Question about 2004 Buick Rendezvous

Open Question

Dashboard cluster r & r, temp. gauge, tach, speedometer & gas gauge don't work

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 321 Answers

SOURCE: Intermittent Speedometer Operation

Your vehicle has the 4T60E transmission,and there is a speed sensor mounted on the transmission case that the vehicle's computer uses to compute vehicle speed,and relay it to the dash mounted speedometer.The best way to diagnose this problem is to first,hook up a scan tool that is available at automotive repair shops,and scan the vehicle for trouble codes first.Your vehicle probably has a stored trouble code along the lines of a Vehicle Speed Sensor (VSS).After pulling codes,go to the data stream on the scan tool and look at the VSS signal that the computer is seeing,and when the speedo acts up,and stops working,look to see if the computer is seeing,a speed signal.If the vehicle computer is seeing a speed signal,then it's probably the speedo in the dash gone bad.If the vehicle computer is not seeing a speed signal,then it is likely a problem with the speed sensor mounted on the transmission,or the wires right before it.So,to diagnose really requires a scan tool,with a data stream,or you could just have the speed sensor replaced,and hope that fixes it.The speed sensor is located on the passenger side of the transmission,only accessible from under the car,but where the pass side axle actually goes into the transmission,the sensor is directly above that point,and retained in the case with a 10 mm bolt.It has two wires going to it.Good luck.

Posted on Aug 06, 2008

  • 141 Answers

SOURCE: none of the instruments in the cluster work (Gas gauge, speedomot

It is possible that the connector came off the back of the circuit board behind the speedometer. Do the lights work IN the speedometer and gauges? Could also be that the ground wire loosened up under the dash, usually on the drivers side. Just some suggestions that I thought might help. Best wishes to you.

Posted on Jan 19, 2009

  • 2 Answers

SOURCE: New Century - DashBoard Problems

My 1999 Buick Regal was doing the same sort of thing. Randomly the gauges would go crazy and then the engine would shut down. I ended up replacing the ignition switch. Not exactly where the key goes in, but the switch box behind it on the inside of the column. I had to take off the steering wheel, air bag and everything, but it hasn't had any problems like that since.
Paul

Posted on Apr 11, 2009

  • 31 Answers

SOURCE: DASHBOARD PROBLEM WITH GAUGES NOT WORKING. 2000 BUICK LASABRE

your gauges need to be replaced it sounds like you have a bad mother board on it.

Posted on Jan 30, 2010

cardenderek
  • 783 Answers

SOURCE: none of my dash board gauges work right or do not

something with your cars ecu ( computer) or possibly your battery. Make sure it is grounded and hooked up properly.

Posted on Mar 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Instrument cluster does not work.


Best practice is to leave pinpoint testing of the instrument cluster & (Delicate) P/C board to an expert .....

May 28, 2015 | 2001 Acura MDX

1 Answer

5425 The dash isn't working. Such as tach,gas gauge,temp and speedometer.


Three possibilities:
  1. Burned out fuse;
  2. Bad chassis ground at instrument cluster (most likely);
  3. Bad or disconnected computer module.

Jul 25, 2014 | Cars & Trucks

1 Answer

All my gauges quit on my 2003 silverado the dash lights still work but none of the gauges move


Hi, this is a pretty common problem on these Silverado instrument clusters. We can definitely help you out with that. Click here to learn more about these Silverado instrument cluster problems: Dr Speedometer Instrument Cluster Repair Speedometer Repair Guage...

Jan 09, 2014 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

Instrument cluster


Do an online search for speedometer repair places. You can get yours rebuilt for a fraction of the price of new or junkyard

Jun 18, 2017 | 1994 Oldsmobile Bravada

1 Answer

Tranmission and instrument cluster


The speed sensor on your trans sends a signal to the electronics telling it when to shift, this will be where you fault is.

Mar 05, 2012 | 2001 GMC Yukon XL

2 Answers

The tach light works, the speedometer & gas,temp lights don't.Are there bulbs? Or does the circut board need repair?


I belive this year still uses bulbs, remove the cluster and in the rear you will see the bulbs, note there are a few so remove the one you think it is and shine a light into the hole and you will see if thats the correct bulb by seeing what lights up, good day.

Jul 26, 2011 | 2001 Oldsmobile Silhouette

1 Answer

Tach & speedo not working


Had same problem with my 2000 dodge stratus 2.4 liter and transmission would not shift out of 1st gear. Solution was ignition fuse under the hood was blown, one side of fuse working, replaced 10 am fuse everything works, tach, speedometer, gas gauge and transmission started back to shifting.

May 27, 2010 | 1996 Oldsmobile Achieva

1 Answer

I have an 1983 olds cutlass and the guage cluster is not working properly the oil temp and gas is not readind but the tach speedometer and battery is what could be the problem


Worn out gauges would be the first guess. The next would be the oil pressure sensor....

The gas gauge could have problems from a bad float in the gas tank or the wires to the sending unit are badly deteriorated.

Dec 01, 2009 | 1983 Oldsmobile Cutlass Supreme

1 Answer

Gauges not working


Ur instrument cluster is most probably the culprit. Smack the dashboard to see if it helps. If it does, bingo, most probably a bad weld on the cluster circuit board. Happens alot on VW's.

Oct 21, 2008 | 1996 Volkswagen Jetta

Not finding what you are looking for?
2004 Buick Rendezvous Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...