Question about Cars & Trucks

Open Question

Free wiring diagrams

I have replaced most sensors guy said he put new distributor in it a 4.3 v6 95 blazer engine turns over but wont start notsure its correct i had it started by squirting gas in throttle air plennium at front of engine fuel pumpnot sre if they have icm an coil wired up right they changed the little plugg ins out an m not sure they have it ritenew fuel pump an pressure regulator an it has 62 psi fuel pressure when turn key on turn key off an pressure drops to 58 then gradually falls down slowly

Posted by on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1999 Yukon cold start problems.

1999 Yukon Start Issue - I have replaced the octopuse, battery, fuel filter, fuel pump, still having problems starting in cold weather, sometimes after a heavy rain.

Any suggestions?

Thanks

Posted on Dec 08, 2008

Ad
  • 37 Answers

SOURCE: 95 blazer fuel prob's.

It drops when it is turned off through the return the pump might be getting weak If you keep using the starting fluid you will blow the intake off of it or it will get hooked on it and won't start without it.

Posted on Jan 07, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 blazer 4.3l crank but no spark condition


use your key fob to start it,your security is on

Apr 22, 2017 | 1998 Chevrolet Blazer

2 Answers

It turns but it wont start,it has gas and power


Pull off the coil ignition cable at the distributor and check for spark coming out of coil when cranking engine over. Use a heavy rag or glove to hold the wire 1/4 inch from a metal ground. Should see a strong blue spark when cranking to verify ignition is good. If no spark, check for battery voltage to coil on the coil primary. If you have current to the coil, suspect a bad coil, ignition module, crank position sensor, or cam position sensor, or pcm. The coil, ignition module, and sensors can be tested before replacing.

Jan 29, 2013 | Cars & Trucks

1 Answer

Replaced computer in 2002 sentra,car wont start now


I assume the car was running before you replaced the computer. If you still have the old computer try it on. This will help you determine if the problem isn't in the new computer. If you can't test as above, check for power to the distributor. If no power then check the circuit from the computer to the distributor (first the fuses that are marked "Engine Control" then the wires at the connector on both ends). If the circuit is OK then the computer is probably faulty.
If you get power then check the coil pack or the distributor. I don't have the wiring diagram for the 2002 Sentra but usually power to the pump is controlled by the distributor.Please feel free to let me know if I can help you more.

Oct 18, 2011 | 2002 Nissan Sentra

1 Answer

Lately, whenever it rains, my 1998 chevy blazer wont start/won't run. the engine turns over, but it won't run. after 2 or 3 days it will fire up like nothing was wrong with it to begin with. any...


Whenever I had this problem, it was always cured with a new set of GOOD spark plug wires. Not generic set off the parts store shelf. Get some moisture removal spray and put it on both ends, the coil and the plug, before putting the wires on. Do one wire at a time so you do not get them mixed up. I do not think you have a distributor or a cap. If you do replace it also as it is over 20 years old.

Jun 17, 2011 | 1998 Chevrolet Blazer

2 Answers

I need the firing order for a 93 chevy blazer distributor.where is number 1?


Firing order for a 4.3 liter v6 1-6-5-4-3-2

#1 piston is the first spark plug drivers side front of engine.
Passenger side cylinders are 2 4 6
Drivers side cylinders are 1 3 5
Distributor rotates clockwise and the starting spot is marked with a 1 on the top of the distributor cap.
Make sure you note the position of the 1 on the old cap before you take it off so you don't rotate the new one 180 out

Jun 09, 2010 | 1993 Chevrolet S-10 Blazer

3 Answers

Replacing spark plug wires on a 1981 cadilac eldarado. I m confuse where the wires go. i need diagram for replacing the wires. Its the 8-6-4 engine


Not sure what you mean by 8-6-4 but this will help you. Pick the correct one for your application:


53d6dfc.gif
GM (Cadillac) 250 (4.1L) V8 .GM (Cadillac) 273 (4.5L) V8 .GM (Oldsmobile) 307 (5.0L) V8 .GM (Oldsmobile) 350 (5.7L) V8 w/EFI.Engine firing order: 1-8-4-3-6-5-7-2 .Distributor rotation: counterclockwise


1cfe6bc.gif
GM (Cadillac) 368, 425, 472, 500 V8.Engine firing order: 1-5-6-3-4-2-7-8.Distributor rotation: clockwise



3f0dea3.gif
GM (Cadillac) 429 V8.Engine firing order: 1-8-7-2-6-5-4-3.Distributor rotation: clockwise

Oct 06, 2009 | 1980 Cadillac Eldorado

1 Answer

Car wont start, turns over fine but theres no feed of gas to carb


take your distributor cap off and check the ignition module for loose wires or even a ground strap thats connected to the engine to the body , you can take the module to autozone and have it checked for free, it might have a crank position sensor thats going wacky

Aug 19, 2009 | 1987 Chevrolet Blazer

1 Answer

Put distributor cap on blazer fire came out of engine


If when you changed the distributor cap you misplaced the wires in the incorrect order you could have caused a misfire. When looking at the cap the correct firing order for a 4.3 liter is 165432 going clockwise. Also if you loosened the distributor hold down bolt and turned the distributor even slightly you could cause a misfire.

Apr 20, 2009 | 1991 Chevrolet S-10 Blazer

2 Answers

1993 blazer 4x4


I assume you have the 4.3 vortec. If so, check to make sure you have the spark plug wires in the right position on the distributor cap. firing order is 1,2,3,4,5,6. right side of engine is 1 front 3 middle and 5 rear. Left side of engine is 2 front, 4 middle, and 6 rear. On the distributor cap # 1 should be toward front of engine and work counter clockwise from there. Hope this is helpful. KS

Mar 16, 2009 | 1993 Chevrolet S-10 Blazer

2 Answers

No start, no spark, no signal to the coil


there is a fuse that works the battery try checking if it is still good

Mar 03, 2009 | 1996 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14398 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...