Question about Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Is your temperature gauge also faulty? I've read that it could be the voltage regulator in the instrument cluster. Can't confirm.
Posted on Dec 08, 2010
SOURCE: Toyota Tazz window winder
Toyota Tazz driver side window refused to wind properly. Problem was that winder mechanism and window separated - old glue. Found some input from Ben on this forum. Some pointers after doing the job today.
Step 1 - remove the arm rest - two screws
Step 2 - remove the screw holding the door opener handle.
Step 3 - remove the C-clip holding the winder handle. The clip is round but the ends are slightly bent outward - to fit back easily. Use a large screwdriver to force a small opening (thus moving the panel slightly inward). I took a piece of thin solid wire and bent it into a loop. This looped wire I hooked around the one end of the clip and pulled in the opposite direction towards the inside of the car. The open end is towards the part of the handle you wind. Make sure the top of the handle faces towards the interior of the car (door is open wide). The clip shot off (as Ben warned) but landed in the car.
Step 4 - the door handle (square) must be slid forward and outward towards you. Will now be loose but is held by the rod going to the lock.
Step 5 - loosen all clips carefully by pulling the panel forward - large screwdriver works.
Step 6 - lift up the panel - and push the door handle holder through the hole in the panel. The panel will now be free.
Step 7 - the window can be removed in this case where window and mechanism seperated by simply pulling the window upwards and outwards.
Step 8 - I used a small grinder and removed most of the glue - but not all.
Step 9 - put the window back into the door making sure it is correctly aligned in the side-sliders.
Step 10 - I used an epoxy 2-part glue (Pratley) and placed some glue in the holders. Position the window and mechanism correctly (using glue I left as marker). Note that only 2 holes in door panel can be used to see or fit glue.
Step 11 - Mix more glue and apply front and back. Now place some grease in the mechanism rail (horizontal) and wind window to the top. Leave to dry.
Step 12 - replace all in reverse. Clip pushes on easily - I used a small long-nose pliers.
Posted on Feb 03, 2013
Tips for a great answer:
Dec 03, 2016 | Toyota Cars & Trucks
Jun 28, 2016 | Toyota Cars & Trucks
Jun 23, 2016 | 2001 Toyota Corolla Hatchback
Jul 08, 2014 | 2005 Toyota Tazz 130
Jan 23, 2014 | 2005 Toyota Tazz 130
Nov 03, 2013 | 2005 Toyota Tazz 130
Oct 18, 2012 | 2005 Toyota Tazz 130
Feb 08, 2012 | 2005 Toyota Tazz 130
14 people viewed this question
Usually answered in minutes!