Question about 1994 Toyota Camry

Open Question

Left window doesnt work but door unlocks but wont lock by switch

Lower half of rear defroster also doesn't work

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76691 Answers

SOURCE: Single power door lock does not work

If it doesn't work from master switch then the door lock motor actuator will need to be replaced, this requires pulling the door panel.

Posted on Sep 20, 2008

Ad
  • 1861 Answers

SOURCE: 98 4Runner rear window no longer operates

Open the rear hatch. Pull off the inner trim panel. Look to see if there is a little box with a bunch of wires connected to it. It may be at the lower edge, driver side. Turn the key on. Test for 12 volts at the solid BLUE wire (there is only 1 solid blue wire) that is connected to the box. Is there power? If not, check the 30 amp POWER fuse. If there IS power, this box may be bad. This is the power window relay for the rear hatch. The wiper/washer and the rear window motor power all come out of this box.
BUT:
Check for power & get back to me before you buy a relay box, there are a few other tests I could share with you before we pronounce the relay box bad...

Posted on Sep 24, 2008

  • 1861 Answers

SOURCE: Drivers side rear door lock inoperative

You need to replace the electric solenoid/actuator for the door lock. The door panel pulls off very easily.

Posted on Oct 25, 2008

stevenhurc
  • 450 Answers

SOURCE: Camry 1996 automatic power lock doen't work, but windows work.

if you can here relays when unlocking/locking check for power at door lock actuators inside doors, if you have power on lock/unlock and good earth from connector actuators are faulty.
if no power on test light when operating check output from central door lock module while operating, none coming out of module then it might need replacing.
check 30Amp power fuse for main relay under bonnet (which goes to pin 8 white/blue on module)and 10Amp gauge fuse in cab(pin 1 blue/red on module),pin 15 is also power when relay is on(red/blue) with test light, and module/ actuators.
check outputs from module pin 3 & 4
blue/red
blue/black
that go to door locks

Posted on Jul 20, 2009

  • 1 Answer

SOURCE: front doors wont lock or unlock

having same problem.... driver's side door

Posted on Feb 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why wont windows and lock work? could it be the front ecu?


Check inside of door where wiring comes thru for broken wires ,ECU doesn't control windows or door locks. You didn't state what model vehicle you own. But opening and closing door on drivers side causes broken wires on numerous vehicles over the years, most makes and models. Split boot and check all wires inside for breakage.

May 29, 2014 | Mitsubishi Galant Cars & Trucks

1 Answer

Buick 2002 LaSabre Custom all windows do not go up and down, door lock/unlock switch drivers side does not work(passenger & rear doors lock/unlock door switches work, trunk release button does n


coulb be the control switch on your panel you can take the door panel off and check for loose connections and try to test for continuity. if you dont know how take it to a shop and have them diagnose the electrical. im quite sure it the switch that burnt out

Oct 24, 2012 | 2002 Buick LeSabre

1 Answer

2006 escalade the left side of the driver switches dont work, ie left side front or back windows wont role up or down and the unlock doesnt work. The lock side of the button works and the right side...


has the vehicle been in an accident around the drivers door A pillar? Sounds like there are some wiring issues inside of the harness or connector that goes from the body to the door.

Aug 22, 2017 | 2006 Cadillac Escalade

1 Answer

Cant open rear doors from the inside; cruise control doesnt work


after cking the child lock, try locking and unlocking the manual locks to see if you can hear any movement inside the doors. if all else fails, you have to remove the door panels.. starting from the aft lower corner, (careful not to tear the plastic moisture sheeting, just peel it back), the door panels are normally held in by plastic plugs and screws under the armrest, etc. once inside the door cavity, ck the linkages for wear or any signs of them being disconnected. try all the lock mechanisms again to pinpoint the cause, its good practice to clear all the drain holes at the lower part of the cavity once you're in there.

Jun 02, 2009 | 1996 Audi A4

3 Answers

Hi i have a land rover freelander 00.back door wont open or tailgate windoe wont go down,the rest of the doors work. help


try a hard restart, if that doesnt work then you need a new rear window motor. for the hard restart all you have to do is disconnect the battery cables and touch the positive and negative together for about 8 seconds. if that fails then a new motor it is.

Mar 03, 2009 | 1999 Land Rover Discovery

1 Answer

Rear side windows


This may be just a case of inadvertently hitting the window lock out n th driver door window switch by mistake. Check that first. Here's some background on window operation

Principles of Operation
The driver power window regulator motor is controlled directly by the master window/door lock/unlock switch (and its integrated "auto down" module). Power is supplied to the power window relay and the master window/door lock/unlock switch, and the passenger power window switch when the SEC/timer module grounds the coil side of the power window relay. The SEC/timer module will ground this relay when the ignition is in the ON position and will remain energized for approximately 15 minutes or until the driver or passenger door is opened.
The driver power window regulator motor is a reversible motor that is operated by applying power and ground to the motor leads to lower the window, and then reversing polarity on those leads to raise the window.
The passenger power window regulator motor is controlled directly by the passenger power window switch and can also be controlled by the master window/door lock/unlock switch. Power is supplied to the power window relay and the master window/door lock/unlock switch, and the passenger power window switch when the SEC/timer module grounds the coil side of the power window relay. The SEC/timer module will ground this relay when the ignition is in the ON position and will remain energized for approximately 15 minutes or until the driver or passenger door is opened.
The passenger power window regulator motor is a reversible motor, which is operated by applying power and ground to the motor leads to lower the window, and then reversing polarity on those leads to raise the window.
The power rear quarter glass is also directly controlled by the master window/door lock/unlock switch. The power rear quarter glass power latches also utilize reversible motors. The power rear quarter glass power latches are operated by applying power and ground to the motor leads to open the window, and then reversing polarity on those same leads to close the window.
Symptom Chart Condition Possible Sources Action
  • All windows are inoperative
  • BJB Fuse:
    • F20.
  • Circuit.
  • Power window relay.
  • Front door power window switch.
  • GO to Pinpoint Test A .
  • Single power window is inoperative
  • Front door power window switch.
  • Front door power window regulator.
  • Circuit.
  • Driver door power window switch.
  • GO to Pinpoint Test B .
  • Vent power window is inoperative — quarter window glass power latch
  • Circuit.
  • Quarter window glass switch.
  • Quarter window glass power latch.
  • GO to Pinpoint Test C .
  • The one touch down feature is inoperative
  • Master window regulator and door lock switch.
  • INSTALL a new master window/door lock/unlock switch. REFER to Switch—Master Window Door Lock/Unlock .
  • The back window will not defrost
  • CJB Fuses:
    • F30 (10A).
    • F32 (20A).
    • F34 (20A).
  • BJB Fuse:
    • F27 (45A)
  • Circuit.
  • Heated back window switch.
  • SEC/timer module.
  • Rear window defrost relay.
  • GO to Pinpoint Test D .
  • The back window defrost will not shut off automatically
  • SEC/timer module.
  • Circuit.
  • Rear window defrost relay.
  • GO to Pinpoint Test E .

Jan 28, 2009 | 1999 Mercury Villager

Not finding what you are looking for?
1994 Toyota Camry Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...