Question about 2007 Toyota Prius

Open Question

How to remove themostat housing - 2007 Toyota Prius

Posted by Anonymous on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Themostat location

follow the top radiator hose from the radiator to the engine where it stops on the engine is the thermostat housing remove that housing and there will lay your thermostat

Aug 09, 2010 | 2004 Jeep Liberty

1 Answer

Where is the themostat on 2000 cadillac deville

hi. On a 4.9L follow the upper radiator back to the engine. This should be the thermostat housing. The thermostat should be inside.
On a 4.6L the thermostate is in the housing which is near the water pump drivebelts "on the coolant crossover housing". If this is not clean I recommend you buy the Haynes for your DeVille. See page 3-4, illustration 3.14.


Jul 29, 2010 | 2000 Cadillac DeVille

1 Answer

How to replace the thermostat?

well first you have to find it it the easyiest way isto follow the top raditor hose as it goes towards the engine it will go from hose to a metal housing called the thermostat housing remove the 2 bolts or more depending on the eng remove the housing remove themostat insert new one in the same way facing make sure you dont flip the themo stat around just look at how it comes out and but the new one in the same make sure to clean around the housing for old gasket and junk

May 05, 2010 | 1996 Pontiac Grand Am

1 Answer

Need to know to replace themostat in 2004

Drain the radiator, follow the top radiator hose to the engine, it is connected to the thermostat housing. Loosen and remove the two bolts, lift the housing and remove thermostat, make sure the new thermostat goes back in the exact same way, tighten bolts, make sure pepcock is closed on radiator, refill radiator, start engine, run heater on full blast, add coolant as needed.

Dec 22, 2009 | Chevrolet TrailBlazer Cars & Trucks

1 Answer

How do i change the themostat on a 1998 olds silouhette

the thermostat is under the throttle body
1 remove the air inlet tube from the throttle body to air box
2 drain the coolant
3 remove the throotle body
4 the top bolt is easy remove 13mm bolt from thermostat housing
5 the bottom bolt not so easy remove 3/4 of the way out bottom hole on housing is slotted
6 remove thermostat housing
7 replace thermostat and reassemble
hope this helps

Nov 11, 2009 | 1998 Oldsmobile Silhouette

1 Answer

How do i change thermostadt on jeep cherokee

  1. Follow your upper raidator hose untill you find the themostat housing which is the ending point for the hose.
  2. Remove the two bolts that hold the housing (you may have to loosen the belt to get to one of the bolts).
  3. Remove housing and replace themostat and gasket ( remove any excess gasket that may have been left over ).
  1. Open draincock on the radiator to drain the coolant from your Jeep Grand Cherokee. This draincock is located on the lower right side facing the rear of your Cherokee.
  2. Use a sealable container and reuse the coolant if it is relatively new and clean.
  3. Follow the upper radiator hose to the point where it meets the thermostat housing. The thermosat is located inside the housing.
  4. Use a clamp tool or vise-grip pliers to loosen the clamp holding the hose to the housing. Work the end of the radiator hose free of the thermostat housing.
  5. Remove two bolts holding on the thermostat housing cover. Pull off the cover.
  6. Take note of the position of the old thermostat. Remove and install the new thermostat in exactly the same position.
  7. Scrape off residue of the old thermostat gasket from the inside of the thermostat housing cover using a razor blade. Avoid getting any debris inside the thermostat housing.
  8. Install the new gasket. Reattach the thermostat housing cover and radiator hose. Start your Jeep and run the heater on high. Allow the engine to warm up. Check for leaks.

Nov 08, 2009 | 1996 Jeep Grand Cherokee

1 Answer

It is over heating and i can't find the temperatre gauge under the hood...

first of all check the radiator for leak or blockage. make sure the coolant is fresh. follow th eupper radiator hosr to the emgine block. there should be 3 bolts attached the themostat housing. take the themostat out and put it with hot water, maks sure the opens. the temperture sending unit should be directly under the themostat. msot likely the themostat is cause or the problem. unless the temperture gage is not reading correctly.

Jun 09, 2009 | 1998 Mercury Mystique

1 Answer

Change themostat on 92 safari

Follow your Upper Radiator Hose to the Motor. It will attach to a Bell Housing. Remove this Bellhousing and the Hose. The Thermostat is Underneath the Bell Housing. Please Rate My Response! Thanks!

Jan 31, 2009 | 1992 GMC Safari

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides