Question about 2006 Ford Territory 4.0

Open Question

How do i remove feul pump on ford territory 2005 7 seater

How do I remove feul pump on ford territoty 2005 7 seater

Posted by Anonymous on


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 22326 Answers


its in the fuel tank

Posted on Nov 18, 2008

  • 22326 Answers

SOURCE: 2000 ford focus

factory immobiliser cut in ,,dealer only sorry about being the harbringer of bad news,hope your preparing to lay the golden egg minium charge in spain is 180€ but iam hearing reports for renaults of 220 upwards and one of nearly 400 today

Posted on Nov 22, 2008

  • 8 Answers

SOURCE: 2000 ford focus new feul

Try the crankshaft position sensor. Sometimes they get covered in clutch dust and the sensor cannot determine No1 cyl. and then it will refuse to start. Sometimes they go faulty as well.

Posted on Nov 23, 2008

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Removal of the rear flexible brake hose on a ford territory 2005 looks like a circlip retainer

remove the steel line to the flexible hose
pull the retainer clip out pull the hose out of the bracket and undo it from the other end

Oct 19, 2017 | Ford Cars & Trucks

1 Answer

2005 ford territory neww battery wont start. No crank sound just click


"Territory" means non-USA market?
(AU, NZ)

(Sorry I'm in the San Francisco, Cali area
(we haven't even started your yesterday)).

The click is the sound of the solenoid (big click?)

located on the starter... you can tell it is the main connection after the battery post on the positive side... If cleaning does not
work... checking the fluid levels & charging the battery (yes, I got the new part) ... then consider getting into testing THAT SOLENOID... (by shorting across those big terminals on the starter... If the vehicle is in gear EXPECT it to TRY to DRIVE THROUGH where-ever it is pointed...!!

aaand ...
don't expect the terminals or shorting device look as pretty as they did before they were ABUSED.

the STARTER MOTOR is most likely at fault
(but again... check that GROUND first (at the starter).

The cheapest and best start is to inspect & clean the battery terminals (both ends of each). Always remove the GROUND side connection FIRST... and always put that GROUND terminal together LAST.

THE reason is purely SAFETY... If you are using a regular wrench (rather than a FULLY INSULATED BATTERY WRENCH) every possible contact with the POSITIVE side of the battery has EXPLOSIVE consequences.

Gloves & eyewear (goggles) are always recommended.

You should always have baking soda & PLENTY of fresh water IMMEDIATELY available in case you become contaminated.

Ideally using anti oxidant battery washers BEFORE final connection of those battery terminals.

Coleman 989 Battery Washers at EssenntialHardware com

Falcon Ute Van Starter Motor 6 cyl XD XE XF XG XH AU BA Ford XA XB XC XY...

Nov 26, 2016 | Ford Territory Cars & Trucks

1 Answer

How do I change the six ignition coils on a ford territory 2005?

Remove the bolt holding them, remove the electrical plug. Most will pull out, some you have to twist to get out. Some times you have to remove other parts to get them out. I only remember one time I had to pull the fuel rail to get one out. It wasn't your type though.

Sep 06, 2015 | Ford Cars & Trucks

1 Answer

2005 territory engine keeps stalling


Feb 10, 2015 | Ford Territory Cars & Trucks

1 Answer

Ford territory back seat console can it be removed

Ok it had to be installed right? I am not up to date with the ford territory's but most installs are basically the same. Look inside of console on the bottom will most likely be small squares of plastic with a notch on one side. Using a small regular screwdriver pry it and all others up to reveal the bolt. remove all and it should come out! I seriously don't think that ford would mount it from underneath the car. But anything is possible after 2005! Things got harder to work on! good luck! And let me know how it goes.

Jun 29, 2014 | 2006 Ford Explorer

1 Answer

Is there a reset for the feul pump on a 05 dodge durango

Not that I know of.
Only Ford products have an inertia switch.
Is the pump getting voltage and ground ?
Did you check the fuel pump relay ?

Aug 05, 2012 | 2005 Dodge Durango

1 Answer

2000 ford focus new feul pump new feul filter new feul pump relay car still want start

Try the crankshaft position sensor. Sometimes they get covered in clutch dust and the sensor cannot determine No1 cyl. and then it will refuse to start. Sometimes they go faulty as well.

Nov 22, 2008 | 2005 Ford Focus

1 Answer


its in the fuel tank

Oct 30, 2008 | 2005 Ford Freestar

Not finding what you are looking for?
2006 Ford Territory 4.0 Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5681 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides