Question about Mitsubishi Lancer

Open Question

Transmission solenoid The transmision is on Protection mode

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whay does code 31, line solenoid open means?


the solinoid stays open,might be stuck,or cloged,have the transmision flushed and replace the hydrolick filter inside the transmision

Dec 22, 2012 | 2005 Mitsubishi Lancer

2 Answers

Transmision automatica se queda sin fuerza


Revise los niveles de liquido en transmission, si estan bien o recientemente ha hecho un cambio de fluidos y filtro, podria tratarse de un problema con el "convertidor de torque" o valvulas de solenoide defectuosas, estas ultimas se encuentran internamente dentro de la transmission.

Jul 04, 2012 | 2005 Nissan Xterra

1 Answer

Where is the shift solenoid located on a 4t65E transmision


All of the shift solenoids are located on the driver side behind the front wheel under the side cover on the transmission. It is not a easy job!

Mar 10, 2012 | 2000 Buick Regal

1 Answer

Transmision just stoped working in drive reverse still goes in gear graet but no drive


CHECK TRANSMISSION FLUID LEVEL SOUND LOW.TRANSMISSION FLUID + FILTER SHOULD BE CHANGED AT 30000 MILES..IF ALL IS GOOD.TRANSMISSION SHIFT VALVE ADJUSTMENT CORRECT.HAVE CAR SCANNED FOR TRANSMISSION FAULT CODES FOR FAULTY SHIFT SOLENOID OR PRESSURE SOLENOID AND TRANSMISSION RANGE SENSOR.

May 20, 2010 | 2002 Dodge Intrepid

1 Answer

Check engine and transmision work bad


I had the same issue. Dodges tend to have some faulty transmissions. Usually it's not too bad. I had to replace my transmission valve body. Usually a sensor or solenoid go bad. Turn the key on/off three times and it will display a code. Google the code or take it to a shop.

Mar 27, 2010 | 2004 Dodge Durango

3 Answers

How do I change the transmission solenoid on my 2001 Ford Taurus?


the solenoid pack is located on the valve body inside the transmission, u must remove the trans pan to access it for replacement

Feb 05, 2010 | 2001 Ford Taurus

3 Answers

Transmision wont go in R 2 4 but 1&3 is fine


You need to have the transmission repaired. There is a faulty Solenoid inside the transmission.

Sep 04, 2009 | Hyundai Motor 1999 Tiburon

1 Answer

1998 honda accord transmission goes into limp mode


the vehicle may have a electrical problem and or mechanical problem in the trans....id try replaceing the solenoids and then the entire transmision and torque converter.

Mar 21, 2009 | 1998 Honda Accord

1 Answer

What is a transmission solenoid


como chequear los solenoides de la transmision, como probarlos y ver por que la transmision no cambia de velocidad quedandose en alta

Jul 30, 2008 | 1993 Dodge Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...