Question about Cars & Trucks

1 Answer

Nissan frontier problems

The truck has been sitting for a few years. The engine runs when it is being choked out buy a rag, but stalls when the rag is removed??? I don't get it.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 302 Answers

Too much air...not enuf fuel???

Posted on Jan 02, 2014


6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Pattods
  • 116 Answers

SOURCE: 1998 nissan frontier 4x4

Well since the lights are controlled by the OBD (on board diagnostics), you'll have to reset it. You may be able to do this by simply disconnecting the battery for a few hours. However, a lot of newer vehicles have electronically locked radios which require the manual to be able to be re-enabled.

I'd check out the radio before disconnecting the battery.

The only other ways are to physically disconnect the lights in the dash or get someone with an OBD reader to clear the codes.

Posted on Sep 13, 2008

  • 1 Answer

SOURCE: choking and stalling while running and then will not start

Might be dirty fuel filter change the fuel filter see how it runs.

Posted on Nov 29, 2008

  • 1 Answer

SOURCE: 2004 nissan frontier crew cab radio

the plastic around the gear shifter will pop up with a good pull, then turn it side ways to get over the shifter, then there are 2 screws the hold the bezel down around the radio and air vents, then just pull from the air vents it will pop off to reveil the screws to the radio

Posted on Feb 27, 2009

  • 3640 Answers

SOURCE: engine repair code P0325

po325--ignition system or missfire.

Posted on Sep 16, 2009

  • 1 Answer

SOURCE: 2005 frintier crew cab hesitate

Sounds like your ECM relay. They are one recall on some 2005 Frontier trucks.

Posted on Mar 13, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need info in the code po301 for a nissan 2005 frontier with a 2.5 engine


P0301 is a misfire on cylinder #1, usually either a bad plug, wire or coil pack.

Feb 08, 2016 | 2005 Nissan Frontier

1 Answer

When engine warms up it start to surge


Engine stalls cold or RPM fluctuates at idle up and down or dies near idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control. If the above cleaning doesn't cure your issues you need to have the computer controlled automatic idle speed control system diagnosed and repaired by a dealer or electronic engine control repair shop.

Nov 05, 2012 | 1998 Nissan Frontier

1 Answer

Nissan frontier codes p1444,p0120,p1320


Depending on the year up to 04, crank sensor goes bad and it's buit internally with disturbuter whole disturbuter would have to be replaced, very common

Jul 08, 2012 | 2000 Nissan Frontier

1 Answer

What's your problem?00 nissan frontier barely idles


i had the same problems about a year ago i took it to my buddies shop hook up the computer and it coded the distributor had gone bad it usually runs about a 400-500 dollars to get it replaced.

Nov 22, 2011 | 2000 Nissan Frontier

1 Answer

My 2005 nissan frontier overheats while sitting still what is wrong with it?


Sounds like coolant isn't circulating. While moving engine making pump circulate coolant and fresh air hitting front of radiator. At idle or a stop, engine not making pump run as fast and there is no fresh air hiiting radiator ( especially if fan isn't working properly) Check out water pump and cooling fan.

May 20, 2010 | 2005 Nissan Frontier

3 Answers

2005 frintier crew cab hesitate


Sounds like your ECM relay. They are one recall on some 2005 Frontier trucks.

Mar 23, 2009 | 2005 Nissan Frontier

1 Answer

2002 Frontier pickup fueling problem


If its a recall there should be no cost, fit the gauge at the fuel supply line at the fuel rail.

Mar 01, 2017 | 2002 Nissan Xterra

3 Answers

Every time it rains, and my truck sits in the rain for an extended period of time, when I go to drive somewhere, a few minutes down the road the truck starts to stutter and shake, or **** either when I'm...


I had a 93 Nissan that had a similar intermittent problem running when wet, humid or after sitting. Usually it would start fine and run well most of the time, but stutter, shake or die. It sometimes had low power and got terrible highway mileage even though it was a 4 cyl. 5 spd. When it was dry and not humid, it ran like it was new. I thought it was the ignition wires and changed them with no results. 2 Nissan dealers said everything was fine--it never acted up when they had it. I found a web site that had Nissan technical service bulletins and found one that described the problem--there's a connector in the wiring that needs replacing. It's wrapped in black tape and is a crimp connection. Dealers told me that couldn't be the problem (it was still under warranty), so I took the truck and bulletin to a non-Nissan mechanic. Within an hour he found the connection, replaced it, and the truck ran perfect after that. Sorry but I don't have the technical service bulletin anymore. I may have found it under a different year . .Good luck.

Aug 22, 2008 | 2003 Nissan Frontier Crew Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...