Question about Toyota 4Runner
Ask a real question
veh. stability control system
is this why is the light glowing?
did you read the operators guide, yet, no, then nows the time.
no year, ?
in general it will say, all cars
stop driving bad. (you doing skid on purpose?)
if it come back with good driving,
get it serviced. can be bad brakes too.
best answer (of the inane on the web)(a real tech answers)
If you haven't read your owner's manual on when the VSC light may normally be on and off, do that first. Then, if it's not functioning the way the owner's manual says it should and is indicating a VSC error condition, have the dealer read out the VSC error codes again. When the error code lamp is lit, that means there is a current code and fault in the VSC system. The dealer technician then follows a troubleshooting procedure for those error codes.
the lamp can warn of driving wrong
or if there is a problem , get your operators guide and read it.
if on ice, it might be normal. see?
if on ice and you drive like crazy, it might not be able to correct
crazy, so glows the lamp.
Posted on Jan 03, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
to reset for a momentany malfuntion,disconnect the negative battery terminal few minutes, reconnect,start engine and drive to check
Posted on May 03, 2009
It is not hard to change the sensor, it just screws into a threaded hole. The light will not go out immeditaly, after the sensor is replaced. It needs to go thru a drive cycle. Your best bet is to replace the sensor and get the code cleard by whoever scanned it for the 0031 code.
Posted on Jul 23, 2009
Check your switches for the VSC, some get bumped on (due to their location) and some get stuck in the "on"position.
Posted on Aug 04, 2009
I did research on line and all indicates that is caused by the YAW RATE SENSOR. It nedds to be replace and adjust. I have the same problem but havent find the time to get to it. When I do I will post it. If you do it before I do please email me with the result at firstname.lastname@example.org
Posted on Sep 24, 2009
Tips for a great answer:
Jun 02, 2017 | Toyota Cars & Trucks
Nov 25, 2015 | Toyota Cars & Trucks
Aug 17, 2014 | 2006 Toyota Sequoia
Nov 19, 2013 | Cars & Trucks
Jun 17, 2013 | 2006 Toyota RAV4
Feb 27, 2012 | 2004 Toyota 4Runner
Jul 09, 2010 | 2004 Toyota Sequoia
Mar 24, 2010 | 2002 Toyota 4Runner
Jun 22, 2009 | 2007 Lexus GX470
159 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: