Question about 2000 Toyota Tacoma PreRunner

1 Answer

1998 3.4 toyota tacoma ran one day not the next turns over no start has fuel to fuel rails has spark no start

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 20,706 Answers

Scan it.
plug (USA:"?) any scan tool
crank for 5 seconds,
stop relax key , not off
see scan DTC errors, i bet YES
no RPM scanning? yes, that means CKP is dead.

the ecu can see no spark cause. most

Posted on Jan 02, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: 1998 Toyota seems like its boggin down when starting

I had this problem recently with my 98 camy LE. Just replace or clean the idle air control valve

Posted on Aug 25, 2008

  • 1861 Answers

SOURCE: 99 tacoma

Still need the codes.
Injectors can go "bad" in a couple of different ways; all they are is an electromagneticaly controlled nozzle. When the ECU "fires" the injector, it pulses a ground circuit for 4-8 milliseconds, the electromagnet powers up, the valve at the bottom of the injector opens, and the fuel shoots out, under pressure. The wire can be bad/chafed/corodded/ The electromagnet may be weak. The nozzle may be stuck. Lots of things. But, to put in an injector for a number 4 cylinder misfire (p-0304 code) would be one of the last things that I would do.

Posted on Nov 21, 2008

mrmx2333
  • 56 Answers

SOURCE: 1990 toyota pickup wont start/turns over no spark or fuel

there may be a bad contact problem check the wire running into the fuse box and look at the relay for the efi

Posted on Dec 19, 2008

skotkolr
  • 558 Answers

SOURCE: 2000 toyota tacoma 2.4l wont start when cold

clogged injectors you need to put cleaner in the fuel to help get dirt and grit out of them some times (every 3 months).
I am assuming you are saying it will turn over but not fire and run when cold?

Posted on Mar 21, 2009

  • 125 Answers

SOURCE: Can't find the fuel filter on 2004 toyota tacoma 4 cyl 4x4

look under the truck

Posted on May 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 f250 5.4l would not start. changed feul pump and filter still would not start. 20 mni later started. was cleaning engine while running 10 15 min later died wont start.


Check fuel pressure at the injector rail. Could be your fuel pump relay is cutting out. If fuel pressure is good, check for sparks at the plug wires. Read the link below for more info.
Do It Yourself Diagnosis and Repair

Jul 26, 2017 | Cars & Trucks

1 Answer

1995 toyota tacoma 2.4 liter, cranks but no start, got fuel, got air, no spark. changed cap, rotor, and coil still no spark.


did you get the plug wires on correctly. check any electrical connections you may have undone. check for codes. it may be coincidental that you lost spark and a sensor may have gone bad.

Sep 25, 2015 | Toyota Cars & Trucks

1 Answer

Toyota Tacoma fuel problem


Check the following:
- Listen to the fuel pump noise under the fuel tank.
- Starter signal.
- EFI relay, under the hood fuse and relay box.
- Fuel pump operation and pressure.
- Regulating valve.
- Circuit Opening Relay (COR) under the dash.
- Check for open in harness and connector between circuit opening relay and fuel pump, and fuel pump and body ground

83744154-13d8-40aa-bba8-aac743062e3f.png
98828e43-1df3-476c-94fa-036164d23c8e.png

2e76aaa2-2dec-411f-a493-b4d0f142f0f8.png
Hope that works. Thank you for visiting Fixya.

Mar 18, 2014 | 1998 Toyota Tacoma

1 Answer

I was backing out of my drive, shifted to 1st then it bogged down , sputtered and died. couldn't get it to start again. bought a dist. cap and rotor and it started .backing out once again, it did the


you ran out of fuel , now the fun is getting all that air out.
cranking works, have a charger handy,( for a life time)
so if it dont start, check spark if spark dead on all cyl fix that(ask)
if spark is good, try test fuel, oops that works but dies.
so the system if full of air, next time put gas in car. keep it that way.
it dont cost more, only driving more,costs more..... dig?
if the injectors are injecting fuel are they (ask)
then do a fuel sample test. crack the rail plug (eyeprotection no in any garage) and get some fuel in a glass jar,. see water floating in bubbles. bingo water.
watch scotty here.... link.

http://www.fixkick.com/nostart.html

Jan 12, 2014 | 1995 Toyota Tacoma

1 Answer

1998 toyota has fuel to fuel rails has spark turns over wont start


Check the cylinder compression first, they should be more than 95 psi, if low check the timing and the valves. If normal, plug in a scan tool to see any code present.

Jan 02, 2014 | 2000 Toyota Tacoma PreRunner

1 Answer

O2 lincoln ls check engine light & fuel gauge went to empty the next day it wouldny start replaced fuel pump & fuel gauge ran fine drove about 40 miles the next day started it up check engine light...


You have two pumps,I guess you know that ,if you already did one. Did you check fuel pressure at the rail and check out the electronic pressure regulator? What codes are coming up and do they stay set?

Feb 05, 2010 | 2002 Lincoln LS

1 Answer

2000 tacoma cranks but wont catch, has good battery. Is it the electronic fuel inecton, or starter coil?


is it getting fuel to the "common fuel rail"?do you have any spark? if neither then either you have lost 12 volts to the ECU or you have a grounding problem there,grounding is very important

Sep 13, 2009 | 2000 Toyota Tacoma PreRunner

1 Answer

Where are the spark plugs on my 2006 Tacoma?


check up under the fuel rail itself and you will see these things with little wires on them inbetween the injecters and that is where the spark plugs are

Feb 21, 2009 | 2006 Toyota Tacoma

1 Answer

99 tacoma


Still need the codes.
Injectors can go "bad" in a couple of different ways; all they are is an electromagneticaly controlled nozzle. When the ECU "fires" the injector, it pulses a ground circuit for 4-8 milliseconds, the electromagnet powers up, the valve at the bottom of the injector opens, and the fuel shoots out, under pressure. The wire can be bad/chafed/corodded/ The electromagnet may be weak. The nozzle may be stuck. Lots of things. But, to put in an injector for a number 4 cylinder misfire (p-0304 code) would be one of the last things that I would do.

Nov 17, 2008 | 2001 Toyota Tacoma

Not finding what you are looking for?
2000 Toyota Tacoma PreRunner Logo

Related Topics:

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...