Question about Chrysler Pacifica
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: bleeding power steering pump
The system bleeds its self as it runs, the pump will eventually stop wining once the air is out of the lines.Let the van idle and turn the steering wheel full lock in each direction a couple time to move the fluid through out the system letting out any air.
Posted on Nov 05, 2008
IF YOU OPEN THE HOOD ON THE RIGHT SIDE THERE IS A SQUAR BOX THAT SITS RIGHT NEXT TO THE BATTERY OPEN THAT BOX AND LOOK UNDER THE PART YOU OPEN AND IT HAS A DIAGRAM AND THE NUMBER WHERE IT GOES
Posted on Dec 29, 2008
Each of the plugs has it's own coil so they are under the swaure coil, you won't see traditional spark plug wires, look for sets of two wires headed for ~ 2.5 inch square block, three plugs can be seen in front of the large plastic air plenum, the uther three are underneath the plenum. Takes a real handy DIY person to do this as there are plenty of things to remove before the plenum comes off. Take good notes on how you remove things, I missed a lever that is part of the idle system and throught I messed things up bac\d, but when I located the correct place to attach the lever it was fine. Also be careful and not break a connector to the individual coils. I did, but was able to glue it together...
Posted on Apr 09, 2009
is it a DOHC V6 if so ur in luck their is probably a plastic cover on the engine remove that to gain access to the valve cover on the front bank. The spark plugs should be right in the center of the valve cover you'll need to get a 6" or so extension to reach down into the cylinder head to remove them the same steps for the spark plugs on the back bank (closest to the fire wall).
Posted on Oct 13, 2009
Normal bleeding procedures should work. there is nothing special about the Bosch twin calipers on the front of the Pacifica.
If you have a friend try the following.
1. with engine running have your friend pump the brakes several times and then push down on the brake pedal with about 20 lbs and hold it down. Now open the bleeder screw on one of the front calipers.
2 The pedal should drop and your friend needs to keep pushing on it and do not let up.
3. Now close the bleeder screw/
4. now have your fiend take his/her foot off the brake pedal.
5. wait 15-30 seconds and repeat. Do the same thing for the other side.
6. Check the fluid level in the resevoir every couple of strokes to keep it at least 2/3 full.
that should do.it.
Be sure to open the bleeder screw at least a full turn because you want a lot of flow rate.
Posted on Dec 25, 2010
Tips for a great answer:
Mar 30, 2017 | 2004 Chrysler Pacifica
Jun 05, 2014 | 2007 Chrysler Pacifica FWD New Cars
Oct 20, 2012 | 1998 Chrysler Concorde
Oct 26, 2011 | 2004 Chrysler Pacifica
Oct 16, 2011 | 2005 Chrysler Pacifica
Jan 29, 2011 | 2005 Honda Accord
Nov 18, 2010 | 2005 Chrysler Pacifica
166 people viewed this question
Usually answered in minutes!