Question about Cars & Trucks

Open Question

I have a 2000 chevy impala put a new battery in it and still wont start or crank

Advance said it was a bad battery so I replace it and the terminals but wont crank and all lights still work

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 21 Answers

SOURCE: 2000 chevy impala starting problem

i used to work as a GM mechanic for years, and we had quite a few complaints like yours, GM issued a computer reprogram to resolve most issues with starting, i would contact your local dealer and have them check for open campaigns or bulletins for your car if there is one they will do it at no cost to you.

Posted on Nov 10, 2008

Ad
  • 1 Answer

SOURCE: My Chevy Impala 2000, wont start at all...and the

i had a similar problem with my 2000ls i turned the key on left it in the on position for 15 mins then repeated it after the second time i turned the key on and off quickly 3times on the 3rd time i held it in the start position and it cranked over. note let your car run for a while to recharge your battery doing this really does drain it

Posted on Jul 08, 2009

  • 36 Answers

SOURCE: wont start security light stays on

Body Control Module (BCM) on both counts. Find a shop in your town that specializes in electrical systems to test it. Beware, these can be intermittent problems, so make sure they keep it until the car does what you have observed. Expect to spend about $450 for the replacment. Dealers quoted me between $700 and $1,100 for the same repair. By the way, a new BCM will probably only last you about 12 months.

Posted on Aug 14, 2009

  • 1 Answer

SOURCE: Replaced ignition switch 2003 chevy impala and car will not start

After you replace the ignition switch turn the key to start the car and release leave the key were it stops after trying to start wait 10 minutes until security light goes out turn key to full off position then repeat the above procedure two more times for a total of three on the 3rd attempt to start car wait for light to go out then turn key to full off positoion wait 10 seconds then try to start car body control module should learn new pass code and the car should start.
Big john, J@J Automotive

Posted on Mar 02, 2010

  • 1857 Answers

SOURCE: 2000 chevy C2500 wont start. No spark. Replaced

Did you check for codes. It won't matter what you change if your computer failed. You should of payed the diag fee. You would of saved alot of money.

Posted on Mar 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why doesnt my 2000 chevy impala have injection pulse


your anti theft device is activated,you need to lock and unlock your doors a couple times with the key fob,not the key,and then you need to put the key in the ignition and start it,if you dont have your key fob,call your car dealer to get a new one,they are programmed for each car only,you cannot bypass it.

May 30, 2015 | 2000 Chevrolet Impala

1 Answer

Installed new battery on 2006 Galant and it still wont crank the engine. Put Jumpers on and it starts. Whats the problem?


If you're jumping with the jumper neg lead on engine block (like you should) then you have a bad ground lead.
If you are jumpering to the battery terminals then the connection to the battery itself is bad. Clean the battery connector terminals.

Feb 11, 2015 | 2006 Mitsubishi Galant

3 Answers

Why is it that my 2003 impala will crank and turnover but wont start


I sounds like you have a fuel flow problem. Replace the in-line fuel filer located in the fuel line in front of the rear tire. Check out this web site for "how to" replace the in-line fuel filter.
http://www.ehow.com/how_6724057_install-filter-2003-chevy-impala.html

Aug 15, 2014 | 2003 Chevrolet Impala

1 Answer

2002 chevy impala having intermitten starting issues


As with any no start issue, someone will have to figure out if you are dealing with a no spark or no fuel problem to proceed.
If you have to rely on a shop they may have to keep the car for a few days to track down the problem.

Aug 09, 2012 | 2002 Chevrolet Impala

1 Answer

CAR WONT START


Have you checked the ignition? They go bad and you can crank all day with no success also check the selanoid.

Aug 06, 2012 | 2006 Chevrolet Impala

2 Answers

I have a 2000 Chevy impala and I am having serious issues with it starting. The battery is fine, we replaced the starter and put in a new starter relay, still not cranking. We are now leaning towards the...


Does the security light in the dash blink?
Thinking it's a pass code fault(ignition switch)
There is no chip in the key,the computer looks for the proper rotation of the switch,had the same thing happen,
Should be able to start it if you crank the engine for a few seconds,release the starter and DON"T turn the key off,wait 10 minutes,crank it again,should start.
If not do the procedure again(had to do it 3 times on mine)
This is the relearn procedure that also has to be run after the switch is replaced(with a new key also)

May 09, 2011 | 2000 Chevrolet Impala

1 Answer

2002 impala intermitenly wont start


I would clean the battery connecters or possibly change them. How old is the battery? sometimes when battery get old, they have enough juice to crank the motor but not enough to start it..But then again, if it doesn't crank at all sometimes, it could certainly be a bad or loose battery terminals..Start with this since its the simplest and easiest and could very well be your problem. hope this helps

Sep 23, 2009 | 2002 Chevrolet Impala

2 Answers

2000 impala wont crank


If the starter is spinning but not cranking the engine the ring gear is worn out.Need to remove engine and or trans to repair

Jul 15, 2009 | 2004 Chevrolet Impala

2 Answers

My Chevy Impala 2000, wont start at all...and the engine light shows.I dont think its the battery because the radio and headlights still work...But when i put the key in and turn , the car wont even...


See if your security light is flashing if it is leave key in the on position untill light stops flashing then attempt to start you may have to repeat this two or three times

May 05, 2009 | 2000 Chevrolet Impala

3 Answers

2003 Chevy Blazer won't start


have the computer checked out. may need reprogramming and have updates added. also check for loose or corroded connections at the terminals.

Aug 27, 2008 | 2003 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...