Question about 2000 Mazda MPV

Open Question

Rough idling idles rough in very cold weather but starts up and accelerates fine sets the check engine light on pulls up to many codes

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ticodude
  • 53 Answers

SOURCE: #5 cylinder misfire

I have a corolla and had #4 cylinder misfire also diagnosed at autozone. After changing the spark plugs, problem persisted, along with the same error code, so they recommended changing the spark plug wires, and that is what fixed it. I would have changed the rotor cap too, but was low on dough. Glad that was not the problem.

Posted on Dec 29, 2008

  • 1 Answer

SOURCE: hesitation during acceleration

could be the type of plug you are using.I was told only to use ngk plugs.I recently put bosch plugs in my mazda 3 and the check engine light came on and it started missfiring.

Posted on May 03, 2009

  • 78 Answers

SOURCE: 2003 Mazda MPV ES that idles very rough when warm

that means could be vacuum leak

Posted on Jan 10, 2010

  • 2 Answers

SOURCE: For 2003 Mazda Protege ES model 2.0L 4cyl engine;

Check the air inlet boot going from the air filter to the intake for rips or holes. If rips exist, this would allow air to bypass the filter and mass air flow sensor and will lead to a check engine light appearing. The code would read "too lean, bank 1." If this problem is allowed to continue for long periods of time, the EGR ports will have to be cleaned out and maybe even the intake.

Posted on Apr 03, 2010

  • 1 Answer

SOURCE: My 2001 Tribute has a very rough idle on cold

Replace the gaskets on the intake manifold. My tribute was doing the same thing. Replace all spark plugs at the same time since the manifold is already off. They found small amounts of oil in my first 2 valves and plugs, but other 4 were dry. My car idles great and runs great now and it was a cold morning today!!! Also go ahead and replace the idle control valve if you like. I had to replace this first in the car with idle problems. Charge for replacing gaskets and plugs and cleaning it up in the cylinders.... $250.00 and it was well worth it! I have a side mechanic and do not go to dealers or other shops in town.

Posted on Dec 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Check engine light flashing check engine soon smell of gas and not running smouth


Check engine light flashing means there is a bad misfire , it flashes to tell you your damaging your catalytic converter . You need to have it check , you don't won't to have to replace the catalytic converter . Can cost up to $1,000.00 . Flashing Check Engine Light CarMD

Feb 03, 2016 | 2004 Cadillac Deville

1 Answer

Rough idle/ not accelerating/coolant leak


Rough Running Engine - James on Engines #2 - Bell Performance

https://www.bellperformance.com/blog/rough-running-engine
Apr 21, 2015 - When diagnosing an engine with a rough idle, there are certain things that must be ... If the problem does not reoccur, the codes will be erased by the computer. ... when accelerating the vehicle, which causes a higher fuel demand. .... it was water in gas...added added Gas LineAntifreeze/Water Remover.

Mar 17, 2017 | 2000 Ford Focus

1 Answer

My ford windstar 2003 hesitates during cold weather or wet conditions. But good during idle. Some time shows blinking engine light.


The flashing and rough running is to to a misfire or misfires cause by arcing due to moisture on ignition components. Eventually these misfires can lead to other problems such as damage catalytic converter. Start by identifying which cylinder(s) is/are misfiring. The arching can be reproduced with a spray bottle filled with soapy water. Spray the ignition components (wires, coils, distributor cap...)and look for the vehicle to idle rough. Replace any faulty component.

Feb 20, 2013 | 2003 Ford Windstar

1 Answer

Rough idle in cold weather


Is there a check engine light on?

Nov 29, 2012 | 2005 Subaru Forester 2.5

1 Answer

Stumbling Idle


possibly ajusting itsself. any severe weather/pressure changes in your area? and if so does your cars cpu compensate for this (thinks its at a different elevation etc then resets its idle proper after a certian time? I have heard of this but not sure if VW uses it) perhaps ask the service tech.

Dec 13, 2009 | 2003 Volkswagen Passat

1 Answer

Idle 1993 suzuki sidekick


replace the o2 censor,located in exhaust header pipe

Mar 14, 2009 | 1993 Suzuki Sidekick

3 Answers

2001 v6 escape rough idle when cold


To update my earlier repair on the 2001 6 cyl Escape: When cold, and when the ignition was turned over but no accelerator pressure given, the rough idle finally returned the P0303 code again when the check engine light came on indicating that it wasn't caused by the plugs or the coil. FYI, I had replaced the intake manifold gaskets during the original repair and just prior to that I had replaced the fuel filter which was very dirty (I cut it open to see).

The repair manual referred to fuel injectors as a possible problem. I have run three tanks of fuel using different injector cleaning products and am very pleased with the results. Cold starts are much smoother and I am unable to coax out the P0303 code or any other code.

My opinion, change the fuel filter, use a fuel injector cleaner for a couple of tanks, change the plugs if the problem still exists. The coils were not the problem on my vehicle.

Jan 17, 2009 | 2001 Ford Escape

1 Answer

Engine runs rough after about ten minutes /idles really low


Just trowing some suggestions out there, but, I would check the idle air control valve (solenoid) or the throttle position sensor. If they check out then my last guess would be the map sensor or the vaccuum to the map sensor. Hope I was able to help. Best wishes.

Jan 16, 2009 | 1991 Plymouth Laser

3 Answers

Engine will not idle and run when starting in cold weather


Have a mechanic take a look at your throttle position sensor and engine idle sensor. Make him manually adjust them as opposed to just putting in new ones. It may require that you have to have a higher idle than normal. Your underlying cause is going to be that I am sure you have a lot of miles on your engine.

Nov 21, 2008 | 2000 Mercury Mountaineer

Not finding what you are looking for?
2000 Mazda MPV Logo

Related Topics:

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...