Question about 2002 Chrysler PT Cruiser

Open Question

2002 pt cruiser horn and led light on radio will not work.fuse and relay ok

Horn and LED will only work sometimes.I have power going to fuse and relay

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 82 Answers

SOURCE: power windows

First off does the window switch on the passenger side? if it does then you may just need the drivers side window switch. The front and the back windows work seperate from each other.

Posted on Jan 03, 2009

Ad
localwonder
  • 6784 Answers

SOURCE: Change the thermostat on 2002 Chrysler PT Cruiser

Hi, i have put together a step by step guide that will help you with this replacement job. Make sure the vehicle is in a cool state before starting this job.


* Drain some coolant into a clean container until the coolant level is below the thermostat housing.
* Remove the upper radiator hose connection from the thermostat housing.
* Loosen the housing bolts and remove the housing.
* Remove the gasket and scrape it carefully from the surface of the housing and the mounting surface on the engine. If the gasket remains on either of the surfaces, there will probably bea coolant leak after reassembly. Some engines use a rubber O-ring to seal a thermostat housing.
* Compare the size of the thermostat to the old one. They are of different sizes, types, and temperature ratings.
* The temperature rating is stamped on the sensing bulb on the bottom of the thermostat. The temperature bulb faces the block.
* When replacing a thermostat, be sure that the thermostat fits into the groove in the block or outlet housing. If the thermostat is installed upside down, the engine will overheat.
* Install the gasket.
* Reinstall the thermostat housing. Refill the system and run the engine or pressure test to check for leaks.
* When the engine has reached operating temperature make sure the thermostat opens.
* You should be able to see coolant circulating within the radiator.
* Another way of checking thermostat operation is to feel the top of the radiator hose or use a thermometer or multimeter with a temperature probe to confirm that the coolant is warming up.
* If the engine is overheating, but the top hose is still cool to the touch, the thermostat is stuck closed and must be replaced.

NOTE
When a paper gasket is used and the recess is in the thermostat housing, it is a good practice to position the thermostat into the recess and glue the gasket to hold it in place. If it falls out of its groove during installation, the outlet housing can be cracked or a coolant leak will result. Before tightening the water outlet housing, try to rock it back and forth to be sure it is flush. Housings are often cracked during this step.


9c06de2.jpg

Posted on Apr 30, 2009

Remontti-J
  • 32 Answers

SOURCE: Need 2002 PT Cruiser Touring Ed. Fuse Box Diagram

There are 2 possibilities. It is on Power distribution Center (mine was there)
or Fuse Block
Here are the photos:


http://www.ptcruiser.fi/ptgalleria/albums/userpics/Power_distripution_center.jpg

http://www.ptcruiser.fi/ptgalleria/albums/userpics/fuse_block.jpg

If you like to fix your fog lights, you must replace malfunction switch. It is a typically PT-Cruiser problem.

Posted on Jun 05, 2009

Remontti-J
  • 32 Answers

SOURCE: PT Cruiser radio

If you have the right code for radio, you just be waiting (acc on) so long time that you can enter the code.

If you turn acc "off" the counter is starts at beginning in next time when you turn acc "on".

I had once same problem, so I took the radio from car, connected to 12V power supply over night. Next morning I enter code and radio was ok.

Posted on Jun 10, 2009

  • 60 Answers

SOURCE: my 2002 pt cruiser lost power steering suddenly

check to see if the serpantine belt is still there. It sounds like like it broke. this belt runs all of the accesories on the vehicle including the water pump. So if this happened it probably starting running hot too

Posted on Jun 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2009 pt cruiser battery goes dead overnite


I had this problem as well on a earlier year PT Cruiser, i tried everything i could think of, removing fuses one by one while watching the current draw on the battery led me to the radio, after pulling the fuse for the radio the current draw dropped down to about 150mA, i don't know what was wrong with the radio but i replaced it and the problem went away. The IOD fuse supplies power to the ECU and all of the electronic control modules in the car, how much current draw are you seeing with the IOD fuse in, and how much are you seeing with it out? Its not uncommon to see a couple hundred mA in standby to everything, especially if you have the factory security system with immobilizer, chipped keys. But you may have to pull one fuse at a time to find the culprit if you are seeing a much higher draw, should be less than 1 amp at the worst.

May 04, 2017 | Cars & Trucks

1 Answer

2002 pt cruiser had and tail lights will not work al other lights work


Could be a defective multifunction switch but 15A FUSES 2 and 8, 25A FUSE 1, 20A FUSE 15, 10A FUSE 20, and 10A FUSE 19 in the fuse block should be checked as well as 15A FUSES 12, 16/17, and 19 in the power distribution center. Also check the headlamp relay.

Mar 21, 2017 | 2002 Chrysler PT Cruiser

2 Answers

Pt cruiser 2002 Alarm red light solid on


Your alarm is ]n valet mode. If your led is pod mounted there is a button in back of it. If your led is hard mounted in the dash, you'll have a hidden switch usually mounted on the kick panel or under dash. Either way, turn on ur ignition push the button turn off the key, your led should go out. Hope that helps.

Dec 28, 2016 | Cars & Trucks

1 Answer

My 2002 pt cruiser horn and stereo won't work fuse good.. back Windows don't go down.. what can I do to fix this


sounds like relay problems or bad connections in fuse box,check relays,then check fuse behind radio,check for voltage at doors.
25618664-gpgzti2ec3hbjv0hrsl1kugs-3-0.jpg

Mar 30, 2015 | 2002 Chrysler PT Cruiser

1 Answer

Where is the headlight relay located on a 2002 PT Cruiser?


Did you check the fuse box inside the cabin ? The book says the relay is in the fuse block but does not give a description.
Keep in mind the headlight relay only affects the headlights. The other lights you mentioned are on different fuses and not the headlight fuses.

44ffe3f1-c5a7-4c89-8c71-605f6a21bb18.jpg

Jan 28, 2014 | 2002 Chrysler PT Cruiser

1 Answer

No power for fan - no ac, heat, defroster, etc. Could it be a fuse?


yes it could be a fuse or relay, check under the hood for the a/c relay, try swapping it with the horn relay just to see if thats fixes it, if it does just buy a new relay

Jun 20, 2010 | 2002 Chrysler PT Cruiser

1 Answer

Below the odometer it indicates no fuse,


The IOD fuse is missing or burnt out. IOD is "ignition off draw" which serves as the dome lights, radio memory, locks and other things powered with the key off.

Jul 30, 2009 | 2002 Chrysler PT Cruiser

1 Answer

Radio and interior lights will not work


check engine compartment relay box.

Jul 05, 2009 | 2002 Chrysler PT Cruiser

1 Answer

How will not blow on 2006 pt cruiser


1st check fuse. Then see if power is coming to horn. A simple power checker can be found at most auto parts store. It may also have a horn relay. Look up your wiring at cargrus. If you still have problems contact me back.

May 25, 2009 | 2006 Chrysler PT Cruiser

1 Answer

I have a 2002 chrysler pt cruiser and my radio wont turn on and i already checked the fuse and relays and they all work the weird thing about it is that the radio its seld the lights from it do work...


Try to take the radio out and look at the fuse in the rear of the radio. You have 2 fuse locations one at your left knee and the other under the hood near the battery. Look in the owners manual for this fuse type, because some fuses work the same thing. Another thing could be that you have an anti-theft radio and it will not work with out you entering a code. The code is on the radio it-self or you have to contact the dealer with the vin number.......runjoe

Mar 02, 2009 | 2002 Chrysler PT Cruiser

Not finding what you are looking for?
2002 Chrysler PT Cruiser Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8548 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...