Question about 1989 Chevrolet Beretta

3 Answers

Dont know my beretta will start and run but if u hit the gas it will spit and spudder u cant rev it higher than 3 thousand rpm's just changed the plugs and wires and got the coil's and modgel tested and thay are both good

Posted by on

Ad

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Run fuel injector cleaner through the engine.  If the injectors are clogged the car will hardly run.  Trust me I know, I had a beretta that had the same problem.  I took it to the dealership and when the machanic took it out for a test drive to see what the problem was he couldn't keep the car running without holding the gas to the floor.  Whe I asked him what he though the problem was he immediatly said the fuel injectors were clogged.  It comes from running cheap gas.  I was surprised to read in the owners manual that no less than 92 octan rated gas should be ran in the car.  He cleaned the injectors and the car ran fine. 

Posted on Sep 28, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Runs but spits and sputtersaround 2000 rpms and then stalls

Posted on Aug 16, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 81 Answers

Check your fuel filter and make sure it not plugged up, make sure you reinstall exactly as it came off.
good luck

Posted on May 20, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Spit and spudder


Clean the idle speed control valve in the upper intake near the throttle valve with CRC brand throttle cleaner.

Jan 10, 2014 | 1996 Toyota Camry

1 Answer

Grand am problems


is the ABS light on? Check the crank sensor wiring down the back of the block, it may have melted on the exhaust. It runs in between the firewall and the engine, 2 wires.

Dec 16, 2013 | Cars & Trucks

1 Answer

99 audi a4 quattro manual it starts up spudders out and dies but if i give it throttle above 1100 rpm it revs seemingly normal


compression test
check for internal crack in turbo
replace plugs
check for blown head gasket

Mar 22, 2017 | 1999 Audi A4

1 Answer

I have a 96 Nissan XE and it starts sputtering and spitting when it hits 2500 RPM. My Guy said he cant fix it because he doesnt have the right port plug for the obd 2.


@jgamble112, sinse it is a specific rpm, 2500, which is where the rev limiter is usually set to stop the engine when reving up, it sounds like the engine control module, or computer as it is commonly called, this is what controls the rev limitermine had smae problem, same rpm, and in gear too, its only supposed to work when in nuetral, but sometimes the computer doesnt recognize the vehicle has been shifted, hope this helps

Aug 08, 2011 | 1996 Nissan Pickup

1 Answer

Surging RPM Hot restart on Chevy Beretta


Change the coolant sensor,and try lucas fuel treatment to clean the injectors.

Jun 08, 2010 | 1996 Chevrolet Beretta

1 Answer

Looses power why driving has trouble starting you can be going down the highway then it starts to spit and spudder all the sudden pull off and shut it off for about 15 minutes or so try to fire it up it...


A good pump and a bad one look identical; problem with the bad one is that after running for a while, it gets hat, begins to bind and then stops. Once cooled down, it will repeat the process. Even when pressure testing, it may "seem" fine but not be., 'till it gets bad enough to show up during testing. Your crank position sensor can act the same way, so can an ignition coil. (internal expansion during heating shows internal shorting.) When in "no start" check for spark. This should separate fuel problem from ignition related stuff. Then, go from there. Do real testing...guessing and replacing parts can cost you a fortune.

Jul 29, 2009 | 1996 Jeep Grand Cherokee

1 Answer

Engine starts to cut out at highter RPM's, Mileage 115,000


Change the filter as suggested and let me know if that takes care of it, also you should run a self test of the powertrain control module to see if it has a trouble codes, kragen and other stores like kragen do it for free.

Oct 18, 2008 | 1994 Pontiac Grand Am

4 Answers

Idles fast


intake leak or a bad idle air controler

Oct 03, 2008 | 1989 Chevrolet Beretta

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

224 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...