Question about Cars & Trucks

1 Answer

Fog light adjustment - Cars & Trucks

Posted by Anonymous on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

I have a 2012 doge ram 1500, I am lifting it 2 inches in the front, I need to adjust the fog lamps, can they be adjusted, if so where is the adjustment knob?
Thanks

Posted on Mar 02, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

02 pt cruiser- fog lights aimed too low


Remove the plastic surround, use a flat blade screwdriver to pry off as usually just clipped in! Then there will be 2 or 4 screws securing the light and a single adjuster screw that pivots the light up and down, adjust the pivoting screw till desired light position is reached!

Dec 06, 2014 | Cars & Trucks

1 Answer

How do i adjust fog lights on a 94 ranger?


the main beam of the light should be slightly down from centre of the light. They should be located as close as possible to the road as their purpose is to shine under the fog cloud and reduce refraction of the light through the fog. Any emergency button on the road will be seen through the fog

Aug 08, 2014 | Ford Ranger Cars & Trucks

1 Answer

Need to adjust fog lights 2006 volvo s60


The fog lights do not really have an adjustment on that model.
The housing screws into the bumper cover and is a fixed position. You could shim it with longer screws and some flat washers butit will not give you lots of adjustment.

Jan 16, 2014 | Cars & Trucks

2 Answers

How can I replace the left front fog light unit from a toyota prius from 2009. I cann't find a maintenance manual for this model and year.


Its all attached by clips and screws.Nothing much special.But its all about the procedure.Dont forget the mark the position , location of the screws you remove, so while refitting you don't face any problemTo replace fog light bulb or to replace replace complete fog light unit, click this link below:--- http://technoanswers.blogspot.com/2011/07/how-to-replace-left-front-fog-light.html ---------- This will help.Thanks.Helpmech.

Jul 09, 2011 | Toyota Prius Cars & Trucks

2 Answers

How do you change the headlight bulb on 1996 olds delta 88? I cannot get to the bulb assembly.



REMOVAL & INSTALLATION

See Figures 1, 2, 3 and 4
  1. Disconnect the negative battery cable.
  2. Remove the fog lamp-to-bumper assembly retaining screws. Be careful not to disturb the adjusting screw.



0900c152800b1fa2.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 1: Unfasten the 2 Torx® fog light retaining screws (1), making sure not to disturb the adjusting screw (2)
  1. Squeeze the bulb and socket assembly retaining clip prongs inward, and pull the bulb and socket from the rear of the fog lamp.



0900c152800b1fa3.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 2: Squeeze the bulb and socket retaining clip prongs inward ...


0900c152800b1fa4.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 3: ... then pull the bulb from the rear of the fog lamp
  1. Unplug the fog lamp electrical connector.



0900c152800b1fa5.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 4: Unfasten the fog lamp electrical connector
  1. Install the assembly, retaining bolts and connect the negative battery cable.


AIMING

  1. Park the car on a level surface, at least 25 ft. (7.6m) from a wall that is perpendicular to the ground surface. Make sure there is no excess weight in the trunk, unless you normally travel with that amount of weight in the car. Bounce the car a few times to settle the suspension.
  2. Measure and record the distance from the ground to the center of each fog light lens.
  3. Turn the fog lights on and adjust so the hot-spots (lit area of most concentrated intensity) are 4 in. (10cm) below the height of the lenses. The ADJUSTING screw is located at the top right corner of the fog light.

Jan 25, 2010 | 1996 Oldsmobile 88

1 Answer

Need a fuse box diagram to wire in fog lights


Fog lamps are installed on the front bumper. The switch is located to the left of the steering column on the dash panel. The fog lamps are turned off by the circuit relay when the high beam driving lamps are turned on. The circuit relay is located on the right front wheelhouse panel near the blower motor.

Good luck, and remember rated this help.
Removal & InstallationFog Lamp Element
See Figure 1
558610d.gif
Fig. 1: Exploded view of a fog lamp assembly

  1. Remove the lamp stone shields, the four bezel attaching screws, and the bezel.
  2. Remove the reflector assembly from the lamp body.
  3. Remove the bulb holder from the assembly. Remove the element from the bulb.

DO NOT handle elements with your bare hands, always handle with a clean cloth. Oil from your hands will cause the element to fail.
  1. Installation is the reverse of removal.

Fog Lamp Switch
The fog lamp switch is removed and installed by simply prying the switch from the instrument panel and unplugging the electrical connector.
FOGLAMP BEAM ADJUSTMENT

  1. Position the vehicle on a level surface, facing a wall approximately 25 feet away. Remove the lamp stone shields and loosen the adjustment nuts.
  2. Turn the fog lamps ON and adjust as follows:
    1. Distance between the light beam centers should be equal to the distance between the lamp assemblies on the bumper.
    2. Height of the light beams on the wall should be 4 inches less than the center of the lamp assemblies when mounted on the bumper.
  3. Install all previously removed items after turning OFF the fog lamps.

1995 Cherokee Chassis Schematic
8e08df0.gif

www.autozone.com

Aug 11, 2009 | 1995 Jeep Cherokee

1 Answer

1999 FORD EXPLORER FOG LIGHTS


Depending on the type of bulb you may need to rotate the bulb one way or the other or you may need to adjust the mounting bracket. good luck and remember to rate all the solutions you get, thanx.

Oct 30, 2008 | 1999 Ford Explorer

1 Answer

How to adjust front fog lights


Park the car in front of a garage door about 15 feet away, adjust the light so they point slightly down and a little to the right, this si all there is to it, the bolts that hold the adjustment are at the rear of the light behind the bumper..

Oct 05, 2008 | 1998 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

439 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...