Question about Cars & Trucks
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
the most common causes are plug wire, plug, vacuum leak at intake, fuel injector failure and last no/low cylinder compressio.
Posted on May 22, 2009
If problem is only on startup and when idleing, then the problem is likely IAC system, also a vacuum leak will cause the same problem.
If problem is not only on startup and idle, but also when driving, then MAP sensor and EGR system must be checked.
Check also accelerator cable state and setting.
The first thing to do is pulling out the OBDII fault codes stored in the ECM. This is done connecting a code reader to the ECM diagnostic port. The job can be done for a small fee at any local garage, and it is done for free at AutoZone.
The codes will help locating the problem.
About possible faults:
Problem is stalling when idling and during startup, but engine idling fast all the time. Problem not starting at times it is due to the fact that the wrong mixture is being sprayed, this is probably causing flooding and misfire. Since the CEL is on, one of the codes returned is probably misfire.
Check IAC system. This is composed by a valve and a solenoid that check and control amount of extra air air when the engine is idling. The IAC valve is located on top of the throttle body.
Check the vacuum system and try cranking with gas tank cap off. Vacuum system is tested using an hand tool gauge onvacuum lines while spraying card cleaner on the hoses (or heating them with a torch). If there is a leak, pressure will go up. A big leak will also do hissing noise, and will often result in a lean code when doing an OBD code scanning.
This kind of symptoms can also be caused by weak wiring to MAP/MAF sensor (MAP in this engine).
If the car also drives very rough and is revving up and down in a weird way, check the EGR valve.
As first thing I would do a code scanning. This car is OBDII. The scan can be done for free at the nearest Autozone, or for a small fee at any garage.
If you get any OBDII code from the scan, report it here, so that we can individuate the possible reason for the problem.
If you repute my solution helpful, then please take some times to accept the solution. Providing good repair tips requires time and skills, and your feedback is important for us.
Posted on Oct 26, 2010
Tips for a great answer:
Jun 27, 2012 | 2001 Nissan Quest
Jun 04, 2011 | 2005 Nissan Quest
May 08, 2010 | 2002 Nissan Quest
Sep 20, 2009 | 1995 Nissan Quest
May 23, 2009 | 1994 Nissan Quest
Apr 25, 2009 | 2005 Nissan Quest
94 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: