Question about 1997 Ford Thunderbird LX

1 Answer

Where is the location for obd II system for 1997 ford thunderbird

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 3 Answers

The OBD conector is located under the globe compartment, in the passenger side. The ECM is located in the pillar, beneath the trim cover... you must remove the cover and some of the plastic parts that protect it to access the ECM.

Posted on Feb 05, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: ignition control module location for 1997 ford thunderbird?

1997 Ford Thunderbird Transmission problem
When driving normally transmission surges like it is not in gear. Had sensors replaced, nitural safety switch, and still acts up.

Posted on Dec 18, 2008

greg_margo
  • 1959 Answers

SOURCE: check engine light 97 ford explorer. obd-II po141

Looked up your OBD II code for your Explorer and got the following: Bank 1 Sensor 1
The possible causes are listed below per Chilton: *same result for all engines available on your vehicle

Trouble Code: P0141 (4.0L V6 VIN E Auto)
HO2S-11 Heater Circuit (Bank 1, Sensor 1) Print this code dataprint_icon_codes.gif
Number of Trips to Set Code: 2
OBD II Monitor Type: CCM Details
Indicators: MIL Details
Trouble Code Conditions:
During testing the heated oxygen sensor (HO2S) heaters are checked for open and short circuits and excessive current draw. The test fails when the current draw exceeds a calibrated limit or an open or short circuit is detected.
Possible Causes:

  • Vacuum hose disconnected on exhaust gas recirculation (EGR) system module (ESM) applications* Short to VPWR in the harness or HO2S
  • Water in the harness connector
  • Open VPWR circuit
  • Open GND circuit
  • Low battery voltage
  • Corrosion or incorrec
The sensors themselves appear in the illustration linked to below. The illustration is for the Ford Ranger but indications are that other models have similar locations. Hope this helps with your problem. Best of luck!
Greg

http://www.chiltonlibrary.com/content/images/8968/images/89684g23.pdf

Posted on May 17, 2009

  • 12650 Answers

SOURCE: Failed emissions What fuse for OBD port on 2006 Ford Fusion?

check the out put from the computer to the obd ll port if good need to check the wiring harness ,connections and pin contacts from computer to obd ll port connections possible short,frayed or broken wire

Posted on Feb 14, 2010

  • 1796 Answers

SOURCE: searching for obd 2 port

Hi!!

The OBD Diagnostic Link Connector is located in front seating area, passenger side, under dash, above kick panel, mounted rear of glove compartment.

Don't forget to rate this post, Good Luck!!

Posted on Apr 27, 2010

cobra777
  • 80 Answers

SOURCE: location of low pressure port of a/c system on a

Here is a system overview. The low side port is #5 in the picture. Hopw it helps ya.. Cobra
be966ed.gif

Item Part Number Description 1 19972 A/C Compressor to Condenser Discharge Line 2 19E762 A/C Charge Port Valve(High Side) 3 19D594 A/C Pressure Cut-Off Switch 4 19D742 Evaporator to Compressor Suction Line 5 19E762 A/C Charge Port Valve(Low Side) 6 19E561 A/C Cycling Switch 7 19860 A/C Evaporator Core 8 19C836 Suction Accumulator/Drier 9 19835 Condenser to Evaporator Tube 10 19D734 A/C Manifold and Tube 11 19703 A/C Compressor 12 19712 A/C Condenser Core

Posted on Jun 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuel pump relay on a 1997 ford thunderbird lx 4.8 l


Usually they are in a powerbox under the hood. Do a Websearch with a title of "1997 Ford Thunderbird fuel pump relay location". The hits you get will lead you to good diagrams and some actual photos.

Sep 18, 2014 | 1997 Ford Thunderbird LX

1 Answer

Where is the obd port on 97 ford thunderbird?


It should be on the left side of the steering column under the das.

Apr 30, 2014 | 1997 Ford Thunderbird LX

1 Answer

Service Engine Soon light is on


Run the codes.......you need an OBD II scanner. Probably O2 sensor or EGR valve stuck. don-ohio

Sep 09, 2011 | 1997 Ford Thunderbird LX

1 Answer

How do you turn up the idol


This vehicle is equipped with On Board Diagnostics II (OBD II).Engine idle speed is controlled by the Powertrain Control Module (PCM) and the Idle Air Control (IAC) valve. The throttle body does not allow for adjustments and must not be cleaned or damage to the special "sludge tolerant" coating in the throttle body bore will be harmed. If a problem is encountered with the engine idle speed, the OBD II system must be thoroughly inspected before a proper repair can be performed.

May 26, 2011 | 1995 Ford Thunderbird

1 Answer

Where is the OBD connector on a 1988 XR7 Cougar


On the 1988 XR7 the Ford diagnostic connector is located under the hood and just ahead of the right front strut tower. It's not the familiar looking OBD-II 16 pin connector but is the Ford style two part connector consisting of one single wire with a female spade type connector and another odd shaped connector with 5 or 6 female spade connectors in it. The typical auto parts store OBD-II reader won't work to read codes on this one, instead you need someone with an older tester to see what is happening and the data available from the system is quite limited also. Hope this helps and good luck!

Jul 28, 2010 | 1997 Mercury Cougar XR7

2 Answers

Searching for obd 2 port


Hi!!

The OBD Diagnostic Link Connector is located in front seating area, passenger side, under dash, above kick panel, mounted rear of glove compartment.

Don't forget to rate this post, Good Luck!!

Apr 27, 2010 | 1997 Ford Thunderbird LX

1 Answer

Check engine light 97 ford explorer. obd-II po141 bank 1 sensor 2. need to locate sensor


Looked up your OBD II code for your Explorer and got the following: Bank 1 Sensor 1
The possible causes are listed below per Chilton: *same result for all engines available on your vehicle

Trouble Code: P0141 (4.0L V6 VIN E Auto)
HO2S-11 Heater Circuit (Bank 1, Sensor 1) Print this code dataprint_icon_codes.gif
Number of Trips to Set Code: 2
OBD II Monitor Type: CCM Details
Indicators: MIL Details
Trouble Code Conditions:
During testing the heated oxygen sensor (HO2S) heaters are checked for open and short circuits and excessive current draw. The test fails when the current draw exceeds a calibrated limit or an open or short circuit is detected.
Possible Causes:
  • Vacuum hose disconnected on exhaust gas recirculation (EGR) system module (ESM) applications* Short to VPWR in the harness or HO2S
  • Water in the harness connector
  • Open VPWR circuit
  • Open GND circuit
  • Low battery voltage
  • Corrosion or incorrec
The sensors themselves appear in the illustration linked to below. The illustration is for the Ford Ranger but indications are that other models have similar locations. Hope this helps with your problem. Best of luck!
Greg

http://www.chiltonlibrary.com/content/images/8968/images/89684g23.pdf

May 17, 2009 | 1997 Ford Explorer AWD

2 Answers

Ignition control module location for 1997 ford thunderbird?


1997 Ford Thunderbird Transmission problem
When driving normally transmission surges like it is not in gear. Had sensors replaced, nitural safety switch, and still acts up.

Dec 12, 2008 | 1997 Ford Thunderbird LX

Not finding what you are looking for?
1997 Ford Thunderbird LX Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...