing the alternator as well


CHECK ALTERNATOR POWER FEED WIRE AND VOLTAGE REGULATOR WIRES FOR EXPOSED WIRES SHORTING TO GROUND.CHECK BATTERY POSITIVE CABLE FROM ALTERNATOR TO STARTER. LOOK FOR SIGNS BURNT WIRES.YOU HAVE POSITIVE BATTERY CABLE SHORTING TO GROUND.OR STARTER SOLENOID OR STARTER SHORTING OUT.TRANSMISSION NEUTRAL SWITCH OR IGNITION SWITCH WIRES SHORTING OUT IGNITION.

Jan 06, 2011 | 1997 Mitsubishi 3000GT

1 Answer

My wife has a 96 3000 gt has new starter and battery and alternator and runs for a couple days then won't start i jump start it and its good for a couple days then it happens again what could be doing this...


sounds like a loose wire at the battery,check both termanals and dont be afraid to give them a good shake also get the wires from the battery to the starter checked even the small ign wire to the starter.adrian,,,,,,

Aug 12, 2010 | 1993 Mitsubishi 3000GT

1 Answer

I have a 1993 Mitsubishi 3000 GT. It has a new


need more info whether you have fuel pressure etc.

Jul 31, 2010 | 1993 Mitsubishi 3000GT

3 Answers

I change my battery post now I don't know where they go on the - or + side can you help me out


Hello. Yes. the black wire is the ground wire. It goes from the frame to the negative post of the battery. The red wire is the hot wire and it goes to the positive post.

Nov 24, 2009 | 1994 Buick LeSabre

1 Answer

Battery is draining


Here is the procedure I use to isolate a battery drain. Remove negative battery cable from the battery. Using a 12-volt test light, hook one end to the negative battery post the other end to the negative battery cable you just disconnected. The test light will glow or "light" if there is a drain. If the "light or glow" is faint, that is probably normal draw for the clock or computer. If the "light or glow" is bright, then there is a large drain. That should be corrected. Now start removing and replacing the fuses one by one until the light goes out; that one will be the circuit with the drain. Remember to hold in the button in the door jam for the interior lights.

Oct 17, 2009 | 2000 Mitsubishi Galant

2 Answers

1993 Ford Explorer battery was stolen and they cut all the cables


which wires ? the ones connected to the battery? or the wiring harness? if it's the battery cables then the large wire is the positive side normally red and the negative side is black and is half the size of the positive wire. The battery will have a + and a - on it so you know that the positive wire is + the larger wire and the smaller is black.

Mar 28, 2009 | 1993 Ford Explorer Limited

Not finding what you are looking for?
1993 Mitsubishi 3000GT Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...