- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Feb 5, 2011 - Uploaded by RickyTomatoes
[FIXED] Audi A4 RPM Idle Problem .... whole lot more and sometime i can even feel like the engine is just gonna die. sometimes it does it some other times it does ... Our cars shouldidle at 900. ... AUDI A3 1.6 IDLE PROBLEM!
RedditSep 3, 2014 - When getting into first gear, I bring the revs up to around 2000 RPM right ... Being able to get going without any throttle is fairly dependent on car size and ...Thats how I have a 300,000 kay clutch still on my audi with no slippage. ... Clutches ought to last well over 100,000 miles if they are not abused, and ...
www.cargurus.com > Questions > Chrysler > Town & Country
CarGurusDec 28, 2012 - motor revving - Sometimes the motor revves up and the light go dim on... If in park it takes alot of rev. to make the pop sound. ... 1996 chrysler cirrus change a bad fuel injector and now the engine revs ... Used Nissan Quest".
Feb 20, 2009 - TYC 800107P Nissan Altima Replacement Cabin Air Filter ... when i go to park the car and throw it in park it goes up to like about .... If I leave it in drive when the idling starts to hesitate it tends to make the car jump forward.
Faulty idle air control valve.After you replace it you will need to reset the computer by disconnecting the ground cable on the battery for 30 seconds then re-install it and start it up it should run fine.
It sounds like it may need more than just an adjustment, the mixture screw is on the side down reasonably low close to the base plate, there are lots of different carbs used but the idle screw is usually right by the linkage point.