Question about 1998 Ford Ranger SuperCab

Open Question

Left outside door handle replacement - ford ranger xlt 6- 3.0

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76649 Answers

SOURCE: starter stays engaged

The starter relay on the fender is the most common cause of this condition. ,It is on passenger side feder in the engine compartment, it is round and the positive cable of the battery goes to it,

Posted on Nov 13, 2008

Ad
  • 1 Answer

SOURCE: ford explorer 1997 xlt, the inside door handle does not work

I had the same problem and I finally found the solution after taking the panels from the inside of the door. Ford makes these vehicles with plastic clips to hold the bar that releases the latch and after so much repetitive usage of them they break. so most likely you will need to go to a ford dealership to get these clips which are stupidly priced at $3.00 a piece. All you need to do is take out the old pieces and put in the new and they'll most likely last you for another 10 yrs. but that's not a guaranteed fix from Ford.

Posted on May 22, 2009

centralvalle
  • 386 Answers

SOURCE: how do i take the door panel off a 94 ford ranger

make sure you remove all door panel screws, you can use a mehanics rag to go behind door handle to remove horse shoe clip that holds door handle if you don't have the proper door tools , it is much easier with the correct tools you can buy they are cheap at autozone or kragens, sears... disconnect any door swtiches like door locks , power mirriors if equipped, then just pull up and out on door panel noting the plastic retainers on back of door panels... please rate help, thanks...

Posted on Aug 06, 2009

  • 104 Answers

SOURCE: how to install replacement door handles for 98 ford ranger pickup

remove interior door panel(need special tool to pop plastic clips holding panel to door)with panel off remove plastic film,with window up you should be able to see two 10m nuts-bolts to remove-also have to pop lever off that goes down to door latch

Posted on Sep 19, 2009

peterrance19
  • 399 Answers

SOURCE: 2006 Ford Ranger XLT: 6

hi your codes show downstream o2 sensor oxygen sensor evapsystem o2 heater random misfire u need to check these

Posted on Nov 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fix door handle Ford Ranger outside drivers


One can be purchased from rockauto or another store and replaced relatively easily.

Oct 10, 2017 | Ford Cars & Trucks

1 Answer

2003 Ford Ranger door latch


Pull the arm from the handle

Jul 14, 2012 | Ford Cars & Trucks

1 Answer

Exterior door handle is broken on 1996 ford ranger xlt, already got the door panel removed..whats next?


You disconnect the lever linkage, it pulls out of the hole after turning the plastic retainer 90 degrees. Then, remove the 2 10mm nuts from the lever... and reverse the procedure to install the new lever/handle.

Mar 06, 2010 | 1996 Ford Ranger SuperCab

1 Answer

Want to stop the buzzing sound when drivers door


you can't unless you job a hole in the little speaker don't cut the wires because you'll have a real headace

Feb 12, 2010 | 1996 Ford Ranger SuperCab

2 Answers

Are there a high and a low pressure fuel pump on the 1987 ford ranger xlt 2.9 liter v-6?


Yes (low pressure) one sit on the inner frame rail on the driver side under the truck by drivers door.High pressure is in the gas tank, if you are going to replace fuel pump, don't forget fuel filter.

Dec 23, 2009 | 1987 Ford Ranger

1 Answer

Rear passenger door will not open, safety lock is on can not open from out side of door handle its a 2004 ford expedition


more then likly the linkage came off to the outside door handle. will be hard to get in the door panle with the door close, but once your in there reach in and unlash door latch, then you can replace linkage and clip.

Nov 04, 2009 | 2007 Ford Expedition EL XLT

1 Answer

How do i remove the outside right door handle on a 2001 ford escape xlt


remove inside door panel remove rod clips unbolt door handle replace

Oct 10, 2009 | 2001 Ford Escape

1 Answer

How do i take the door panel off a 94 ford ranger xlt


make sure you remove all door panel screws, you can use a mehanics rag to go behind door handle to remove horse shoe clip that holds door handle if you don't have the proper door tools , it is much easier with the correct tools you can buy they are cheap at autozone or kragens, sears... disconnect any door swtiches like door locks , power mirriors if equipped, then just pull up and out on door panel noting the plastic retainers on back of door panels... please rate help, thanks...

Aug 05, 2009 | 1994 Ford Ranger Supercab

1 Answer

Ford explorer 1997 xlt, the inside door handle does not work


I had the same problem and I finally found the solution after taking the panels from the inside of the door. Ford makes these vehicles with plastic clips to hold the bar that releases the latch and after so much repetitive usage of them they break. so most likely you will need to go to a ford dealership to get these clips which are stupidly priced at $3.00 a piece. All you need to do is take out the old pieces and put in the new and they'll most likely last you for another 10 yrs. but that's not a guaranteed fix from Ford.

Mar 31, 2009 | 1997 Ford Explorer AWD

1 Answer

Door handle on 1998 Ford Ranger


Remove the door panel and on the inside of the door is a clip or a couple of nuts you'll need to remove. The door handle will fall out.

Jun 14, 2008 | 1998 Ford Ranger SuperCab

Not finding what you are looking for?
1998 Ford Ranger SuperCab Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...