Question about 2000 Pontiac Grand Prix
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
as you face the engine the thermostat bell is on the right (drivers side) Follow the radiatoe hose. Remove the two bolts and raise the bell still attatched to the hose. the thermostat is there with the rubber seal. You can gently pry the thermostat out with a screwdriver or something similar. Put in new thermostat be sure it is the same as the old one, and then replace or change the seal (be sure it is the smae size and thickness as the old one as I got the wrong size from Napa) Then replace the bell, and tighten, but not over tighten. I hope this helps!
Posted on Jan 31, 2009
DTC P0641 The powertrain control module (PCM) provides a 5-volt reference to the
The throttle position (TP) sensor 1
The accelerator pedal position (APP) sensor 2
The engine cooling fan speed sensor
The AC pressure sensor
The fuel tank pressure (FTP) sensor
The oil pressure sensor (OPS)
The PCM monitors voltage on the 5-volt reference circuit. If the voltage is higher or lower than required, DTC P0641 will set.
Conditions for Setting the DTC
The PCM detects a voltage that is higher or lower than required on the 5-volt reference circuit. The above condition is present for 1 second. Action Taken When the DTC Sets The control module illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails. The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Freeze Frame/Failure Records.
Conditions for Clearing the MIL/DTC The control module turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail. A current DTC, Last Test Failed, clears when the diagnostic runs and passes. A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic. Clear the MIL and the DTC with a scan tool.
Yes i can be dangerous, depending which issues mentioned above has triggered the code such as a faulty gas peddle position sensor. the code can also cause a reduced engine power to activate.
Thank you for using Fixya and best advice is to have the dealer address these issues. A tech 2 scanner would be needed to address the P0641 DTC code.
Posted on Mar 19, 2010
Testimonial: "Thank you for your detailed, easy to understand and very quick response!"
Tips for a great answer:
Nov 24, 2015 | Pontiac Cars & Trucks
Oct 15, 2015 | 2000 Pontiac Grand Prix SE
Aug 02, 2014 | 2002 Pontiac Grand Prix
Jul 29, 2014 | 2007 Toyota Tundra
Jan 31, 2011 | 2005 Pontiac Grand Prix
Jul 28, 2010 | 2000 Pontiac Grand Prix
May 16, 2010 | 1995 Pontiac Grand Prix
Mar 26, 2010 | 1997 Pontiac Grand Prix
Mar 15, 2009 | 1995 Pontiac Grand Prix
Mar 05, 2009 | 1999 Pontiac Grand Prix
21 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: