Question about 2004 Dodge Ram 1500

1 Answer

Windshield wipers stopped working

For a few months now they may or may not come on...but came on when I tapped the top of the steering column a couple times. That stopped working so I put a new multifunction switch in...nothing still.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 207 Answers

Check the wiper arm motor under the hood. Sometimes its the fuse, Check the circuit breaker for continuity across the terminals If an open circuit is indicated replace the circuit breaker. Also check between the circuit motor and the ground, and check the battery voltage with ignition on (don't start) if it test for voltage good and the motor still don't work its a faulty wiper motor. A used wiper motor will work as well as a new $$$$$$ one.Denton auto salvage 785-437-2223 test all their parts for working condition before shipping and have a 30 day return on them

Posted on Jan 03, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Need to locate and replace windshield wiper switch

What make of car do you have

Posted on Dec 25, 2008

  • 1596 Answers

SOURCE: I am missing a part for my headlight assembly (can't identify)

There is A Steal ROD that runs along the Collum from Actual Multi. Sw. Lever down to Dimmer Switch I Cannot Send Pics through FixYa but can Email them aol.com My Knickname in front w/@ of coars hope this helps Pics will Help More

Disconnect battery ground cable.

  1. Remove left lower instrument panel cover, then tape dimmer switch rod to steering column to prevent rod from falling out of notch in actuator lever.
  2. Remove switch to column attaching screws.
  3. Disconnect switch electrical connector, then remove switch from steering column.
  4. Reverse procedure to install. During installation, gently push up on switch to take up slack on rod.

Posted on Jan 29, 2009

dnewcombe1
  • 1564 Answers

SOURCE: horn button wouldn't work but horn works when using remote

You need to pull your steering wheel and get access to the small plastic tube with tabs on it. they sometimes come loose from the holder in the steering wheel fram. It's held in place by one tiny pin that you push in and turn one quarter turn to the right. If you find that his pin has broken off, a drop of superglue and a pair of needle nose pliers will do the permanent fix. Have a couple beers first because you only have a matter of seconds to get this spring and tube back in place. Can't have any shaking going on. Good luck, Dana

Posted on Aug 25, 2009

bunnydawg
  • 5158 Answers

SOURCE: wipers inop new multifunction switch new wiper

there is a relay in the fuse panel located next to the battery in the engine compartment. you will find the wiper relay there. replace it

Posted on Sep 06, 2009

moparhart
  • 245 Answers

SOURCE: My 2007 SLT 1500 is experiencing some electical

You need a new turnsignal switch

Posted on Jul 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Front windshiled wipers not working.


blown fuse, faulty wiper motor or faulty wiper switch. Possible you got a bad new wiper motor if you replaced everything in the order you wrote it in.

Mar 12, 2012 | 2003 Ford Windstar

1 Answer

1986 volkswagen windshield wipers will not turn off?


look for signs of a windshield leaking water into fuse/relay box- located near pedals under dash. Also remove small plastic trim below steering wheel ( 2 screws) and unplug black connector with 6 or 8 wires directly under steering column. Turn key on if wipers are stopped then your switch is bad- steering wheel must be removed to change switch.

Apr 29, 2011 | 1986 Volkswagen Cabriolet

1 Answer

Windshield wipers stopped working, washers stopped also.fuse is good. 260,000 kms


Check the multipin connector block on the part of the wiring harness that runs from the wiper control switch along the sterring column and under dash for a loose connection. You may have to remove the plastic covers from around steerring column to do this. Also check earth connection located near the fuse block for a poor connection.

Dec 01, 2010 | 1999 Honda Civic

2 Answers

2001 Trans Am WS6 My windshield wipers only work on high and stop in the middle of the windshield or whayever point I turn the switch off. I just replaced the control lever (turn signal stalk) and that...


This sounds like the wiper control module.Most of these are a module attached to the wiper motor but are replaceable seperate from the wiper transmisson.

Oct 27, 2010 | 2001 Pontiac Firebird

1 Answer

After turn on windshield wipers, they will not


There is two place that you can check which would cause this problem. (1) the switch it self and the other is the (2) circuit board on the wiper motor. It's common for the solder on the circuit board where the wire harness clips on the wiper motor to crack and needs to be re soldered. You can buy the replacement at Auto Zone or you can re solder it your self to safe you the $15.00 for the board. If you give it a light tap and the wipers stop, then it's the circuit board. If it keeps working, then it's the switch on the steering column and you can get that at Auto Zone also and they will have the step by step instructions for you to get the hob done with common tools. Good luck and keep me posted.

Jan 07, 2010 | 1992 Pontiac Sunbird

1 Answer

When I start my 2003 buick lesabre the windshield wipers come on by themselves and continue intermittenantly until they stop.


Behind your ignition inside the steering column, there is a plastic piece that screws to the back that has to do with your accessories. its bad or your wiper control stick also located on the steering column is bad.

Jul 10, 2009 | 2003 Buick LeSabre

1 Answer

Windshield wipers don't work


Ok, this is a steering column issue. The wiring needs to be replaced. Shouldn't cost much at all. also, the external switch may have issues as well but, i suggest you re wire your steering column to fix this problem.

Jan 28, 2009 | 1994 Mercury Sable

1 Answer

Windshield wipers


The fuse panel is under the instrument panel to the left of the steering column. Lift the handle to unlatch the panel and pull it down. The windshield wiper/washer system uses a circuit breaker in position #2 in the fuse panel. If your washer is working the circuit breaker is OK.

Jul 18, 2008 | 1991 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...