Question about Cars & Trucks

1 Answer

How to install a new radiator on a 2005 gmc canyon perferrable where the transission cooler connects

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,103 Answers

Why did ya strip out the old ones? parts store has a prointout of these proceedures..get with them..

Posted on Jan 01, 2014

4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: I have a 2005 gmc canyon. Occassionally it will

it's probably the transmission and u might have to change ur fuel pump also

Posted on Jul 29, 2009

  • 1596 Answers

SOURCE: how do i change the o2 sensor on a 2005 gmc canyon

It is a 7/8 ths Sized Wrench needed for it and you Simplt Unplug it and remove it and replace it. If you see a Problem with this Method , there IS a SPECIAL SOCKET for 02 Sensors and Same Procedure just with A Socket / Extention / Ratchet.

Posted on Nov 09, 2009

Testimonial: "Thanks "

  • 75066 Answers

SOURCE: fan control only works on high

this is caused by a defective blower speed control resistor.

Posted on Dec 09, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

My reverse stop working in my gmc canyon

Put a code reader on it should tell you a code for powertrain

Nov 29, 2016 | 2005 GMC Canyon

1 Answer

Install a radiator in a 2005 canyon gmc

I could do this myself but you need instructions from the parts store or dealer service..

Jan 01, 2014 | Cars & Trucks

1 Answer

I just purchased a used 2005 Pathfinder and just learned of my potential problem with the radiator/transmission cooler assy.

You have no choice but to buy & install a new radiator

That is something you should have researched before
buying,not a big deal unless the trans cooler fails then
so fails the trans

Also I believe you have to drop the fuel tank & change the
sending unit as the fuel tank is deformed
That part may be avail under some govt mandate & free
but not the radiator

The cooler your asking about is inside the radiator, not the one
out front of condensor you can see

You don't by pass the radiator nowadays with all the computer
controls unless your a sharp & perceptive person who can know
the results of doing so.

There is lots to read on the internet & I have done a lot of it,
years ago considering buying a nissan frontier, I have yet to
decide about

I would buy an aftermarket big name radiator & install yourself
then see if you can get the sending unit for free frem a dealer
& intall that as well

When you get a timing chain noise- the updated Borg Warner ones
can out in Nov 2009 for the 2010's on the assy line

Jan 28, 2013 | 2005 Nissan Pathfinder LE

1 Answer

Where is the inside fuse box for my 2005 canyon 4door

All fuses and circuit breakers for a 2005 GMC Canyon are located in the engine compartment fuse block.

This subject is covered in the 2005 GMC Canyon Owner's Manual on pages 5-98 through 5-102.

If you do not have an Owner's Manual, you can download a free PDF version clicking on the following direct link:

2005 GMC Canyon Owner's Manual

Jan 04, 2012 | Cars & Trucks

2 Answers

Where is the thermostat on and 2005 canyon 4 cyclinder

Your thermostat is accessed through the dr side wheel well. Jack and support vehicle, and remove fasteners attaching inner wheel well to body, and remove.You will then have a good veiw of the radiator inlet hose. Either drain the cooling system through the radiator drain ****, or just pull off the hose and catch as much as possible.After you remove the inlet hose, the water outlet(or thermostat housing that the hose connects to on the engine) comes off next. Should be two or three bolts securing it. Install your new thermostat the with the spring facing the engine, and reverse removal procedure. Refill coolant through resevoir, run engine to operating temp(two to three minutes at 2000 to 2500 rpm). Allow to cool and top off coolant as needed.

Oct 21, 2011 | 2005 GMC Canyon

1 Answer

2005 GMC Canyon windows won't roll back up on driver and passenger side.

2005 gmc canyon.driver side window and lock does not work.have relpaced switch. the new switch now giving the same problem.

Jan 18, 2011 | 2005 GMC Canyon

1 Answer

Where is the horn located under the hood of a 2005 gmc canyon

Horn Replacement Removal Procedure

  1. Remove the grille. Refer to Grille Replacement .
  2. Disconnect the horn assembly electrical connector.
  3. Remove the bolt that retains the horn assembly to the radiator support.
  4. Remove the horn assembly from the body.
Installation Procedure

  1. Install the horn assembly to the radiator support.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the bolt that retains the horn assembly to the radiator support.
  4. Tighten
    Tighten the bolt to 10 N·m (88 lb in).
  5. Connect the horn assembly electrical connector.
  6. Install the grille. Refer to Grille Replacement .

Nov 07, 2009 | 2005 GMC Canyon

1 Answer

How do i progamm a remote for a gmc canyon.

There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote.

Oct 05, 2009 | 2005 GMC Canyon

1 Answer

Ignition coil - 2005 gmc canyon

Just above each spark plug.

May 18, 2008 | 2004 GMC Canyon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides