Question about 2003 Ford Taurus

2 Answers

Occasionally my 2003 Taurus stalls

My 2003 ford Taurus on rare occasions will stall out. This usually occurs when I’ve been driving for awhile. It runs fine and then when I slow down it stalls and won’t restart until I let it sit for awhile. What could be causing this? Note I have replaced: spark plugs, spark plug wires, pcv valve, oil, oil filter, air filter and used fuel system cleaner since problem first occurred. The check engine light only comes on when car is running and door is open but when checked for codes nothing comes up. Also car does not have issue during my regular daily commute of 10 miles.

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,533 Answers

Check all of the vaccum lines and check for leak at the fuel injection unit and for leaks at the intake manifold also make sure the spark plugs are at the right gap and change the fuel filter and here is a couple of website to checout www.autozone.com and www.alldatadiy.com and i forgot one www.taurusclub.com and i hope i have been some help to you Michigan Man.

Posted on May 20, 2009

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Have your o2 sensors checked and have your emission system checked

Posted on May 20, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Taurus stalls as soon as I shift into drive


Try unplugging the mass air flow sensor on the air filter box. If it don't stall, change the sensor.

Sep 14, 2014 | 1995 Ford Taurus

2 Answers

Battery light flashes off and on/car stalls


check the condition and tension of the drive belt on the alternator. check for loose terminals . Check for moisture in the alternator and loose alternator terminals.

Jan 09, 2014 | 2000 Ford Taurus

1 Answer

95 Ford Taurus SHO 3.2 stalls randomly


On one of the occasions when it won't start back up, someone will need to figure out if you have lost spark to the plugs or fuel to the injectors to be able to troubleshoot the problem.

Sep 26, 2012 | 1995 Ford Taurus

1 Answer

2002 taurus 3.0L OHV stalls when hot have replaced IAC,camshaft position sensor,fuel pump and there are no codes on engine stall occurs most often when slowing and turning


If you have to wait to restart its usually a faulty coil or ignition module.
Someone would need to troubleshoot the ignition system when the engine fails to start to proceed. Could be a faulty relay too.

Sep 13, 2012 | 2002 Ford Taurus

1 Answer

1988 ford ranger 2.9 ltr engine stalls while driving , restarts in a few minutes usually


There are several possibilities, but based on how you described the symptoms I suggest a profile igniton pickup. On these systems the failure usually begins as dropping a cylinder occasionally,like a misfire,mostly during high underhood temperatures,will manifest into stalling and finally into a stall with no resart condition. Symptoms are most likely to occur in summer. The pickup is inside the distributor and the distributor must be disassembled to install it,the trickiest part being the removal and installation of the distributor drive gear. They are iron and easily broken. The simplest solution is another distributor. The ignition modules typically do not fail in this manner,but this is classic for the pickup coil. A code for loss of pip signal should be present, it is possible for a code to not be present,though very unlikely. Having worked on these systems for years this would be my first area of diagnosis.

Mar 13, 2012 | 1988 Ford Ranger

1 Answer

Rough idle and stalling 2003 ford taurus ses


mine did the same it was the map censor had new one installed about 125$

Dec 06, 2011 | 2003 Ford Taurus

1 Answer

Taurus 2003 idling problems


mcdevito75 here, Sounds like the idle speed motor, Ford is known for these idle speed motors going bad, in the later stages the car races like crazy. have your repair shop check this idle speed motor and change it.

Mar 14, 2009 | 2003 Ford Taurus

1 Answer

I need a list of the EGR/Trouble codes for a 1994 Ford SHO Taurus


Sounds like the catalytic converter has gone bad. What happens is you car as you drive will lose power, smell like rotten eggs and stall out. The reason is, the cat. is plugged up and cannot let the exhaust out of the tail pipe like it should. The exhaust is staying in the engine causing it to stall out and loose pwer.

Jun 11, 2008 | 1994 Ford Taurus

Not finding what you are looking for?
2003 Ford Taurus Logo

460 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...