Question about Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
For the sliding doors you need to clean the contacts, there are 6 or 8 on both sides, just wipe them clean as they are probably covered in oil/grease/grime.
Posted on Feb 14, 2009
I went to bulldogsecurity.com and looked up the wiring diagram for this vehcle. However, prior to checking this part, I would check to see if you have a blown fuse. It doesn't hurt and only takes a few minutes. There should be a fuse for that either somewhere on the side of the dash or near the brake pedal area. If not it may be under the hood, but it should be inside the vehicle. You may have multiple fuse boxes. If it has (2) sliding doors it will have a wire for the auto doors in each kick panel (under the plastic trim/molding) when you open the door and look down you will see all of the trim/molding it should snap out or may be held in place with a screw or (2). Once you remove that you should see the wires. It says for the left side it is either light blue or black and the right side is definitely light blue. Trace this wire until you find out where it ends (the motor or switch to control the auto doors) Then test the switch/motor to see if it is bad.
Posted on Mar 02, 2009
this can be stuck contacts on the door. better to check the sliding contact point for any dirt debris on the slide or it may need some lubricant for easily sliding.
Posted on Apr 18, 2009
the sliding doors on montana assuming there power have a electrical harness on the bottom track that break and jam the doors but unlikly both have this problem do the doors lock @ unlock if not check switch at drivers door
Posted on May 27, 2009
Verify the wiring harness which passes under plastic step & carpet at front passenger side. This wiring harness goes from the firewall to the pillar on the right side and some have crimped connectors in them to act as junction between two or more wires (ususlly the 12volt feed), which deteriorate with time, especially with Salt & Water. Then the electric sliding door stops working and even driver the electric seat can loose power.
Posted on Jun 07, 2009
Tips for a great answer:
Mar 25, 2013 | 2000 Pontiac Montana
Aug 02, 2009 | 1999 Pontiac Montana
Jul 29, 2009 | 2006 Pontiac Montana SV6
May 27, 2009 | 2003 Pontiac Montana
May 17, 2009 | 1999 Pontiac Montana
Feb 12, 2009 | 2006 Pontiac Montana SV6
Jan 26, 2009 | 1999 Pontiac Montana
27 people viewed this question
Usually answered in minutes!