Question about Honda CR-V

Open Question

How to find fuse for hazard lights on 2006 honda crv

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 79 Answers

SOURCE: honda crv engine light

I would go to your local Honda dealership and tell them the engine light came on. They will hook it up to a special computer and they will be able to tell you why the engine light came on and what's wrong with the car. Not sure what the cost will be to get it checked out. If you don't have the money for that right now.

Posted on Jan 23, 2009

philschneide
  • 448 Answers

SOURCE: 2006 Honda crv, vsa, abs, and triangle light are

You are talking about the VSA activation indicator (triangle with exclamation point in the middle):
This indicator has three functions:

It comes on as a reminder that you have turned off the vehicle stability assist (VSA) system.

It flashes when VSA is active.

It comes on along with the VSA system indicator (the rectangle with VSA in it) if there is a problem with the VSA system.

This indicator normally comes on for a few seconds when you turn the ignition switch to the ON (II) position, and when the ignition switch is turned to the START (III) position.

Hope this helps you understand the problem.

Posted on Dec 09, 2009

techbuster
  • 5081 Answers

SOURCE: 2006 CRV - VSA light and triangle are lit? What

The vsa and check engine light cam on because their is a fault in the system that needs to be looked at.To be on the safe side i would check the oil and transmission fluid .
Try doing a reset. Disconnect battery for a minute, this will clear the code ( light ). If the light comes back then take it auto zone or dealer to have the code read.
You can have the codes read for free at your local parts store like auto zone.
Have them scan it and let me know what the codes are.


Posted on Dec 18, 2009

SOURCE: WHERE IS HONDA CRV TAIL LAMP FUSE

hi,
i have provided the picture showing the location of tail lamp fuse for Honda. I have marked it too for your reference. Please rate my solution as helpful.Have a nice day!7c6a615.jpg

Posted on Mar 05, 2010

johnjohn2
  • 5763 Answers

SOURCE: replacing cruise control bulb on honda crv 2006

JUST POP SWITCH OUT AND BULB GOES INTO SWITCH USE SMALL SCREW DRIVER TO REMOVE YOU WILL HAVE TO TWIST IT COUNTERCLOCKWISE TO REMOVE, TWIST CLOCKWISE TO INSTALL.

Posted on Apr 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2000 honda crv turn signals / hazards don't work replaced flasher relay still nothing


Hello, Check your fuse panels for a blown fuses. If that is not the problem, check the bulbs; the only other source would be in the switch itself the wiring harness and connectors.
Most likely the fault is in the switch and it has to be replaced

Feb 13, 2017 | Honda Cars & Trucks

1 Answer

I have a 2006 Honda CRV and the reverse lights don't work. Can you advise where the fuse is ?


Have a look at this page.

http://www.carcarekiosk.com/video/2006_Honda_CR-V_SE_2.4L_4_Cyl./fuse_interior/replace

Feb 19, 2015 | Honda Cars & Trucks

1 Answer

All electric windows not working on my 2006 honda crv


not herd of them all getting the same fault at same time but it could be the master control switch or the tamper/control unit would think it would be the switch.

Jan 12, 2014 | 2006 Chevrolet Trailblazer

1 Answer

My blinker lights won't work on my 2006 Honda Crv but my hazards do. Where can I find the relay for the blinkers?


it is the same relay. You can hear it click when you turn on hazards. Just listen for the sound and you will locate it.

Nov 01, 2013 | Honda CR-V Cars & Trucks

1 Answer

Should my hazard light switch flash when my hazard light are on my crv is 2004


If it does, then yes, it's supposed to. If it doesn't, as long as the hazard lights flash like they're supposed to, then all is good. Most hazard light switches don't flash. Some do. The likelihood of just that little bulb in the switch not working is almost zero.

Aug 14, 2013 | Honda CRV Cars & Trucks

1 Answer

Honda crv 2003 brake light fuse


For a 2003 Honda CRV, disconnect the horn fuse (#7), located in the under hood fuse box. This will also kill the rear lights. My underhood fuse box did not match glvenu's pic above, didn't have the 2 fuses circled together. The #7 fuse in my CR-V is located below the single fuse circled in the pic above.

Jun 28, 2012 | 2003 Honda CR-V

2 Answers

2007 tail light fuse location honda crv


I had this problem with my 2007 Honda CRV -- all the lights worked EXCEPT the tail/running lights and the license plate light. The other tail lights worked -- brake, reverse, indicators, and hazards. Front headlights also worked, but when the headlights went on the back tail lights did not (not to safe for driving at night!!)
The fuse was #15 in the interior fuse box (under the dash driver side) with the label "small exterior lights" ( also check fuse #19 labeled "small lights main"). The cause of my problem, I believe, is a bad or lose wire in my license plate light.

Jan 16, 2012 | Honda Civic Cars & Trucks

2 Answers

Honda CRV 2006 front accessory outlet not working. Fuse replaced and still not working.


have you got power to the outlet plug.may have a faulty plug or broken wire to plug

Jan 01, 2010 | 2006 Honda CR-V

1 Answer

Instrument lights don't come on


Should be the interior panal. Look in owners manual for dome/inst.

Nov 28, 2009 | 2006 Honda CR-V

1 Answer

2006 Honda CRV Signal/Hazzard Lights not working


How did you check the flasher relay? I only ask because it is a circuit board. But anyways if you feel confident that its fine then I've seen the multi-function switches fail. IM talking about the the lever on the steering column, behind the steering wheel. If you probe the plugs for signal/hazard lamps and you have ground but no power then I would test the multi-function switch.

May 14, 2009 | 2006 Honda CR-V

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...