Question about 2006 Jeep Liberty

Open Question

Wires in shifter for overdrive button broke when lifting shifter as you instructed

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there a way to permanently disable the overdrive on my 1994 Ford f150


You should have an overdrive off button at the end of your gear shift lever. just switch it off and tape over the button. Or the wires from the button connect at the bottom of the shifter. The button is on or off, figure out which disengages the overdrive and either leave the circuit open or closed.

May 23, 2016 | Ford Cars & Trucks

1 Answer

Seems like overdrive button doesn't work


What model mark lots of time when the overdrive button ia in the shifter there broken wire because the shifter goes up and down just last week i change a shifter arm on a 2003 silverado diesel

Mar 24, 2015 | Cars & Trucks

1 Answer

I have a 2001 ford focus, my wife spilt water on the gear shifter and now the overdrive light will not go off even if the button is pushed


First of all...water and electrical connections don't mix well. Since the overdrive button is located on the left side of the shifter, and your wife spilled water on the shifter, the water has likely caused an electrical short.

With the ignition key off, try using compressed air to blow out any possible water or moisture around the shifer button and at the base of the shifter itself. Since the overdrive button has electrical connections inside the shifter, the water has probably caused a short. (I repeat...water and electrical connections don't mix well) If this doesn't cure the problem, you may need to disassemble the shifter mechanism and check for water or moisture. The electrical connections or wiring may be wet inside the shifter, which is likely causing the problem. Blow the areas out with compressed air and make sure everything is clean and dry. Then reassemble the shifter mechanism and reheck to see if this cures the problem.

Good Luck!

May 17, 2012 | 2001 Ford Focus

1 Answer

My overdrive button is broken off , there are three wires stiicking out and it is in overdrive all of the time . is ther a way to dissingage the overdrive


There's just a pin that holds the shifter arm in place. You can remove the pin from the top under the rubber boot and pick up a used shifter arm from just about any scrap or recycling yard. I've already sold 5 or 6 this year for 25 dollars. It takes about 5 minutes, and comes with a good OD button. To be quite honest you could put a clip on two of the exposed wires in the same amount of time it'd take to replace it.

Jan 28, 2011 | 1994 Ford Bronco

1 Answer

Won't shift into overdrive when button pushed


check gearbox oil level remove gear lever switch check feed to switch with meter or test lamp no feed check fuse if ok put 2 wires together car in 4th gear ignition on should hear click from overdrive solenoied if ok fit new switch if not check wires from lever to gearbox for breaks think you might find problem here if not check inhibitor switch and then solenoid hope this helps you

Dec 09, 2009 | 1992 Volvo 240

1 Answer

Removed auto shifter and overdrive wires broke and its stays in 3rd gear all the time is there a way to make iit rewire it to stay in 4th ?


see where the wiers from overdrive go and fix there a switch. all it is a switch. or just connect the wiers together to turn the overdrive off

Jun 02, 2009 | 1993 Mitsubishi Diamante

1 Answer

How to remove the shift knob on 1998 toyota rav4


If its a manual shift, just turn it counter clockwise untill it comes off. If its an automatic you have to remove the 2 screws that hold it on, then lift straight up. The overdrive button wires will need to be cut then spliced back together when you put the shifter back together.

Feb 22, 2009 | 1996 Toyota RAV4

2 Answers

Overdrive wont engage and the O/D light blinks


if the overdrive light is blinking then there is a problem with the TCM transmission control module. if you have access to a scanner, pull the codes, that will lead you on the path to what is wrong. if you dont you will have to take it for service.

Dec 02, 2008 | 1999 Kia Sephia

3 Answers

Plastic pieces on shifter handle


That part is only serviced with the sift arm. Source: 20 years at a Ford Dealer as a Technician.

Oct 13, 2008 | 1999 Ford Expedition

Not finding what you are looking for?
2006 Jeep Liberty Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...