Question about 2006 Hyundai Tucson

Open Question

Security system reset

After armed stage alarm goes off after 10 min

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do you turn off an alarm for a 2005 Saturn Ion


Disarming an Armed System/Silencing an Alarm
If system arming has been requested by the keyless entry transmitter, it must be disarmed.
Important: Using the power door unlock switch or manually unlocking the doors does not disable the CTD armed mode. Also, disconnecting the battery or pulling fuses does not disable the armed mode, since the BCM stores the CTD mode status in memory.
?€¢
To disarm the CTD system in arm pending mode, SECURITY indicator flashing and doors open, perform 1 of the following:


-
Press the UNLOCK button on the keyless entry transmitter.


-
Insert a valid key into the ignition and start the vehicle.


?€¢
To disarm the CTD system in the armed mode:


-
Press the UNLOCK button on the keyless entry transmitter.


-
Insert a valid key into the ignition and start the vehicle.


?€¢
To disarm the CTD system when activated, alarming mode.


-
Press the UNLOCK button on the keyless entry transmitter.


-
Insert a valid key into the ignition and start the vehicle.

Jun 24, 2016 | 2005 Saturn ION

1 Answer

My 96 Tahoe won't start but it has power and the alarm goes off every time I try and start it


You have probably activated the anti theft system. Try this to reset it:
Leave the key on for about 10 min. then try to start. Or reset the computer by leaving the key on for 10 min and try to start the vehicle. Do this process 3 times then it should reset and you will be able to start the engine.

Jul 21, 2014 | Cars & Trucks

1 Answer

Flashing lights on security system for 1993 ford escort wagon


usualy there is a switch on the driver and passener side, try disarming by unlocking drivers door with the key to disarm the factory alarm, or the passenger door. this should turn off the alarm if it is not aftermarket. the factory alarm will arm any time the door is locked by key or power door lock. good luck

Jan 14, 2014 | 1993 Ford Escort 4 Door

1 Answer

2006 GMC Envoy car alarm goes off when I open doors or start engine. This happened after installing new battery. It had the same problem when I bought it in 2008. I forget how it was solved.


U need to reset security system (pass lock II). Turn key to on right b4 cranking but don't start and let security light flash for about 10-12 mins until it stops and then turn key back off, repeat procedure two more times don't actually turn key far enough to start during first two 10-12 min cycles, third cycle though after flashing stops turn the rest of the way forward for it to start. This should then reset security and solve problem sometimes only takes two cycles to reset. Good luck, hope this is helpful & solves problem.

Nov 23, 2013 | 2002 GMC Envoy

1 Answer

Replaced battery in my 1993 jeep grandcherokee limited now security system seems to cut fuel off seconds after engin fires


Here's some info as it sound like the theft deterrent is armed.

---
Reset Procedure

NOTE: This information applies to a Vehicle Theft Security System (VTSS) that was armed when the battery was disconnected and reconnected.

When the armed VTSS senses that the battery has been disconnected and reconnected, it enters its power-up mode. In the power-up mode the alarm system remains armed following a battery failure or disconnect. If the VTSS was armed prior to a battery disconnect or failure, the system will have to be actively or passively disarmed following a battery reconnection.

The power-up mode will also apply if the battery goes dead while the system is armed and battery jump-starting is attempted. The engine no-run feature will prevent the engine from starting until the alarm system has been actively or passively disarmed.

Passive disarming of the Vehicle Theft Security System (VTSS) occurs when the vehicle is unlocked using the key to unlock either front door or the liftgate. Active disarming of the VTSS occurs when the vehicle is unlocked by depressing the Unlock button of the Remote Keyless Entry (RKE) transmitter.

Once the alarm has been activated (horn sounding, lights flashing, and the engine no-run feature), either disarming method will deactivate the alarm.

Depressing the Panic button (if equipped) on the RKE transmitter will also disarm the VTSS, but the horn will sound and the lights will flash for about three minutes as part of the Panic feature. The horn and lights can be stopped by pressing any of the RKE transmitter's buttons or driving the vehicle above 15 mph.

Feb 11, 2013 | Dodge Stratus Cars & Trucks

2 Answers

My 1999 tahoe has a security problem. The light comes on and goes off it will start.If the light flashes it fails to start. can you help


The pass lock is beginning to fail.You can try reporogramming it following this procedure. If it still continues to happen the pass lock/ignition tumbler may need replaced.
PASSKEY LOCKOUT RESET ALL GM CARS 1999 AND UP
1) Put the key in the ignition and turn to the "ON" position. Leave it that way for 10 minutes. After 10 minutes turn the key and take it out. Repeat this process (2) more times (3 times, 30 minutes total) This should reset the PASSKEY system to recognize your key
.

Sep 23, 2010 | 1999 Chevrolet Tahoe

1 Answer

Cylinder head torque settings for 1989 Volkswagen Golf?


hi to tighten you have to do it in 4 stages as follows
1st stage 40nm leave 5 mins 2nd stage 60nm leave 5 mins 3rd stage 90 degrees leave 10 mins 4th stage 90 degrees then you are done i will try put order on here i hope this works as follows
10 4 2 6 8 front of engine back of engine 7 5 1 3 9

starting with 1 so it goes like this

10 4 2 6 8
7 5 1 3 9

hope thats some help to you

Aug 09, 2010 | 1989 Volkswagen Golf

2 Answers

How do i reset the security system on my 2003 chevy impala


Are you reffering to the alarm or the pass lock system that put the theft light on.....If its the alarm the put the key in the door and unlock it. If its the pass lock system put the key in the ignition and turn it on and try to start the vehicle. After it shuts itself off leave the key on for ten min until the theft light stops flashing the turn key off and try to start it again. This may take a few times....

Jul 24, 2009 | 2003 Chevrolet Impala

2 Answers

1992 Toyota Cressida Alarm - son's car.


NOT SURE IF THIS WORKS ON THIS MODEL (KINDA OLD FOR ME) HOWEVER TRY UNLOCKING PASSENGER SIDE DOOR TWICE TO RESET SYSTEM LET ME KNOW AND PLEASE RATE THIS

Apr 19, 2009 | 1992 Toyota Cressida

1 Answer

How can I reset my Factory Alarm on my Jeep it wont run


Alarm Module Reset Procedure
NOTE: This information applies to a Vehicle Theft Security System (VTSS) that was armed when the battery was disconnected and reconnected.
When the armed VTSS senses that the battery has been disconnected and reconnected, it enters its power-up mode. In the power-up mode the alarm system remains armed following a battery failure or disconnect. If the VTSS was armed prior to a battery disconnect or failure, the system will have to be actively or passively disarmed following a battery reconnection.
The power-up mode will also apply if the battery goes dead while the system is armed and battery jump-starting is attempted. The engine no-run feature will prevent the engine from starting until the alarm system has been actively or passively disarmed.
Passive disarming of the Vehicle Theft Security System (VTSS) occurs when the vehicle is unlocked using the key to unlock either front door or the lift gate. Active disarming of the VTSS occurs when the vehicle is unlocked by depressing the Unlock button of the Remote Keyless Entry (RKE) transmitter.
Once the alarm has been activated (horn sounding, lights flashing, and the engine no-run feature), either disarming method will deactivate the alarm.
Depressing the Panic button (if equipped) on the RKE transmitter will also disarm the VTSS, but the horn will sound and the lights will flash for about three minutes as part of the Panic feature. The horn and lights can be stopped by pressing any of the RKE transmitter's buttons or driving the vehicle above 15 mph.

Jan 28, 2009 | 1999 Jeep Grand Cherokee

Not finding what you are looking for?
2006 Hyundai Tucson Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...