Question about Cars & Trucks

Open Question

Vsc and traction control lights on 2007 camry

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 918 Answers

SOURCE: My 2007 Toyota Tundra 4.7l shows VSC OFF lights

check air filter for dirty , how many miles or kms have your car? , maybe need to replace spark plugs, try to reset the ecu for a momentany malfunction, remove the negative battery terminal few minutes and reconnect,start engine and drive, check if lights goes off , please write me

Posted on Jul 05, 2009

  • 578 Answers

SOURCE: my check engine light is on and traction control

Toyota is known for sensor problems (Especially tire pressure and traction control).
Suggest that you ask your local AutoZone to run a free ODB check on your car and define the specific sensor messages. That may get you in the right direction... or tell you that the chip that collects the data is smoke..... it can happen with excessive heat or voltage spikes.... Good Luck and keep us informed....

Posted on Oct 10, 2009

  • 1586 Answers

SOURCE: Toyota Avalon 2006, I ahve a VSC indicator light

VSC is Vehicle Skid Control. The system is usually on, but when you turn it off (on my mother's 01 Avalon, it's on the knee bolster, below and to the right of the steering column), the indicator comes on in the cluster to let you know it's turned off - it's just a reminder to you that you don't have that safety net activated. The way the car is set up, even if you turn it off, when you shut down the engine and then restart it later, the system is rearmed automatically.

What I'm thinking is, since you've obviously had the engine on and off and the VSC OFF and TC OFF warnings are still illuminated, you probably have a problem with either an ABS sensor, a yaw sensor, or something related to those, as those systems rely on a bunch of sensors to work. If they have failed, it should illuminate the check-engine light. Stop at Auto Zone or Advance Auto Parts and have them scan the car's computer (it's free). They'll give you a list of the fault codes that come up. If you post them up here, I can define them for you and help you solve the problem - just post them as a reply or follow-up on this posting.

Posted on Nov 08, 2009

Testimonial: "Thanks a bunch!! Big help and I will do what was suggested to solve the problem. Thanks again."

  • 1374 Answers

SOURCE: traction controll light and vsc light came on the

Have vehicle scanned for codes and do the repairs that the codes address.

Posted on May 26, 2010

  • 7353 Answers


Have the ABS system scanned for codes. Verify the brake fluid level.

Posted on Nov 27, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2009 camry VSC & Traction Control Light & Engine Light are on how to turn off

Take it to the dealer , if you have to ask you have no business messing with it .

Feb 24, 2015 | 2009 Toyota Camry

1 Answer

What is a vsc in a toyota aurion?

VSC Is ..Vehicle Stability Control..It is a control system for traction loss,scidding,.If one tire loses traction it will light up..It shouldn't interfere with starting...Make sure all CV Axles for drivetrain isn't damaged...?..Did this happen all of a sudden..?..You can wear safety glasses and disconnect negative battery to erase the code and reset the computer..Reconnect and then try to start it..Be sure car is in park..!

Feb 20, 2015 | 2008 Toyota Camry

1 Answer

2007 tundra with 5.7v8 lack of acceleration "vsc off" light flashing traction control light on check engine light on

Your truck is in limp mode because your fuel mixture sensor is bad, I think that toyota has put this part back under warranty because of so many problems

Mar 03, 2013 | 2007 Toyota Tundra

1 Answer

Just got my oil changed and the day after my vsc lights come on- any connection?

Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module

Oct 22, 2012 | 2007 Toyota Camry

1 Answer

2007 toyota tundra 5.7L vsc off light blinking plus traction control light on and check engine light

Seeing as how you go to a dealer vs: a repair
shop,take it back to the dealer

What else can you do?

You can not resolve yourself without factory service
& diagnostic manuals,you could purchase them

Sep 18, 2012 | 2007 Toyota Tundra SR5

1 Answer

Will it hurt 2007 tundra to drive with the VSC off light on

no , it will not hurt it vsc=vehicle-stability-control its wont haver traction control so it will spin the tires easier when its wet/snow

Jul 29, 2012 | Cars & Trucks

1 Answer

2005 camry vsc light is on and traction control light on does not shift out of 1st gear

i'd check your tire pressure first if thats ok or at least equal on all four tires. usually vsc and tcs become active if the vehicles computer receives unequal input values from two or more wheel speed sensors. if one or two tires are low on pressure it can cause this to occur.

Jul 27, 2012 | 2005 Toyota Camry XLE

1 Answer

2007 tundra with 5.7v8 lack of acceleration "vsc off" light flashing traction control light on check engine light on

The key of your problem is to know what is the check engine light, there is several codes that send the computer to safe mode diminishing engine output, vsc and track off come with the check engine light.

If you need further help, I’m available over the phone at

Jan 06, 2011 | 2007 Toyota Tundra

1 Answer

I have a 2007 Toyota camry with push button start. I tried to turn the car on this morning and the radio and gps turned on but the car wouldn't start. The message display says check vsc. I checked my gas...

VSC stands for vehicle stability control. That has nothing to do with the gas cap.

Maybe, the starter or battery is weak or bad. Or, the starter to battery connection at the battery is bad.

Try to disconnect the battery, clean and wire brush the connections, and reinstall the connections to see if the car will start up after that.

Note, that batteries have an average life expectancy of 3 years, typically. I see that your car is 3 years old, so if it had the original battery, it's possible it needs to be tested at a battery retailer to see if it is alright.

Good luck on this repair.

Oct 31, 2010 | 2007 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15148 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides