Question about 2008 Chevrolet Cobalt

Open Question

Where do I put the transmission fluid in 2009 Chevy cobalt

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75066 Answers

SOURCE: How do I change transmission fluid in 2006 Chevy

jack the car up and remove the trans pan (12 bolts I think), inside you will find the filter replace it, after u finish refill with the exact same amount of fluid (about 3-4 quarts of Dexron 6 ATF) and then recheck hot, don't overfill...

Posted on Jun 13, 2009

SOURCE: Trans-axle fluid leak

checking the transmission fluid involves lifting the vehicle and removing a plug on the transmission, it is quite difficult and messy if you don't have access to a lift, the vehicle has to be level and at operating temperature in park, there is a small plug on the side of the transmission near the passenger axle shaft. remove the plug slowly, i believe it is an 11mm bolt, if fluid drips out, the level is ok, if no fluid comes out, there is a small plastic screw on cap on top of the transmission itself on the driverside near the oil filter cap, add fluid slowly untill fluid starts to drip out of the plug hole, once the fluid starts to drip, insert the plug and tighten, don't overtighten, just snug it up.!!!make sure you use the right fluid, this is important!!! i believe your fluid is dextron 6, double check in your owners manual, the use of any other fluid will cause damage!!! also, do not remove the small plug on the front of the transmission, that is the pressure plug, all the fluid will shoot out with force if that plug is removed!!!

Posted on Jun 20, 2009

  • 2926 Answers

SOURCE: How do you check the transmission fluid level on a

The transmission is sealed. It is intended the fluidis to never need to be checked or changed. The dealer has a probe to check this function.

Posted on Feb 03, 2010

Testimonial: "Thanks for the info, I never would have figured it out."

  • 2 Answers

SOURCE: WHERE DO I PUT TRANSMISSION FLUID ON THE 2006

You put it in the small tube that the transmission dip stick came out of. You'll need a small funnel and the PROPER fluid.

Posted on Aug 20, 2010

hfmiles
  • 1165 Answers

SOURCE: how to you check the transmission fluid in 2005

I believe you have to crawl under the car and check the level thru a sight window in the side of the transmission.

Posted on Dec 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I get the air panel off to check the fluid lines for blockages?


Blow out the sprayer from outside. If it does not clear it get a new nozzle.

Nov 01, 2014 | 2009 Chevrolet Cobalt

1 Answer

Transmission dipstick location on a 2009 Chevy


It doesn't have one. To check the fluid you have to pull a plug from the passenger side of the transmission, by the CV shaft. Start the car and pull the plug. If fluid comes out, it is full. If not then add. The fill is the red cap on the top of the transmission.

Sep 30, 2014 | 2009 Chevrolet Cobalt

1 Answer

Check transmission fluid 2005 chevy cobalt


Cobalt has a front engine front wheel drive layout. The transaxle has a dip stick that can be accessed from by opening the hood. The dip stick has markings on it indicating full/half//low oil level.

Jul 11, 2013 | Cars & Trucks

1 Answer

My transmission on my 2005 Chevy cobalt is acting up I need to know if it's possible to put transmission fluid into the cobalt I have no idea where to put it there is a little On top of the transmissi


if it is a automatic transmission just open the hood and there is a tube other than the oil tube usually the opposing side of the engine between the engine and the fire wall it has a long dip stick just like the oil stick and this fluid level should be checked when engine is running in park,If it is manual transmission it is usually a sealed unit.

Nov 02, 2012 | Cars & Trucks

1 Answer

Where is transmission dipstick Chevy cobalt 2005


according to wiki.answers.com
"Chevy Cobalt has a sealed Automatic Transmission... no dip stick. Probably best to take it in to get service by trans shop if you think it needs changing or re-filling."
Or
"There actually isn't one. It's a sealed system. There is a cap to fill the transmission directly ontop of the transmission. If you need to check the level, lift the car1.gif in the air and there is a 11mm plug on the bottom of the transmission, With the car running (WARNING: THE CAR MUST REMAIN RUNNING WHILE PLUG IS OUT!!!!) take the plug out, the fluid should trickle out of the hole. If no fluid comes out add fluid. AGAIN DONT SHUT THE CAR OFF WHILE IT IS RUNNING OR ELSE FLUID WILL POUR OUT!"

Sep 30, 2012 | 2005 Chevrolet Cobalt

1 Answer

How to check the transmission fluid on 08 chevy colbolt


On the Cobalt the car maker says that the fluid level only needs to be checked when the fluid is drained or when you have an obvious leak.If the fluid were to go low it would slip or you would loose drive.If you put to much fluid could foam and cause fluid loss.I would recommend that you take it to a shop and let them check it since the check plug is under the car.

Feb 13, 2011 | 2008 Chevrolet Cobalt

1 Answer

WHERE DO I PUT TRANSMISSION FLUID ON THE 2006 CHEVY COBALT?


You put it in the small tube that the transmission dip stick came out of. You'll need a small funnel and the PROPER fluid.

Aug 20, 2010 | 2006 Chevrolet Cobalt

1 Answer

Howto change a key cylinder for a chevy cobalt


There is a TSB on this issues if your having ignition lock issues.
Service Information
2009 Chevrolet Cobalt | Cobalt, G5 (VIN A) Service Manual | View All Bulletins | Document ID: 2325129

#09-02-35-005: Ignition Key Difficult to Remove, Ignition Key Binds or Sticks in Cylinder (Replace Ignition Cylinder) - (Aug 10, 2009)

Subject: Ignition Key Difficult to Remove, Ignition Key Binds or Sticks in Cylinder (Replace Ignition Cylinder)

Models: 2008-2009 Cadillac CTS (Built Prior to VIN Breakpoint 90163371)

2005-2009 Chevrolet Cobalt (Built Prior to April 14, 2009)

2006-2009 Chevrolet HHR (Built Prior to April 14, 2009)

2007-2009 Chevrolet Equinox (Built Prior to July 2008)

2005-2006 Pontiac Pursuit (Canada Only)

2006-2009 Pontiac Solstice (Built Prior to April 14, 2009)

2007-2009 Pontiac G5 (Built Prior to April 14, 2009), Torrent (Built Prior to July 2008)

Attention: This bulletin only applies to vehicle equipped with automatic transmission.

Aug 05, 2010 | 2005 Chevrolet Cobalt

4 Answers

Chevy cobalt check engine light is on


there is no way you can check the transmission you must take it to the dealer.that is what i was told

Aug 28, 2008 | 2005 Chevrolet Cobalt

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...