Question about Cars & Trucks

Open Question

Troubleshooting code p2112 on toyota tacoma - Cars & Trucks

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

clifford224
  • 1975 Answers

SOURCE: toyota trouble code P2112

A trouble code of P2112 has to do with the electronic throttle control system (ETCS). Unlike vehicle in the past, your gas pedal does not have a cable that goes to the throttle body to open and close your throttle plate or the thing that makes your idle go up and down to make your vehicle go faster or slower. Your vehicle works with sensors and motors in order to go faster or slower. In other words in simple terms you have a sensor at the gas pedal which is supposed to send a signal to the vehicles computer (ECM). Then the ECM sends a signal to a motor as well as another sensor to tell the throtle to go faster or slower. It's a litle technical but that's a simple way of putting it. Toyota's will go into a "fail safe" mode when it detects a problem. The fail safe mode basically makes the computer set the idle at a certain point so the vehicle can at least be moved slowly and that's all it will do until the problem is corrected. You didn't mention your engine size so I'm not able to really give you anything to check but if you're not real mechanically inclinded you may want to take it to a reputable repair shop. There are MANY tests to do to narrow down the source of the problem but in most cases that I have seen it was some sort of a binding in the throttle body. I know this answer didn't really give you and answer as far as how to fix it but I hope I have been able to help you understand why you have this code and why the vehicle isn't moving hardly which I'm guessing is the case....

Posted on Sep 11, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What are the probable causes of DTCs P0688 and P2112?


P2112 Chrysler - Engine-Codes.com

engine-codes.com/p2112_chrysler.html
Possible Causes and Repair Information for P2112 Chrysler code. Learn what doesP2112 ... 2005 CHRYSLER 300 Engine And Engine Cooling:engine Details

Aug 12, 2015 | Chrysler 300M Cars & Trucks

1 Answer

Camry 2005 P2112


P2112 TOYOTA - Throttle Actuator Control System - Stuck Closed

Read more: https://www.engine-codes.com/p2112_toyota.html

Jun 30, 2014 | 2004 Toyota Camry

1 Answer

Where is the decelaration senser for the a.b.s. o4 tacoma 4x4


Diagnostic Test Code (DTC) C1244 is a "maufacturer-specific" code used by Toyota for this vehicle. Toyta defines this code simply as "DECELERATION SENSOR CIRCUIT."

Possible causes are:
> Faulty ABS deceleration sensor
> Open or short in deceleration sensor circuit
> Defective wiring harness or connectors

The deceleration sensor for your 2004 Toyota Tacoma is located under the passenger seat.

Jun 15, 2012 | 2004 Toyota Tacoma

1 Answer

P1036 Fault Code - 2002 Toyota Tacoma


Sorry! I wish I could help you, but fault code P1036 is not a valid code for a 2002 Toyota Tacoma. Read the code again and repost your question.

May 14, 2011 | Toyota Tacoma Cars & Trucks

1 Answer

I have 3 codes from my scaner p2111 p2112 p2238


P2111 - Throttle Actuator Control System Stuck Open.
P2112 - Throttle Actuator Control System Stuck Closed.
P2238 - O2 Sensor Positive Current Control Circuit Low Bank 1 Sensor 1



For the P2111 & P2112 you will need to replace the throttle body this can be pricey since the TAC is built into it. Try cleaning it good and see what happens. This can also trigger the P2238 code if its dumping fuel.
For the P2238 check the connections on the o2 sensor or replace the upstream o2 sensor that should correct it.

Dec 31, 2010 | 2004 Toyota Solara

1 Answer

Code p2112 system stuck close, what do i do in this case? My car is a jetta 06 TDI 1.9 turbo


p2112 means throtle accuator stuck closed. Check the wire connections on the air intake flap motor . Might have to replace the intake flap motor.

Apr 14, 2010 | 2006 Volkswagen Jetta

2 Answers

Have p0130 and p0133 codes 98 toyota tacoma


check the mass air flow sensor there maybe dirt on the filiment inside the sensor causing false readings. cleaning or replacing it may make the codes go away.

Oct 28, 2009 | 1998 Toyota Tacoma

2 Answers

P0450 trouble code


Your vehicle has whats called a OBDII diagnostics setup. Just google "2001 Toyota Tacoma, OBDII trouble codes". You should get a whole page full of responses. (Type in exactly what is in exclamation marks above) Once you have codes, scroll down to PO450. Remember, whatever sensor/circuit it refers to, means there is a problem with the circuit, the sensor, ie..wiring, bad connector, bad ground, short, open, and so on. Dont just change out part without first examining the wiring and connectors first. Common sense goes a long way with this sort of troubleshooting.

theroad

Apr 19, 2009 | 2001 Toyota Tacoma

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...