Question about Cars & Trucks

Open Question

Fuel pump replacement

How to remove and replace fuel pump of 2008 Ford super-duty 4x4 diesel truck

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
chiquititas
  • 1010 Answers

SOURCE: abs light on

I'm a Ford service adviser. There are many reasons for the
abs warning indicator to come on. The usual cause is from a
faulty speed sensor. Either a wheel speed sensor or the
differential speed sensor. I don't think the light is related to your vandalism. You might want to take the truck to an auto parts store and have them read the codes for you. Most auto parts stores will do this for free.
Good Luck

Posted on Jun 23, 2008

Ad
  • 3 Answers

SOURCE: 2000 ford f250 super duty 4x4 7.3L diesel oil leak

The HPOP (high pressure oil pump) is right under the filter housing. There are 2 lines that distribute the oil to the cylinder heads. The o-rings on those fittings go out. Kit is available from Ford or International. You will need a special wrench to get to the fittings though.

Posted on Jun 23, 2008

  • 11 Answers

SOURCE: how to replace outside mirrors on a 2002 ford f-250 super duty

you need to remove door trim panel there are (2) 7mm screws that hold panel on .. 1 is behind the lower red light lens and the other is behind switch panel for the power window switch . remove both screws and remove small black panel above door trim by pulling strait off .(now there are (4) 11mm nuts the hold mirror on 2 are behind the small rubber plugs in front of door that you can see with panel on and the other 2 are under panel that you can see after panel is removed . the wiring need to be disconneced you may have to remove speaker for acess to feed new wiring down into the door good luck

Posted on Mar 11, 2009

  • 1 Answer

SOURCE: fuel leaking from ford f250 1999 super duty v8, 7,3 truck

check the high pressure return line behind the fuel filter the clamp securing it will vibrate and rub a hole in the line. i was quoted a couple of hundred to replace the line, i put a small piece of fuel line over the hole and secured it with a worm gear clamp. no leaks in over 2 years

Posted on May 05, 2009

DIESELMUDDER
  • 2760 Answers

SOURCE: replace fuel pump on 03 Ford F350 diesel

simple : obtain replacement pump from parts provider (no used stuff)

Now help me out here: thats the year they were bolted to the pass side front of engine
and not inside the tank right? (better go look to see for sure)

using a tube wrench unscrew the fuel lines (i use large wire nuts to temp block off fuel leakage)

with a 12 mm wrench undo the two side bolts holding the pump to block

wiggle pump it should come straight off

clean mounting place on block with solvent let dry

silicone back (or use gasket that comes with pump ) of pump

apply pump to block (depending on where crank stopped you may have some tension on arm you will have to overcome to get flange to meet block )

use locktite (blue)or simmiliar thread lock on bolts retighten firmly but not hang up the dog tight

use light grease or vasolene on tube connections don't try to tighten dry

Now the fun part your diesel now has air in the fuel system

there are two ways to remove this ( hard and harder)
your choice here are both methods

loosten the fuel supply line for #8 injector ( I did not say remove) 1 full turn ought to be enough

crank engine 30 seconds only
wait 5 minutes for starter to cool down
crank engine 30 sec again
did it start but runs rough while it's still running tighten #8 injector (caution fuel under high pressure)
engine smooth out good your lucky
engine did not start yet
wait 5 minutes
crank engine 30 sec again
start yet
if so tighten #8 injector up

Now here's something I've done to my diesel to make this much less a hasstle

trace fuel line as it comes up from pump
obtain a small low pressure electric fuel pump and a two short pieces of fuel line
and a few clamps

use tube cutter and cut fuel line just before it bends to go in filter
deburr edges
slide tube and clamps over pipe (both sides)
insert pump observe flow arrrow towards filter

the wires of pump can be stretched over to #1 battery terminals

now any time you change a filter or open your fuel system for any reason
all you need do is connect pump to battery
open sharader valve on top of filter for a few min
and start truck as normal
then disconnect wires and stow away for another day

Posted on Jul 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to repair 2008 ford F-350 diesel showing code P2033


code p2033 refers to exhaust gas temperature (EGT) sensor 2 bank 1 circuit high === causes wiring short to ground --EGT sensor . check the wiring for shorted / broken wires and replace the sensor . If there is no problem with the sensor or the new sensor fails early I would be checking the fuel settings on the pump ( pump timing and cc ratings ) as a hot diesel exhaust indicates over fuelling or pump timing too far advanced.

Jul 22, 2014 | 2008 Ford F-350 Super Duty

1 Answer

2008 ford super duty 6.4 diesel wont crack turns over and has diesel and oil makes no sense just drove it home and parked it then 24 hours later it wont crank up


check fuel pressure, check filters , bad fuel or water in fuel is a common problem with diesel fuel.start simple, turn key to on ,,can u hear fuel pump. remove filter check condition see if water in filter.they have 2 or more filters. prime pump per manual try again.

Mar 21, 2011 | Ford F-350 Cars & Trucks

1 Answer

MI have a 2004 f250 super duty diesel 4x4 lariat and i recently put all new batterys on it and fill it up with diesel, now it trys to start but its acting like its not getting any fuel, someone told me it...


Take the small fuel filter cap loose under the hood and have somebody hit the key to on. Fuel should come gushing out... If not check filter on frame rail. ....then pump

Jan 12, 2011 | 2006 Ford F-250 Super Duty

2 Answers

I have a 2002 Ford F-250 Diesel 7.3 litre Super Duty truck. It is leaking oil from an area beneath the fuel filter. What part would I need to repair this leak?


there are 2 high pressure lines that attach to the high pressure pump near the front of the engine left side. the o rings leak. I would get them from the dealer, or a shop that does a lot of Diesel work. Its not a easy job.

Aug 31, 2010 | 2002 Ford F250 Super Duty SuperCab

1 Answer

Replaced fuel lines on my 2000 F-250 super-duty 7.3 diesel now will not fire. primed fuel filter bowl several times no luck


YOU HAVE AIR IN THE SUCTION LINE.OR YOUR ELECTRIC FUEL PUMP FUSE IS BLOWED OR PUMP IS FAULTY IF YOU CANT GET NO FUEL TO FLOW.

May 25, 2010 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

WATER IN THE FUEL TANK


The drain is on the frame mounted fuel pump 6mm allen plug
Don't strip it!

Dec 26, 2008 | 2008 Ford F 250 Super Duty 4WD

1 Answer

Hi pressure fuel pump


Unfortunatly the injectors and the pump are computer matched when the engine is assembled so YES 10,000 sounds high but right for a dealer price.
I would be VERY careful who you go to for this job the high pressure pump has to put out nearly 15,000 psi to run the injectors. With that kind of pressure if anything is done wrong it can be major

Nov 17, 2008 | 2008 Ford F 250 Super Duty 4WD

2 Answers

2002 f350 wont start


i had to replace my oil pressure regulator sensor it contols the oil pressure required to have the injectors open and spit fuel, if you replaced it and still no start replace the the cam position sensor

Jul 20, 2008 | 2002 Ford F350 Super Duty DRW Reg. Cab

2 Answers

2003 Ford F-250 Super Duty 6.0 liter 4x4 diesel steering 71000 miles


check out the steering stabilizer(it's the shock on the steering linkage) for wear. If it shows signs of leakage replace it.

Jun 29, 2008 | 2007 Ford F-250 Super Duty Lariat

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...