Question about Cars & Trucks

1 Answer

-17 degrees centigrade started van drove in reversed for 10 seconds after which van would not move with engine idling and transmission in gear move transmission lever to drive van would not move. Move transmission lever back and forth for about 15 seconds then van started to move normal..What is the most likely cause for this problem to occur . Thanks

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 4 Answers

Most likely in this severe weather the fluid and the bands in the transmission need time to circulate and warm up. It is a good idea in severe weather to allow a vehicle to warm up for at least 4 - 6 minutes before driving it. Remember that oils and lubricants get very thick in cold weather.

Posted on Jan 03, 2014

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ticodude
  • 53 Answers

SOURCE: #5 cylinder misfire

I have a corolla and had #4 cylinder misfire also diagnosed at autozone. After changing the spark plugs, problem persisted, along with the same error code, so they recommended changing the spark plug wires, and that is what fixed it. I would have changed the rotor cap too, but was low on dough. Glad that was not the problem.

Posted on Dec 29, 2008

Murphybanton
  • 2004 Answers

SOURCE: 1991 735i automatic transmission,no forward drive, has reverse

The transmission has gone bad and all I can say is that you need to replace it.

Good luck.

Posted on Aug 29, 2009

ghost45
  • 1280 Answers

SOURCE: 2001 Hyundai - reverse gear is inoperative. The

If I understand you correctly, you have ALL forward gears working, but reverse doesn't?... then the problem is in the transmission itself or the linkage on the trans linkage into reverse.

Posted on Oct 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wont go in to reverse and sometimes wont go in to drive


ewprotest.org: SECOND TRANSMISSION ISSUE

newprotest.org/details.pl?1457
Dec 27, 2009 - This time around, the check-engine light came on, and while driving on the ..... my dodge caravan wont go in reverse and only a few feet forward tranny shot i will go ... I have a 1992 Dodge Grand Caravan 3.3L 4-speed xmission. ..... having shifting issues sometimes shifts fine other times I have to cut van off ...

No Reverse - The Chrysler Minivan Fan Club Forums

forum.chryslerminivan.net/showthread.php/19184-No-Reverse

Nov 21, 2010 - 10 posts - ‎1 author
BTW, I have driven it all summer, over 7k miles with no reverse; I just park up hill or in a drive-thru spot! ... 1992 S-10/4.3L V6/249K mi/original 4L60E ... I had a '90 Grand Caravan w/3.3 and same trans. rebuilt at 120k by AAMCO ... I've decided to drive it until the forward gears go out before I pay for a rebuild ...

10 Most Common Transmission Problems

www.transmissionrepaircostguide.com/10-common-transmission-proble...
Ever notice that while driving that the car hesitates or refuses to go into gear? ... that needs to be replaced, but may sometimes point to a more severe problem. ... If the carwill not shift after engaging the clutch and trying to move the stick, take a .... This is a problem because in park a dodge dose not run the the transmission ...

Transmission May Fail Causing Slipping in First or Reverse ...

repairpal.com > Problems > Dodge > Caravan

Jan 27, 2016 | 1992 Dodge Caravan

2 Answers

Car will start but put it in gear engine will die


engine starts with no problem; but, when I put in gear and ...

www.cargurus.com > Questions > Hyundai > Sonata

CarGurusNov 15, 2012 - The engine just fall dead when you step on the gas; it seems to jerk before ... My car does the same thing but i put it in neutral n it starts up. ... I have a 2004 kia optima it jerks when I go into reverse it was driving ... start and run fine butwhen I put it in drive or any other gear it dies! ... 2002 Hyundai Elantra GT.

Engine stalls when tranny put in Drive or Reverse - Kia Forum

www.kia-forums.com/kia-carnival...2002.../43407-engine-stalls-when-tr...

Feb 28, 2008 - 10 posts - ‎3 authors
Give it a little gas before putting in D or R and it will go. .... When I start the van cold and shift the tranny into drive or reverse.....the whole front ... won't run in forward gears - Kia Forum
10 posts
May 25, 2012
Intriguing problem - engine rough idle & hesitation ...
10 posts
Aug 31, 2011
2006 Kia Spectra engine stalls and bad idle, cleaning the ...
10 posts
Aug 30, 2010
2002 Kia Spectra Won't Go Out of Park - Kia Forum
3 posts
Oct 28, 2008
More results from www.kia-forums.com

Dec 17, 2015 | 2002 Kia Rio

1 Answer

The gear selector on my 2002 Ford Windstar moves, but the transmission won't go into gear. Why is the transmission not going into gear?


try to replace transmission strainer first torque convertor and see if that helps if not it probabaly the transmission

Jan 31, 2013 | Cars & Trucks

1 Answer

My 2004 sienna hit bumpy corner express road at 45mph, seconds later the whole van shakes like I'm driving on 4 flat tires then vsc and check engine light comes on. The van refuse to move as if I


Hello


The Engine and Automatic Transmission (not applicable to manual transmissions) in this vehicles drive train are fully electronically controlled by a computer called the PCM and TCM (Power Train Control Module, Transmission Control Module). When a problem like this or other drive-ability related problems occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM. Also always check fuel pressure for correct spec for your make and engine type.


Sep 20, 2012 | 2004 Toyota Sienna

1 Answer

IT STARTED ABOUT TWO WEEKS AGO, SHIFT INTO REVERSE, TRUCK WILL NOT MOVE IN REVERSE. IT HAS ALL FORWARDS GEARS, I PUT IN 4X4 AND IT STILL WILL NOT MOVE IN REVERSE. HELP


This is caused by the gear oil,there is none in the gear box, so get a transmission fluid and fill the gear box with it, run the engine idle for some minutes and then try select the gear.

Jan 12, 2011 | Chevrolet 2500 Cars & Trucks

1 Answer

When i put my van into drive or reverse, the van wont move. I'm hoping it'snot the transmissions. I haven't had any issues with this problembefore. I had my brother look t it, he thinks it's somting to...


OK so the engines fires up? This means that the transmission is neutral or park. Try starting the car with the shift in gear. If the car starts but does not move this tells you that the selector switch on the side of the transmission casing is not being moved out of 'park' and therefore the links need to be checked for continuity. If the engine fails to start then the selector has been moved out of 'park' and that although the links from the gear selector in the car to the are OK there is something wrong with the transmission.

Aug 20, 2010 | 2004 Ford Windstar

1 Answer

2002 Windstar wont go into gear


These are common for the pump shaft splines stripping in the torque converter. The transmission will need to be removed to fix it. Before you condemn the trans, does the speedo move and the van doesn't or do you hear any grinding when you put it back into park? Or can you push the van in park (Broken CV shafts)?

Mar 28, 2009 | 2002 Ford Windstar Cargo

2 Answers

Transmission problem


im sorry to say no it will not.

Mar 02, 2009 | 1988 Chevrolet Astro Cargo

1 Answer

Van Cuts Off In Drive


sounds like transmission

Feb 17, 2009 | 1993 Oldsmobile Silhouette

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...