Question about Chevrolet Equinox

1 Answer

I put a heatercore in a chevy equinox i put everything back together but the car start but the car dont not power two nothing im thinking it lost its programing i had the battey unplug for 4 days wha

How two reprogram everything

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Chevrolet Master
  • 42,671 Answers

This is possible so use a code reader to reset the CPU and see what happens.

Posted on Jan 02, 2014


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 840 Answers

SOURCE: reprogram computer of 2001 chevy venture

Call gm parts dept they can print a copy for you give them vin /Please rate my response thank you very much

Posted on Feb 02, 2009

  • 76109 Answers

SOURCE: 2006 chevy equinox keyless remote programming

from the service manual:
There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote. Please go to the nearest GM dealer for assistance

Posted on Mar 26, 2009

  • 206 Answers

SOURCE: car will not start-battery is fine

Try this Put your key in turn it on dont start wait 10 mins remove key wait 10 seconds repeat this a total of 3 times. Your theft light should go out. As long as the light is on your fuel system is disabled. If that dont work try a different key do the same thing. If that dont work a dealer needs to probably replace and reprogram your ignition switch and keys

Posted on Apr 11, 2009

  • 14036 Answers

SOURCE: Lost power on drivers side door 2007 chevy equinox

check fuse .if fuse good you got a bad ground.

Posted on May 16, 2009

  • 1486 Answers

SOURCE: did tune up on 2001 chevy blazer v6 4.3 ltr

change the mass air flow meter

Posted on Jul 18, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Reprogram ecm

did you disconnect the battery first? if not pull the negative with the key on.. car will die..then reconnect the negative with the key off.. then turn the key on wait 3-5 seconds for dash indicators to go out..all the factory presets should reset themselves..

Jan 01, 2014 | Chevrolet Equinox Cars & Trucks

1 Answer

I have a 96 audi a4 nd just replaced the heatercore after putting everything back together the car will not turn over nd i dont have the factory stereo to determine if the security has been tripped

ok.. you need to start all over again.. remove the + of the battery and check the connection you make.. double check it the reason is you forgot to plug some or loose or because you make a mistaken connection and the results is a blown fuse you need to check all of these..

Sep 22, 2013 | 2000 Audi A4

1 Answer

2008 Chevy Equinox would not start, turn key and nothing happened, replaced battery, ran just fine for a week. Tried to start one week later it acted like it wanted to start but wouldn't. Had ju

Usually a sign of something draining the battery.
The machine test probably showed the battery could hold a charge and the alternator was charging the battery.
You may need to have someone check for a power drain.
When the key switch is off, there may be a weak short to ground or a relay or component that is using power.

Jan 22, 2013 | 2008 Chevrolet Equinox

1 Answer

Hello!! i have an 84 chevy 1/2 ton that recent gave me problems so i took out the starter, alternator, and battery to have them all tested and they all passed except for the battery so i had it charged and...

Hi there
There could be a problem with the wiring that makes it start. Check the ignition and then check the wires on the starter and solenoid. Good luck

Apr 25, 2011 | Chevrolet 1500 Cars & Trucks

1 Answer

Durango wont start after replacing heatercore I

check ground wires on both sides of dash

Feb 12, 2011 | 1999 Dodge Durango

1 Answer

Nothing works,door locks, lights, no noise of any

security system failure will shut everything down
(IT THINKS IT IS BEENING STOLEN) an locked it self out

Mar 03, 2010 | 2005 Chevrolet Equinox

1 Answer

2006 Chevy Tahoe Z71

when you hooked the battery back up did the post and the cable spark when they came to contact? is it possible you hooked it up wrong?

Jan 11, 2009 | 2006 Chevrolet Tahoe

1 Answer

Won't start after it warms up.

Hi, could be the overload relay, this is the relay with a spade fuse in the top, could be under a black cove.r. Regards Tom (uk)

Nov 26, 2008 | 1994 Mercedes-Benz S-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides