Question about Cars & Trucks

Open Question

My Utilitech oscillating heater just turned off and even after letting it set and unplugging and then plugging it back in it won't turn on. Can this be fixed?

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heat does not come out of defroster


An oscillator? :vibration, motion like a pendulum, pulsation, fluctuation, rotation...yeah, I can imagine Nissan calling a door that swings back and forth to direct air, an oscillator. Hope someone is not pulling your leg, though, or we've both been suckered ! Don't know what to tell you, except to find your nearest oscillator outlet supplier. In the meantime, check the controls to the various doors on the heater case. Are they vacuum controlled, cable controls, or electrical motor controlled? Usually all of one type. You may be able to see the offending part, a disconnected hose or cable, or the stem of an inner door that has broken or not moving the door. The oscillator might be hidden deep in the bowels there-be careful. Good luck, norman.

Feb 25, 2013 | 2001 Nissan Quest

1 Answer

The blinker in my 2002 Chevy Malibu won't stop making the blinker noise...even when the blinker isn't turned on. Driving me insane!


the blinker control under and to the right of the steering column under the knee panel is out its a cheep part you remove the knee panel an turn on the turn signals listen for the ticking you find that part unplug it and replace it yours is bad worn contacts this is a cheap part easy to fix don't let people rip you off good day

Feb 15, 2013 | 2002 Chevrolet Malibu

1 Answer

Heater does not turn on


If you have a gas hot water heater that won't stay on, check to see if pilot light is out and relight it if it is. If you have an electric hot water heater that won't stay on, then you should have an electrician check the wiring.
if you need an auto tool you can click here: chinasinoy.com

Nov 05, 2012 | 1990 Toyota Corolla

1 Answer

Headlight on rx 300 lexus won't work even after changeing the bulb


have a tester handy.unplug the light and then turn on the headlights.with tester on 12 volts test plug to see if you have 12 volts. if not the plug is properly corroded or shorted .

Nov 24, 2011 | 1999 Lexus RX 300

1 Answer

2005 mustang is overheating and shutting off. Turned the key and it won't stay on. I noticed that the fan might not be turning on. How do I troubleshoot? I put water in the radiator and didn't...


It could be a leak, check your radiator for any leaks, also check upper and lower radiator hoses, water pump, etc. But you said the fan doesn't kick on even when it's reading "hot". So I would look into that more. route the wires and locate the plug, make sure it's plugged in, or reseat the cable by unplugging, and replugging it back in. You could also unplug the negative cable on the battery terminal for a few seconds in attempt to reset the ECU (computer).

Oct 21, 2011 | 2005 Ford Mustang

1 Answer

My turn signal won't lit when activate and my brake light also wont also but is illuminate. The Top Brake light do light up when but only when the lights are turned on manual setting if they are on...


possible multifunction switch gone bad for turn signal problem. do headlihgts come on in a dark setting on automatic or not? if they don't come on when it is dark then most likely bad light sensor in top of dash or maybe unplugged if recent dash work has been done.

Jul 13, 2011 | 2002 Mercury Mountaineer

3 Answers

The heater/ac fan only works on speed settings 4 & 5


you might check your switch sounds like to me that your two lower speed sides of the switch maybe burnwed out.

Dec 19, 2009 | 2002 Chevrolet TrailBlazer

1 Answer

Seat heater won't turn off


Is there a fuse under there
or see if you can unplug it and plug it back in
see if that works

Feb 06, 2009 | 2003 Mercury Mountaineer

1 Answer

Heat will not turn off


should turn off with the key,someone has hotwired it and now the control switch has packed in,rewire the motor through the ignition switch

Dec 30, 2008 | 1993 Pontiac Bonneville

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...