Question about Mercury Grand Marquis

Open Question

Transmission wont shift into reverse

Why fuse 15 gets blowing off and My Grand Marquis won't go into reverse?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
leetamara
  • 702 Answers

SOURCE: Transmission wont shift into reverse

By the grayish color, fluid being thick, and metal shavings, the clutches are pretty much worn out. It's time to either rebuilding your transmission or just installing a good used one. The fluid normally should be a reddish color. The gray is from the actual clutch material going away.

Posted on Aug 17, 2008

Ad
wwjdcgh
  • 114 Answers

SOURCE: automatic 3 speed transmission wont shift out of first gear

that is what they consider safe mode for those transmissions, they are a very smart electronic transmission it does that so you dont ruin the trans.
It has detected a problem and you must take it to a tech and have the codes pulled, could be as simple as a sensor or solenoid pack

Posted on Mar 09, 2009

GM Elec
  • 1000 Answers

SOURCE: fuse blows when shift in reverse

Am I correct, the turn signal fuse is blowing when you put the manual shifter in reverse?
Let me know.
Regards

Posted on Mar 26, 2009

polarcycle
  • 1392 Answers

SOURCE: ac or heat wont blow

Needs a blower motor resistor if the fan only blows on one speed. It is located underneath the firewall on the outside, near where the passenger exhaust system is. You need to take the passenger side cat converter off to get to it.

Posted on Jun 02, 2009

  • 2 Answers

SOURCE: I have a 1999 Grand Marquis that has blown (3) 15

seems like you might have a bare wire somewhere or a bad cluster

Posted on Dec 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Atv won,t shift into reverse


2004 Mercury Grand Marquis is not an ATV. Reverse on some ATV's has a knob on the handlebar attached to a cable that sometimes goes out of rig. (the cable prevents shifting down past neutral unless pulled)

Jan 16, 2014 | 2004 Mercury Grand Marquis

1 Answer

1998 grand Marquis blows out Fuse 13. This shuts off power to the instrument cluster and shutting the Headlights, only when the Variable Control iss in the "Auto" position. In the "On " position th


(1998 Gr. Marquis) I just found the culprit of my fuse #13 for the speedo, temp and votage gages. I had to remove the gear shifter cover which was not difficult also the metal brace across the bottom and the ignition key, but it was a tiny exposed burr in the overdrive shift button wire just at the end of the gear shift leaver. I elec. taped it up and now, no more blown fuse!

Feb 28, 2013 | 1998 Mercury Grand Marquis

1 Answer

2003 Mercury Grand Marquis w/ less than 100k miles-lost reverse; all other gears fine.


Usually what causes this is your reverse clutch is worn out in the transmission, or there is a bad valve

Dec 19, 2011 | 2003 Mercury Grand Marquis

1 Answer

2001 mercury grand marquis 15 amp fuse blows blows when put in drive fuse controls speed ometer fuel gauge oil pressure gauge amp gauge


Check under the dash at your Brake pedal interlock switch. It is timed with the gearshift Interlock and Ignition switch. This switch usually gets hit by feet and dislodged or broken. When you shift out of Park, the switch is toggling to a broken piece and shorting out.

The brake interlock switch is at the top half of the pedal lever. The other part of the Interlock uses a rod or cable in the steering column Ignition switch and mates with the shifting mechanism.

Jul 03, 2011 | 2001 Mercury Grand Marquis

1 Answer

Tranny goes on neutral sometimes and then back to normal


If you happened to become high centered on something, and tried shifting from drive to reverse, you may have bent your transmission linkage, which happened to me, and I got that fixed, but it cost me 280 dollars at a transmission shop...

Mar 27, 2009 | 1993 Mercury Grand Marquis

1 Answer

1994 grand marquis break switch fuse keeps blowing


This means you have a shortage somewhere in you wires. I suggest rewiring your wires.

Mar 14, 2009 | 1994 Mercury Grand Marquis

1 Answer

Tranny wont shift


Sounds like you need a rebuild on your transmission. The overdrive is going out in the transmission system.

Mar 05, 2009 | 1993 Chevrolet S-10

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

79186 Answers

fordexpert

Level 3 Expert

5681 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...